34 REV. 4
2. Any fault or anomaly must be reported to Fluimac srl within eight days.
3. Warranty repair will be carried
4. Warranty shall not be extended in case of repair or replacement.
5. Faulty parts must be forwarded to the Manufacturer who reserves the right to test them in this own
factory to identify the fault or any external reason that may have caused it. Should the parts be found not
faulty, the Manufacturer reserves the right to invoice the total cost of the parts that had been replaced
under this warranty.
Costs and transportation risks of faulty, repaired or replaced parts including custom charges will be borne
entirely by the client. Repair or replacement of faulty parts cover any obligation under this warranty. The
warranty DOES NOT cover any indirect damage and in particular any normal consumable material such as
diaphragms, ball seats, balls and others. The warranty does not cover parts damaged as a consequence of
incorrect installation, usage with fluids that not compatible with construction materials, carelessness, neglect,
incorrect maintenance, or damages due to transportation or to any other reason or event that is not directly
linked to functional or manufacturing defects. The warranty excludes all cases of improper use of the
pump or incorrect applications or non-observance of the information contained in this manual.
Any controversy falls within the jurisdiction of the Court of Varese.
SAFETY RULES
Dangerous or hazardous practices or practice not complying with the safety rules and with the
recommendations contained herein, may cause serious injuries, material damage and even explosions and
/or death for which the manufacturer cannot be held responsible.
WARNING: these instructions are essential for of the
2006/42/CE directive and must therefore be available, known, understood and applied.
WARNING: the personnel in charge of installing, inspecting and servicing the pumps must have
suitable technical knowledge and training in matters concerning potentially explosive atmospheres
and the related risks.
WARNING: Pumps are intended for operation with different types of fluids and chemical solutions.
Follow the specific internal instructions for decontamination during the inspection or maintenance
operations.
WARNING: use of the pumps in a manner that does not comply with the instructions indicated in
the use and maintenance manual will cancel all the requirements for safety and protection against of
explosions.
WARNING: the maximum allowed temperature for process fluids or powder for zone 2 is equal to
65/95°C depending on the construction materials and for zone 1 is equal to 65/80°C depending on
the construction materials; if exceeded, respect of the maximum temperature marked on the
machine cannot be guaranteed.
WARNING: before intervening on the pump and/or servicing or repairing it, please note that you
must:
a. Discharge any product that was being pumped
b. Wash it internally using a suitable non-flammable fluid, then drain.
c. Cut-off the air supply using the relevant valve and make sure that no residual pressure
remains inside it.
d. Close all on-off valves (delivery and intake sides) relative to the product;
e. Disconnect the network air supply;
f. Wear suitable individual protection before any maintenance or repair (goggles/face
protection, gloves, closed shoes, aprons and others).
WARNING: before using the pump, make sure that the fluid to be pumped is compatible with the
explosion protection class and with construction materials of the pump: DANGER OF
CORROSION, PRODUCT SPILLS AND/OR EXPLOSIONS CAUSED BY CHEMICAL
REACTIONS.
For installation and use in a potentially explosive environment, comply with these general precautions:
- ascertain that the pump is full and if possible, that the level is above it by 0.5 m;
- ascertain that the fluid treated does not contain or cannot contain large solids or solids of a
dangerous shape;
