7
5 OPERATION
During the operation of the milling machine, the following additional safety
instructions must be followed.
Only work with an earthed power cable of the proper thickness (at least 2.5
mm2).
Ensure the machine is NEVER placed under undue load while milling.
NEVER stop the cutting blade movement by applying pressure to the sides.
Only use original Flooriq cutting blades.
Removing the cutting blade
Always remove the plug from the socket before replacing the cutting blade.
And ensure you are wearing a (class P3) dust mask.
1!Unscrew the two plastic nuts on the dust cover.
2!Remove the dust cover.
3!Using a suitable spanner, loosen the nut from the shaft.
4!Remove the packing bush.
5!Removing the cutting blade.
Fitting the cutting blade
Fitting a cutting blade is carried out in the reverse order of the removal.
1!Slide the cutting blade over the drive shaft.
2!Slide the packing bush over the shaft.
3!Screw the nut onto the shaft and tighten it firmly with a suitable
spanner.
4!Fit the dust cover and tighten the two plastic nuts.
Adjusting the milling depth
1!Loosen the lock lever to the left.
2!Rotate the plastic spindle to bring the cutting blade to the desired
depth.
3!Tighten the lock lever to the right so the cutting blade remains at
the same depth. (Note: the cutting blade wears down during milling,
this affects the milling depth).
