Flavel ATLANTA FBFR**MN Manual de usuario

ATLANTA

Model No. FBFR**MN

** denotes fascia variant

RADIANT BALANCED FLUE GAS FIRE

User Instructions

These instructions should be read by the user before operating the appliance and retained

for future reference

This appliance is only for use on Natural Gas (G20) at a supply pressure of 20 mbar in G.B. /

I.E

INSTALLATION INFORMATION

CONDITIONS OF INSTALLATION

It is the law that all gas appliances are installed only by a competent (e.g. CORGI Registered)

Installer, in accordance with the installation instructions and the Gas Safety (Installation and Use)

Regulations 1998 as amended. Failure to install appliances correctly could lead to prosecution. It

is in your own interest and that of safety to comply with the law.

The fire may be fitted below a combustible shelf provided that the shelf is at least 200mm above

the top of the appliance and the depth of the shelf does not exceed 150mm.

The fire may be installed below combustible shelves, which exceed 150mm deep providing that

the clearance above the fire is increased by 15mm for each 25mm of additional overhang in

excess of 150mm.

If appliances burning fuels other than gas have previously used the chimney or flue they must be

swept prior to the installation of this fire.

If this appliance is fitted directly on to a wall without the use of a fireplace or surround, soft wall

coverings such as wallpaper, blown vinyl etc. could be affected by the heat and may discolour or

scorch. This should be considered when installing or decorating.

The Model number of this appliance is as stated on the rating plate on the firebox base and it is

manufactured by: -

BFM Europe Ltd.

Trentham Lakes

Stoke-on-Trent

Staffordshire

ST4 4TJ

Telephone 01782 339000

ABOUT YOUR NEW ATLANTA GAS FIRE

The Atlanta radiant gas fire incorporates a unique and patented combustion system that creates a

flame picture never seen before in any radiant gas fire, whilst providing class leading levels of

efficiency and safety. The technology used is completely new and has many benefits over existing

fires, so please take the time to fully read these instructions, as you will then be able to obtain the

most effective and safe operation of your fire.

When first using the new fire a slight smell may be noticed. This is due to small deposits of oil on

the firebox, but will soon disappear.

IMPORTANT SAFETY INFORMATION

WARNING

This appliance has a naked flame and as with all heating appliances a fireguard should be

used for the protection of children, the elderly and infirm. Fireguards should conform to BS

8423 : 2002 (Fireguards for use with solid fuel appliances).

Servicing should be carried out annually by a competent person such as a CORGI

registered engineer. It is a condition of the Flavel guarantees that this is carried out by a

competent person i.e. a CORGI registered Engineer in accordance with these servicing

notes

For continued safe operation of the fire the pilot assembly must be replaced at the annual

service. These are available from BFM Europe Ltd. at a specially discounted price to encourage

routine renewal and ensure continued safe and trouble free operation. Pilot renewal is also a

condition of the above guarantee schemes.

The service should include visually checking the fire opening for accumulations of debris.

After any servicing work a gas tightness check must always be carried out.

Always keep furniture and combustible materials well clear of the fire and never dry clothing or

items either on or near to the fire. Never use aerosols or flammable cleaning products near to the

fire when it is in use.

The glass remains hot for a considerable period after use and sufficient time should be allowed for

the fire to cool before cleaning etc.

The fire must only be operated with the contemporary trim and ash pan cover as supplied with the

fire and these must always be in position when the fire is used.

OPERATING THE FIRE

The controls are located behind the ashpan cover. The controls, comprise a control valve to adjust

the gas flow and a push button piezo igniter. To light the fire proceed as follows: -

1) Depress the control knob and turn anti-clockwise to the position marked pilot. Hold in the

control knob for a few seconds to allow the gas to reach the pilot.

2) Continue to hold-in the control knob and press the igniter button. If the pilot does not light,

continue to press the igniter button until ignition occurs. The pilot flame can be seen by

looking down through the glass above the centre of the burner heat shield. When the pilot has

lit, continue to hold the control knob in for 5-10 seconds to allow the thermocouple to heat up,

if the pilot goes out when the control knob is released, repeat the lighting sequence.

3) After lighting, turn the control knob in the anti-clockwise direction to the high position and the

main burner will light.

4) The gas control can be turned clockwise from the maximum position to give the desired

heat output.

5) To turn the fire off, push in and turn the control valve fully clockwise in to the off position.

the burner and pilot will go out.

NOTE : AFTER LIGHTING THE FIRE, THE FLAMES MAY SEEM TO BE LOW. THIS WILL

LAST FOR APPROX 10 MINUTES WHILST THE APPLIANCE IS WARMING UP.

WARNING

If the fire goes out for any reason or is turned off and it is necessary to re-light the fire . It is

important to allow the fire to cool for 3 minutes before attempting to re-light it.

WHEN TURNING THE FIRE “OFF” PLEASE ENSURE THAT THE

CONTROLVALVE IS TURNED TO THE “OFF” POSITION AND THE

PILOT FLAME IS EXTINGUISHED. DO NOT LEAVE THE PILOT

FLAME ONLY LIT.

NOTE : THIS APPLIANCE IS DESIGNED TO WORK SAFELY AND EFFECTIVELY DURING

ADVERSE WEATHER CONDITIONS. HOWEVER, DURING SUCH TIMES FLAME

DISTURBANCE MAY BE NOTICED. THIS IS NORMAL AND DOES NOT EFFECT OR

IMPAIR THE SAFETY OF THE APPLIANCE.

CLEANING

WARNING

Before attempting any cleaning operation ensure that the fire has been allowed to fully cool.

CLEANING THE STAINLESS AND PAINTED METAL PARTS.

The trim fitted to this appliance is stainless steel, and must only be cleaned with a clean, damp

cloth. Black painted metal parts should be gently cleaned with a damp cloth. Abrasive cleaners,

chemical cleaning agents or any type of polish must never be used as damage to the paint

may result.

Removing the Fascia

The trim is secured to the appliance with magnets and therefore can be simply lifted from the fire.

WARNING

If the glass on the appliance is damaged or removed the fire must not be ignited.

CLEANING THE GLASS.

To clean the glass panel, first ensure that the fire is cool, please note that the glass panel will

remain hot for a considerable period when the fire has been switched off.

To remove the glass panel, follow the instructions overpage for removal and re-fitting.

To glass panel should be cleaned gently with a soft damp cloth and glass cleaner.

DO NOT UNDER ANY CIRCUMSTANCES ATTEMPT TO CLEAN THE GLASS PANEL WHEN

THE APPLIANCE IS RUNNING.

REMOVAL & REFITTING OF THE GLASS FRAME.

a) Remove the fascia & ashpan cover from the firebox.

b) Remove the pilot heat shield which is held in place at each end by 1 screw.

c) Remove the top infill panel by sliding it upwards out of the clips.

d) Obtain the allen key which is located at the bottom left hand side of the firebox.

e) Loosen each allen bolt a small amount at a time to prevent damage to the glass

panel. When all the allen bolts have been removed, lift away the glass frame and

clean as per the previous page.

f) Refit the glass panel to the firebox, again tightening each bolt a small amount at a

time to prevent stressing the glass panel. Fully tighten all the bolts to ensure good

compression on the glass panel.

g) Refit the fascia & ashpan cover to the firebox.

4 Allen key

fixing screws

Top infill panel.

Due to our policy of continual improvement and development the exact

accuracy of descriptions and illustrations cannot be guaranteed

B-104490

Issue 2

BFM Europe Ltd.

Trentham Lakes

Stoke-on-Trent

Staffordshire

ST4 4TJ

www.bfm-europe.com

Telephone 0178 339000

Telephone (Service) 0844 7700169

Tabla de contenidos

Otros manuales de Chimenea de interior de Flavel

Flavel

Flavel Enchant FSCP**MN Manual de usuario

Flavel

Flavel Orchestra Manual de usuario

Flavel

Flavel Jazz Impact Manual de usuario

Flavel

Flavel Renoir FRECN0EN Instrucciones de montaje

Flavel

Flavel Linear HE Instrucciones de montaje

Flavel

Flavel Curve FCRR Series Manual de usuario

Flavel

Flavel Raglan Manual de usuario

Flavel

Flavel REGENT FRLC EN Series Manual de usuario

Flavel

Flavel Richmond Plus FOPC MN Series Instrucciones de montaje

Flavel

Flavel Ora Manual de usuario

Flavel

Flavel REGENT L.F.E. RC Instrucciones de montaje

Flavel

Flavel Calibre FBFC**MN2 Instrucciones de montaje

Flavel

Flavel FRLCP0MN Manual de usuario

Flavel

Flavel Decadence HE Series Instrucciones de montaje

Flavel

Flavel Atlanta FAVRU0MN Manual de usuario

Flavel

Flavel "Waverley" Inset Tray FITC00MN Instrucciones de montaje

Flavel

Flavel Pure FPRG**RN2 Manual de usuario

Flavel

Flavel Onyx MK2 FFHOW0RE2 Manual de usuario

Flavel

Flavel Linear Pebble Manual de usuario

Flavel

Flavel Kenilworth HE Instrucciones de montaje

Flavel

Flavel FRDC**MN Series Manual de usuario

Flavel

Flavel Curve Manual de usuario

Flavel

Flavel Warwick FIRC**MN Manual de usuario

Flavel

Flavel Atlanta Manual de usuario

Manuales populares de Chimenea de interior de otras marcas

Brigantia

Brigantia 35-DVRS31N-2 Manual del propietario

Nordpeis

Nordpeis Bergen Manual de usuario

Superior

Superior BCT2536TMN Manual de usuario

Quadra-Fire

Quadra-Fire 5100I-GD-B Manual de usuario

Renaissance

Renaissance RUMFORD 1000 Manual de usuario

Lacunza

Lacunza IV-800 Manual de usuario

Baxi

Baxi 940 Instrucciones de uso

Dru

Dru Maestro 60/2 Tall RCH Manual de usuario

Diamond Fireglass

Diamond Fireglass SS-O22 Manual de usuario

HearthStone

HearthStone Windsor Bay 8830 Manual de programación

Napoleon

Napoleon ASCENT B42 Manual de usuario

Enviro

Enviro E33GI Manual de usuario

Smeg

Smeg L30 FABE Instrucciones de montaje

KEDDY

KEDDY K700 Manual de usuario

Godin

Godin 3451 Manual de usuario

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Manual de usuario

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 Manual de usuario

Desa

Desa CCFPDFT Manual de operación