Flashforge Observer Manual de usuario
Observer User Manual | www.flashforge-usa.com
1
User Manual
Observer –Handheld 3D Scanner
V1.0 14.10.2014
Observer User Manual | www.flashforge-usa.com
2
Observer User Manual | www.flashforge-usa.com
3
Table of Contents
Thank you for choosing FlashForge Observer 3D Scanner
A. Overview
Chapter 1. Summary
A. Unboxing
B. Introduction
Chapter 2. Software
A. Software Installation and Usage
B. Shortcuts Set Ups
Chapter 3. Begin to Scan
A. Scanner Modes
B. Preferred Scanning Environment
Chapter 4. Cloud Server
A. Uploading
Observer User Manual | www.flashforge-usa.com
4
Thank you for choosing
FlashForge Observer 3D Scanner
A. Overview
Observer User Manual | www.flashforge-usa.com
4
Observer User Manual | www.flashforge-usa.com
5
A.Overview
Note: Thank you for reading and supporting this user manual. This
manual is for the use of FlashForge Observer 3D Scanner only. There are
three chapters on this manual and all operations described are base on
Windows 7, 64 bit operation system.
There are certain hardware requirements when using the FlashForge
Observer 3D Scanner. Faster CPU and audio card would increase the
speed of playback and color combining. However, it would not affect the
resolution on position and color.
Recommended hardware: i3 –i7 CUP, 4G memory, NVIDIA audio card
2G or above, USB 2.0 adaptor. The FlashForge Observer does not support
desktop of any kind. Also, the FlashForge Observer does not support
either AMD or Intel audio card.
Caution: when using the scanner, unplugging the data cable or power
cord of notebook computer is strictly prohibited and any damage caused
by this action would not be covered by our warranty. This manual is
available in different languages. Please contact your local reseller for
details.
2
4
Observer User Manual | www.flashforge-usa.com
6
Chapter 1
Summray
A. Unboxing
B. Introduction
Observer User Manual | www.flashforge-usa.com
Observer User Manual | www.flashforge-usa.com
7
A.Unboxing
Observer 用户使用指南 | www.sz3dp.com
6
1、After opening the box, you will see a piece
of black foam sheet protecting what is inside.
2、Under the foam, you can see the Scanner,
Combination Key, Disc and After-sales
service card at their corresponding position.
3、By taking the first layer of foam out, you
will see a turntable. Under the turntable there
is a power cord, and a voltage transmitter.
Observer User Manual | www.flashforge-usa.com
8
Everything in this picture should be included. If there is anything missing, please
contact us immediately, and we will provide a solution to you right away.
Observer User Manual | www.flashforge-usa.com
9
B.Introduction
This chapter will talk about the function of each parts of the printer and how to use
them properly.
1、Handheld 3D scanner, insert USB cable to
notebook computer. We will talk in detail about
how to use the software to complete a scan.
2、After-sales Service Card, it lists terms,
conditions and our contact information. Please
read carefully.
3、Combination key, every scanner comes with
a combination key. Scanner would only work
when this key is inserted.
Observer User Manual | www.flashforge-usa.com
10
4、Disc, scanner software and videos of use are
stored here.
5、Turn table, requires horizontally leveled
ground, human standing on turn table say “turn
table turn”, used when constructing 3D model.
Turn table turns at 10 rpm. To prevent injury,
please do not step up or down the turn table
when it is turning.
6、Power cord (for turn table), this power cord
is used to provide electricity to the turn table.
There is a switch in the middle of the cord.
Tabla de contenidos
