We reserve the right to change designs and technical specifications of our products.
7
ENG
Alternatively, to contact other Flamco locations, please see the contact page in Appendix 4: Contact
5 Safety
This equipment is intended to fill and/or top-up sealed water-based heating and cooling systems, in
which temperature-induced changes in the volume of the system water (the heat transferring agent)
is governed by a separate expansion vessel and safety relief valve.
This product is suitable and appropriate for the operation in heat generating systems according to
BS7074, BSEN 12828, BSEN 12952 and BSEN 12953.
The Principal / Operator, will need to consult with a local authorities on any additional safety
measures that are required.
5.1 Incoming goods
The items delivered must be compared against the items listed on the shipping note and inspected
for conformity. If not in line with the documentation or if the delivery is incorrect in another way,
the product must not be used. The goods may also be warehoused in their packaging. Once it has
been removed from its packaging, the equipment must be put in position, observing standard safety
procedures.
Always check the unit for damage and appropriate markings according to Appendix2:
Markings in this manual.
5.2 Operations location
The responsible person carries the responsibility over the designated plant room that meets all the
requirements stated above.
Definition: Room which meets the applicable European and local regulations, standards and
relevant technical rules and guidelines of the professional associations for this
field of application. For the use of the FlexFiller Direct G4 as prescribed in this
manual these rooms generally contain equipment for thermal generation and
distribution, water heating/cooling and top-up, power source and distribution,
such as measuring, control engineering, control technology and IT.
Access for unqualified and untrained persons must be restricted or forbidden
Unit Internal access
The unit internals can be accessed for service or repair, by a Qualified Person. The unit can only be
accessed by using a specialized tool. Any attempts to access the internals of the unit without the
correct equipment will invalidate the Flamco Warranty and will be classified as use in an improper
manner, according to our General Conditions of Sale.
5.3 Electrical
Electrical equipment inspections, routine inspection
Without prejudice to the considerations of the insurer/Operator, it is recommended that the
electrical equipment of the FlexFiller Direct G4 be inspected and documented together with the
heating/cooling unit no less than every 18 months (see also DIN EN 60204-1 2007).
