Figure 1: The FLAIM Trainer system 3
Figure 2: Standard packaging for the FLAIM Trainer system 3
Figure 3: Standard packaging of support components 4
Figure 4: Standard packaging of the SCBA, VR headset and half facemask 5
Figure 5: Standard packaging of the hose reel 6
Figure 6: Tracking system 13
Figure 7: Tracking system showing plug locations 13
Figure 8: Typical configuration of training area 14
Figure 9: Trackers installed on tripods angled at ~30 degrees 14
Figure 10: Instructor viewing hardware 15
Figure 11: SCBA Main battery installation 16
Figure 12: Battery connected and secured 16
Figure 13: Connect the hose reel to a standard power socket 17
Figure 14: Hose rewind and system power 17
Figure 15: Nozzle face showing batteries installed and tracking puck 17
Figure 16: When installed, the puck should look like this 18
Figure 17: Step 1. Power to hose reel 19
Figure 18: Step 1 Connect two trackers 20
Figure 19: Step 3. Ensure HDMI receiver is powered 20
Figure 20: Step 4. Power on SCBA Backpack - short press 20
Figure 21: Step 5. Short press to power on nozzle puck 21
Figure 22: Step 6. Power on or wake instructor tablet 21
Figure 23: Instructor tablet home screen 23
Figure 24: FLAIM Trainer instructor software 23
Figure 25: Basic room setup configuration 24
Figure 26: Room Setup Step 1 25
Figure 27: Room Setup Step 2 25
Figure 28: Room Setup Step 3 25
Figure 29: Room Setup Step 25
Figure 30: Room Setup Step 5 25
Figure 31: Room Setup Step 6 26
Contents
