Fisher & Paykel WM1490P Manual de usuario

INSTALLATION GUIDE / USER GUIDE

GB IE SG

FRONT LOADING CLOTHES WASHER

WM1490F, WM1490P, WM1480P

& WM1280J models

CONTENTS

IMPORTANT!

SAVE THESE INSTRUCTIONS

The models shown in this user guide may

not be available in all markets and are

subject to change at any time. For current

details about model and specification

availability in your country, please go to

our website www.fisherpaykel.com or

contact your local Fisher & Paykel dealer.

Registration

provide you with the best service possible.

To register your product visit our website:

www.fisherpaykel.com

Introduction 3

Safety and warnings 4

Installation instructions 6

Before you do your first wash 13

Getting started quickly 14

Washer controls 20

Safety features 21

Sorting and loading 22

Detergent and fabric softener 24

Wash cycles 28

Wash cycle options 31

Customising wash cycles 35

Caring for your washer 36

Before you call for service 39

Fault codes 41

Troubleshooting 42

Consumption data table 47

Product Fiche (according to EU 1061/2010) 48

Manufacturer’s Warranty 49

Customer Care 51

European Directive 2012/19/EU on Waste Electrical 53

and Electronic Equipment (WEEE)

INTRODUCTION

Welcome

Thank you for buying a Fisher & Paykel clothes washer. We are proud of this washer

and trust it will serve you well for many years.

At Fisher & Paykel we aim to provide innovative products that are simple to use,

ergonomic and kind to the environment. Your washer has numerous wash cycles

and options so you can perform every wash task with ease and the knowledge your

clothes are receiving the best possible care.

Please take the time to read these instructions carefully before you begin using your

machine.

Following the advice in this user guide will ensure you get the performance you

expect from your machine and that you get the best possible wash results. Keep these

instructions for future reference.

We hope you enjoy your new washer. We have certainly enjoyed designing it for you.

Front loading washer

SAFETY AND WARNINGS

IMPORTANT SAFETY INSTRUCTIONS

WARNING!

When using this appliance always exercise basic

safety precautions including the following:

• This clothes washer is not intended for use by

persons (including children aged below 8years) with

reduced physical, sensory, or mental capabilities, or

lack of experience and knowledge, unless they are

supervised or given instructions on how to use the

washer by someone responsible for their safety and

they understand the hazards involved.

• The washer should only be used for washing and

rinsing of textiles where this is indicated on the

carelabel.

• The door will be locked from the start of the cycle

until the cycle is complete for safety reasons. It is

possible to open the door during the cycle under

certain conditions (refer to page21).

• Never force the door open.

• Keep children away from the washer while it is in

operation.

• Children of less than 3years should be kept away

unless continuously supervised.

• Cleaning and user maintenance shall not be made by

children without supervision.

• Supervise children to ensure they do not play with

the washer or climb inside the drum.

• Do not touch the glass part of the door during a

cycle as the door can become hot.

• Do not open the detergent dispenser during the

cycle as hot water may come out of it.

SAFETY AND WARNINGS

• The only user-removable parts of the washer are

the inlet hoses, detergent dispenser and the pump

filter. No other parts are designed to be removed

by anyone other than a Fisher & Paykel trained and

supported service technician.

• When disposing of the washer, it is recommended

that the door is removed to avoid children getting

trapped inside, and that the electrical cable is cut off

close to the washer.

INSTALLATION INSTRUCTIONS

Accessories

Please check you received the following accessories with your Fisher & Paykel washer.

You will find them inside the drum or attached to the packaging.

 2 x Inlet hoses

 1 x Drain hose guide

 1 x Installation instructions and user guide

 1 x Spanner

 1 x Installation leaflet (attached to the top of the washer)

 1 x Inlet valve cap

 1 x Hose clamp

Unpacking

To ensure the best performance from your new washer please follow the instructions below.

Removing the packaging

1Remove the outer packaging (including the polystyrene packer and plastic wrapping). All

packaging must be removed prior to use. Ensure these materials are kept out of reach of

children. Note: a small amount of water may be seen inside the packaging and inside the

washer. This is the result of factory testing and is normal.

2Tilt the machine backwards and ‘walk’ it off the base one foot at a time. Not doing so

may cause damage to your floor and washer.

3Remove all packaging and accessories from inside the drum.

Removing the transit bolts

The clothes washer is fitted with 4 transit bolts at the rear to avoid damage during

transportation.

IMPORTANT!

The 4 transit bolts MUST be removed prior to operation of the machine. Failure to

remove these will result in damage to the machine.

To remove the bolts:

1Use a spanner or socket to unscrew and remove all four transit bolts at the back of the

washer (A).

2Pull the black rubber grommets to remove the bolt, grommet and white plastic spacers

from the machine. Keep the transit bolts in case they are required for future transit of the

machine. Never transport the machine without the transit bolts properly fixed in place.

3Cover the bolt holes with the white plastic plugs which are attached to the machine and

located near each hole (B). Push to clip into place.

Removing the transit safety bolts

INSTALLATION INSTRUCTIONS

Product dimensions

WM1490F

WM1490P

WM1480P

WM1280J

PRODUCT DIMENSIONS mm mm

AOverall height of product 850 850

BOverall width of product 600 600

COverall depth of product

(excluding dial and door whenclosed)

645 570

DDepth of door open 1065 1010

EMinimum door clearance to adjacent wall 330 330

Standpipe height min. 800–1200 min. 800–1200

MAXIMUM CAPACITY kg kg

9.0 8.0

Note: the exact height of your washer is dependent on how far the feet are extended

from the base of the machine. The space where you install your washer needs to be at

least 40mm wider and 20mm deeper than its dimensions.

 Electrical supply: 220–240V, 50Hz Sinusoidal, minimum 10A.

 Inlet water static pressure: Max. 1MPa (150psi), Min. 30kPa (4.5psi).

 Inlet water flow rate at tap: Min. 6litres/min.

TOP VIEWWallFRONT VIEW

INSTALLATION INSTRUCTIONS

Location

IMPORTANT!

Install the machine on a solid and level floor surface ensuring it has at least 20mm

clearance on each side. The washer must not be installed on any textured floor

coverings (eg carpet, rugs).

Note: this machine must not be installed and operated on a plinth.

Levelling the machine

It is IMPORTANT to level the machine to ensure good spin

performance, and to minimise noise, vibrations and wear

and tear on the washer.

1Before positioning the machine in its final position, check

that the machine is level, front to back and side to side.

2Manoeuvre the product into its final position (we suggest a

minimum clearance of 20mm each side).

3Use a spirit level to check that the machine is correctly

level. If needed, pull the machine out. Loosen the lock nut

using the spanner provided and wind the feet up or down

to correctly level the machine.

4Using the spanner provided, tighten the lock nuts against

the base of the machine to lock the feet in position.

Connecting to the water supply

Inlet hoses

IMPORTANT!

 New hose sets provided with the washer should be

used to connect the washer to the water mains.

 Old hose sets should not be re-used.

 We recommend the inlet hoses are changed every

5 years. WARNING: Failure to do so may result in a

flood and damage to property.

1Connect the straight ends of the inlet hoses to the taps and the elbow ends to the

corresponding machine inlet valves. The hot valve is colour coded orange to make this

easier. Tighten the inlet hose ends by hand until the hose seal makes contact with the

tap sealing face and then tighten a further half-turn. Make sure there are no kinks in

the hoses.

2Turn the taps on and check for leaks. Check for leaks again after 24hours.

IMPORTANT!

The hot water temperature should not exceed 65°C and the cold water temperature

not exceed35°C. Temperatures above these may cause the machine to fault or cause

damage to the machine.

Locking the feet

Inlet hose ends

Elbow

(machine) end

Straight

(tap) end

Este manual sirve para los siguientes modelos

Otros manuales de Arandela de Fisher & Paykel

Fisher & Paykel

Fisher & Paykel AWF70MD Manual de usuario

Fisher & Paykel

Fisher & Paykel WA70T60GW1 Manual de usuario

Fisher & Paykel

Fisher & Paykel FabricSmart WA8060P Manual de usuario

Fisher & Paykel

Fisher & Paykel WH9060J Manual de usuario

Fisher & Paykel

Fisher & Paykel FabricSmart WA1068P Manual de usuario

Fisher & Paykel

Fisher & Paykel QuickSmart Instrucciones de montaje

Fisher & Paykel

Fisher & Paykel WA37T26EW Manual de usuario

Fisher & Paykel

Fisher & Paykel WashSmart Eco Diagrama de cableado

Fisher & Paykel

Fisher & Paykel CLEANSMART WL8O60P Manual de usuario

Fisher & Paykel

Fisher & Paykel WH8060P Instrucciones de montaje

Fisher & Paykel

Fisher & Paykel FabricSmart WA1068P Instrucciones de montaje

Fisher & Paykel

Fisher & Paykel WA3927G1 Manual de usuario

Fisher & Paykel

Fisher & Paykel WH1260F1 Manual de usuario

Fisher & Paykel

Fisher & Paykel WM1490P2 Manual de usuario

Fisher & Paykel

Fisher & Paykel WashSmart Eco Manual de usuario

Fisher & Paykel

Fisher & Paykel CLEANSMART 7 Series Manual de usuario

Fisher & Paykel

Fisher & Paykel ecosmart GWL11 Instrucciones de montaje

Fisher & Paykel

Fisher & Paykel AquaSmart WL26C Instrucciones de montaje

Fisher & Paykel

Fisher & Paykel eco smart PHASE 6 12 Series Manual de usuario

Fisher & Paykel

Fisher & Paykel FabricSmart WA8060P Manual de usuario

Fisher & Paykel

Fisher & Paykel WashSmart WH1260P1 Manual de usuario

Fisher & Paykel

Fisher & Paykel WASHSMART WA1060E Manual de usuario

Fisher & Paykel

Fisher & Paykel WashSmart Manual de usuario

Fisher & Paykel

Fisher & Paykel WH1060P1 Manual de usuario

Manuales populares de Arandela de otras marcas

Tricity Bendix

Tricity Bendix AW 1000 W Guía del producto

Panasonic

Panasonic NA-F60L5WRB Manual de usuario

GE WSLP1500 Manual

Electrolux

Electrolux EWF1284EDW Manual de usuario

Bosch

Bosch WAN2829BSN Manual de usuario

LG TV2516DV3B Manual de usuario

LG TH2517DSAV Manual de usuario

VESTEL

VESTEL CMH-XL 7510 TE Manual de usuario

AEG

AEG 74335 Manual de operación

Johnson

Johnson JWF721A Manual de usuario

Beko

Beko WTE7604XLW0 Manual de usuario

Danby

Danby DTT100A1WDB Instrucciones de montaje

Amica

Amica WA 14 Ex Manual de usuario

Daewoo

Daewoo DWD-F1222 Manual de usuario

Bosch

Bosch WAS28461AU Manual de usuario

Miele

Miele PW 6080 Vario Manual de usuario

Finlux

Finlux FLX108CF220 Manual de usuario

Whirlpool

Whirlpool 3LBR5132AN0 Manual de usuario