Fisher & Paykel OR60SDBGFX2 Manual de usuario
Care and cleaning
Always turn off the oven at the wall first. Ensure the oven has cooled down completely before starting.
Before you start cleaning your cooker, please:
• Read these cleaning instructions and the ‘Safety and warnings’ section at the start of this
user guide.
• Turn the power to the cooker off at the wall.
• Make sure the cooker is a safe temperature to touch.
• Do not use a steam cleaner.
• Do not keep flammable substances in the oven.
General advice
• Wipe down the cooktop and wipe out the oven after every use.
• Wipe up spills. Avoid leaving alkaline or acidic substances (such as lemon juice or vinegar) on the surfaces.
• Do not use cleaning products with a chlorine or acidic base.
Cleaning the outside of the cooker
• Do not use abrasive cleaners, cloths or pads on the outside surfaces.
• Immediately wipe off any caustic cleaners if they are spilled onto the oven door handle.
Wipe the outside surfaces often, using warm water and a mild household detergent. The stainless steel may also
be cleaned with a suitable cleaner and polish.
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX…
Updated: Wed, 12 Apr 2023 09:13:40 GMT
Powered by
1
if you choose to use a commercial stainless steel cleaner, please read the label to make
sure it does not contain chlorine compounds as these are corrosive and may damage the
appearance of your cooker.
Cleaning the gas cooktop
Maintenance
Period Description
Daily • Clean gas cooktop as per following instructions.
Monthly
• Remove all burner parts, and clean using a non-abrasive detergent. Rinse in cold water, dry
thoroughly, and replace.
• Clean the ignitor carefully, using a toothbrush and methylated spirits.
Every 3-4
years
• Contact your local authorised gas Service Agent to perform a thorough check on all gas
components on the gas cooker.
Burner parts and trivets
• You can remove and clean these parts with hot soapy water or non-abrasive detergents. Clean spills regularly
before they become burnt on. Do not wash these parts in a dishwasher.
• After cleaning, check that the burners and their flame spreaders are dry before replacing correctly.
• It is very important to check that the burner flame spreader and the cap have been correctly positioned. Failure
to do so can cause serious problems.
to avoid damage to the electronic ignition, do not try to light a burner without all burner
parts correctly in place.
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX…
Updated: Wed, 12 Apr 2023 09:13:40 GMT
Powered by
2
Replacing the auxiliary and semi-rapid burners
• Carefully replace the burner parts as per the following Figs.
• Check that the ignitor is always clean to ensure trouble-free sparking.
• Clean it carefully with a toothbrush and methylated spirits (see Fig.26).
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX…
Updated: Wed, 12 Apr 2023 09:13:40 GMT
Powered by
3
Replacing the triple-ring wok burner
Fit the burner ring to the housing as shown by the arrow in the Fig. following. Make sure the burner is not able to
rotate (Fig.31).
Fig. 31 Correct positioning of cap and ring -
triple-ring wok burner
Fig. 32 Incorrect and correct positioning of cap and ring -
triple-ring wok burner
Cleaning the inside of your oven
Do not use abrasive cleaners, cloths or pads to clean the enamel. Clean the enamel on the inside of the oven
when it has cooled down, using household detergents or an ammonia-based cleaner. You may use ‘off the shelf’
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX…
Updated: Wed, 12 Apr 2023 09:13:40 GMT
Powered by
5
oven cleaners, if you carefully follow the manufacturers’ instructions.
To make cleaning easier, you can remove the side
racks, the oven door, and the fat filter. The grill element
is self-cleaning.
Fig. 33 Removing the side racks
Cleaning the fat filter
Clean the fat filter after every use. If the filter is not
cleaned, it will block and shorten the life of the fan
element. If it is lightly soiled, place the filter in a
dishwasher on normal wash. If the filter is very dirty,
place in a saucepan with either two tablespoons of
clothes washing powder, or one tablespoon of
dishwashing powder. Bring to the boil and leave to soak
for at least 30 minutes. Rinse the filter in clean water and
dry.
Fig. 34 Fat filter
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX…
Updated: Wed, 12 Apr 2023 09:13:40 GMT
Powered by
6
Cleaning the oven door glass
Do not use harsh abrasive cleaners or sharp metal
scrapers to clean the oven door glass since they scratch
the surface, which may result in shattering of the glass.
The inner glass door panel can easily be removed for
cleaning by unscrewing the two fixing screws (Fig. 35).
When re-assembling, ensure that the inner glass is
correctly positioned and do not over-tighten the screws.
Fig. 35 Oven door glass
Drawer
The drawer comes out like a normal drawer.
Do not store flammable material in the
drawer.
Fig. 36 Drawer
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX…
Updated: Wed, 12 Apr 2023 09:13:40 GMT
Powered by
7
Removing the oven door
The oven door can easily be removed as follows:
1. Open the door completely.
2. Hook the swivel retainers of the right-hand and left-
hand hinges (Fig. 37a) onto the metal bar above
them (Fig. 37b).
3. Lift the oven door slightly. The notch on the bottom
of the hinge will disengage (Fig. 37c).
4. Now pull the oven door forwards off the appliance.
Release both hinge sections from the slots (Fig.
37d).
5. Rest the door on a soft surface.
To replace the door, repeat the above steps in reverse
order.
Fig.37a
Fig.37b
Fig.37c
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX…
Updated: Wed, 12 Apr 2023 09:13:40 GMT
Powered by
8
Fig.37e Fig.37d
Replacing the oven lamp
1. Turn the power to the cooker off at the wall.
2. Let the oven cavity and the heating elements cool down.
3. Remove the protective cover “B”.
4. Unscrew and replace the bulb “A” with a new one suitable for high temperatures (300°C) with the following
specifications: 230-240V, 50Hz, E14 and same wattage as the bulb being replaced (check wattage stamped on
the bulb).
5. Refit the protective cover “B”.
Oven bulb replacement is not covered by your warranty.
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX…
Updated: Wed, 12 Apr 2023 09:13:40 GMT
Powered by
9
Otros manuales para OR60SDBGFX2
3
Tabla de contenidos
Otros manuales de Estufa de Fisher & Paykel
Fisher & Paykel
Fisher & Paykel OR90SDBSIX2 Manual de usuario
Fisher & Paykel
Fisher & Paykel OR90LDBGFX3 Manual de usuario
Fisher & Paykel
Fisher & Paykel Galaxy DI1203 Series Manual de usuario
Fisher & Paykel
Fisher & Paykel PROFESSIONAL Series Manual de usuario
Fisher & Paykel
Fisher & Paykel OR90SPG6 Manual de usuario
Fisher & Paykel
Fisher & Paykel OR30SDE Manual de usuario
Fisher & Paykel
Fisher & Paykel OR90SDBGFX3 Manual de usuario
Fisher & Paykel
Fisher & Paykel OR120DDWGFX2 Manual de usuario
Fisher & Paykel
Fisher & Paykel OR90SCI4B1 Manual de usuario
Fisher & Paykel
Fisher & Paykel OR90SCI1X Series Manual de usuario
Fisher & Paykel
Fisher & Paykel OR90SDBGFPX Instrucciones de montaje
Fisher & Paykel
Fisher & Paykel Classic Series Manual de usuario
Fisher & Paykel
Fisher & Paykel CG302DLPGB1 Manual de usuario
Fisher & Paykel
Fisher & Paykel CG905DWLPACX2 Manual de usuario
Fisher & Paykel
Fisher & Paykel OR90SDBSIX2 Manual de usuario
Fisher & Paykel
Fisher & Paykel OR90SDBSIPX1 Manual de usuario
Fisher & Paykel
Fisher & Paykel CG905DWFCX1 Manual de usuario
Fisher & Paykel
Fisher & Paykel OR60 models Instrucciones de montaje
Fisher & Paykel
Fisher & Paykel OR90SCG6R1 Manual de usuario
Fisher & Paykel
Fisher & Paykel OR90SCI6 Manual de usuario
