First Degree Fitness Fluid Cycle XT E720 Manual de usuario
Owners Manual
XT-E720
2
Training with E720
As with any piece of fitness equipment, consult a physician be-
fore beginning your E720 exercise program.
CAUTION
Use two hands and follow all safety instruc-
tions whenever raising or lowering the E720
control arm.
Warning
Do not remove feet or hands while crank is in motion. The crank
will continue to rotate and could cause injury.
3
Contents
Box Contents
Assembly Seat Back and Lower Seat
Assembly Mainframt and Lower Seat Frame
Assembly Upper Seat Frame and Lower Seat Frame
Assembly Right Crank Pedal
Control Arm
Tank Filling and Water Treatment
Long Term Water Treatment and Basic Operation
Rower Ergometer
Using the First Degree Fitness USB Interface
Maintenance chart
Troubleshooting
Tank Belt Adjustment
Warranty
5
6
7
8
9
10
11
12
13
14
15
16
17
18
4
1
10
2
3
4
5
6 7
8
9
21
22
17
11
12 13
14
15
16
18
19
20
Box Contents
5
Item Qty Description Item Qty Description
1 1 Mainframe 12 6 M10 Washer
2 1 Lower Seat Frame 13 1 M10 Plastic Washer
3 1 Upper Seat Frame 14 3 Nylock Nut
4 2 Seat Back/Lower Seat 15 1 4mm Allen Key
5 1 Right Crank Pedal 16 1 6mm Allen Key
6 1 L-pin 17 1 Multi-tool
7 3 Leveler 18 2 AA Batteries
8 1
Seat Frame lubricating
grease 19 1 Touch up paint
11 8 M6 Washer 22 1 Owners Manual
9 8 M6x20mm bolt 20 4 Water Treatment Tablet
10 3 M10x25mm bolt 21 1 Funnel and Hose
6
Assembly Seat Back and Lower Seat
Seat Back to Upper Seat Frame using 4x M6x20mm bolts[9] and 4x
M6 washers[11].
Lower Seat to Upper seat frame using 4x M6x20mm bolts[9] and 4x
M6 washers[11.
Upper Seat Frame
Lower Seat
Seat Back
M6 Washer
M6x20mm bolt
7
M10 Nylock nut
M10 Washer
M10x25mm bolt
Assembly Mainframe and Lower Seat Frame
Attach Lower Seat Frame[2] to Mainframe[1] using 2x M10x25mm
bolts[10], 2x M10 Nylock nuts[14] and 4x M10 Washers[12]
Mainframe
Lower Seat Frame
8
L-Pin
M10x25mm bolt
M10 Nylock
nut
M10 Washer
Assembly Upper Seat Frame and Lower Seat Frame
M10 plastic
washer
Before installing the upper
seat frame onto the lower,
use the supplied grease
and apply liberally between
the two sliding surfaces
Upper Seat Frame onto Mainframe and secure using 1x M10x25mm
bolt[10], 1x M10 Nylock nut[14], 2xM10 Washers[12],M10 Plastic
Washer and L-pin[6].
Note: Tighten the M10x25mm bolt, washers and Nylock until lightly snug
only. Over-tightening will prevent the seat from rotating. Use the L-pin to
tighten the upper seat frame once rotated into place.
9
Secure Right Crank Pedal[5] onto Crank arm. The pedal threads have
a blue coating which will feel very tight when threaded onto the crank
arm. This is a type of thread locker, and once in contact with the crank
arm threads will activate in approximately 15minutes.
Caution! Extreme over-tightening could damage the aluminum threads
on the crank arm.
Note: Allow 15 minutes for the thread-locker to activate before first time
use.
Check pedal tightness on a regular basis and tighten as needed with a
15mm wrench.
Assembly Right Crank Pedal
10
Control Arm
The E720 Pedal: This patented
design allows for usage in both the
recumbent position and for sitting/
standing upper body workouts.
L-pin: Loosen when rotat-
ing the control arm and
tighten (snug only) once the
desired position has been
reached.
T-pin: The T-pin locks the
control arm in any one of 72
different positions through-
out its 360 degree range of
motion. Pull up the T-pin
to allow the control arm to
rotate while supporting the
control arm with the other
hand.
Crank arm bolts: Loosen
all 8 bolts slightly before
adjusting/tightening chain.
Chain tensioning bolts: Allows for tightening the chain or adjustment from side to
side. Make sure when tightening only to adjust the same amount for both bolts, oth-
erwise the sprocket will be misaligned.
Note: Tightening the right bolt only will pull the right side of the crank assembly to-
ward you, tightening the left will pull the left side toward you. Use this feature to re-
align the rear with the front sprocket if needed or when changing to a new chain.
Inspection plate: Open to check
chain tension.
Warning: Do not check
chain tension by hand!
Otros manuales para Fluid Cycle XT E720
1
Tabla de contenidos
