Firesense PH08-SA Manual de usuario
- 1-
Patio Heater
Model: PH08-SA, PH08-SSA
Item #: 60804
Instruction Manual & Parts List
INSTALLER: Please leave this manual for the consumer.
CONSUMER: Please retain this manual for future reference.
MANUFACTURER: Changzhou Wellife Furnace Co., Ltd.
WARNING: For outdoor use only.
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, immediately call
gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors or liquids in the
vicinity of this or any other appliance.
An LP-cylinder not connected for
use shall not be stored in the
vicinity of this or any other
appliance.
3177588
- 2-
DANGER CARBON MONOXIDE HAZARD
This appliance can produce carbon
monoxide which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed
space such as a camper, tent, car or
home.
WARNING :
For Outdoor Use Only
LPG Cylinders to be used must be constructed and
marked in accordance with US DOT specifications.
Storage of the heater indoors is permissible only
if the gas cylinder is turned off and removed.
NOTE:
Use only 20lb LP-Gas tank with size of
18.1in / 46cm(Height)*12.5in / 32cm
(Width).
Do not use if the environment temperature
is below 40 degrees F / 4.4 degrees C.
WARNING: Improper installation, adjustment,
alteration, service or maintenance can cause injury
or property damage. Read the installation,
operating and maintenance instructions thoroughly
before installing or servicing this equipment.
Tools needed:
●Open end wrench 10 & 13mm
(included)
NOT included:
●Adjustable opening wrench 8’’
long
●Philips screwdriver w/ medium
blade
●Spray bottle of soapy solution
for leak testing
Tools and parts needed for assembly
- 3-
NOTE: PLEASE READ THE FOLLOWING SAFETY RULES
WARNING:
PRECAUTIONS
This heater must only be used outdoors. Using this product in an enclosed area may
cause injury, death or property damage.
Only use in a well-ventilated space. Do not use in a building, garage, or any other
enclosed area.
Read the instructions before use. This heater must be installed in accordance
with local codes or, in the absences of local codes, with the National Fuel Code, ANSI
Z223.1. If applicable, the heater, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes, with The National
Electrical Code, ANSI/NFPA70.
Do not use the heater in an explosive atmosphere. Keep the heater away from areas
where gasoline or other flammable liquids or vapors are stored.
Prior to use, check for damaged parts such as hoses, regulators, pilot or burner.
Turn off and disconnect LPG cylinder before moving the heater.
Do not attempt to alter this heater in any manner. EXAMPLE: Using the heater
without the top canopy reflector or radiant screen.
Do not use this heater in basements or below ground level. It must always be placed
on a solid and level surface.
Always ensure there is ample fresh air ventilation. For outdoor use ONLY.
Never replace or substitute the regulator with any regulator other than the factory
suggested replacement.
Do not clean the heater with cleaners that are combustible or corrosive.
Do not paint radiant screen, control panel, or top canopy reflector.
All leak tests should be done with a soapy solution. NEVER USE AN OPEN FLAME TO
CHECK FOR LEAKS.
The LPG cylinder should be turned off when the heater is not in use.
At least once a year, the unit should be inspected for the presence of spiders, spider
webs or other insects.
- 4-
CHECK THE HEATER IMMEDIATELY IF ANY OF THE FOLLOWING
EXIST:
1. The smell of gas in conjunction with extreme yellow colored tips of the burner flames.
2. The heater does not reach temperature.
3. The burner makes a popping noise during use (a slight popping noise is normal when
the burner is extinguished after using).
Children and adults should be aware of the hazards of high surface temperature, and
should stay away to avoid burns or clothing ignition.
Young children should be carefully supervised when they are in the area of the heater.
Clothing or other flammable material should not be hung from the heater, or placed on
or near the heater.
Any guard or other protective device removed for servicing the heater must be
replaced prior to operating the heater.
Installation and repair should be done by a qualified service person. The heater should
be inspected before use and cleaning may be required at least once a year, or as
necessary. It is imperative that the control compartment, burner and circulating
passageways of the heater are kept clean.
Keep the heater area clear of combustible materials such as gasoline and other flammable
vapors and liquids.
Do not obstruct the flow of combustion and ventilation air.
Keep the ventilation opening of the LPG cylinder enclosure free and clear of debris.
Storage of a heater indoors is permissible only if the LPG cylinder is turned off,
disconnected and removed from the heater.
Cylinders must be stored outdoors in a well-ventilated area out of the reach of
children. Disconnected cylinders must have threaded valve plugs tightly installed,
and must not be stored in a building, garage or any other enclosed area.
。
PRECAUTIONS
- 5-
1. Base assembly with
tank and control
housing
2. 2pcs wheels
3. Handle
4. 2pcs glass tube fixed
parts (one for top, one
for bottom)
5. 2pcs glass tube
6. Glass tube connector
7. 4pcs lower support
8. 4pcs upper support
9. 4pcs support connector
10.8pcs mesh guard
11.Upper plate
12.Top reflector
13.4pcs mesh fixed parts
(see exploded view
below)
14.3pcs gas cylinder fixed
parts and 3pcs
M8x25mm bolts (to
secure LPG cylinder on
base)
15.4pcs M12 screws
16.4pcs M5x10mm bolts
17.4pcs M6x12mm bolts
18.6pcs M6x12mm bolts
19.3pcs 3/16’’ screws
20.3pcs M4x8mm screws
21.3pcs M4x8mm screws
22.4pcs M4x8mm screws
23.8pcs M6x18mm bolts
24.8pcs M6 nuts
ASSEMBLY
# 13 (exploded view)
- 6-
WARNING: This appliance requires installation by a competent
person. Proper assembly is the responsibility of the installer.
Step 1
Attach the wheels (2) to the base assembly
(1)with 8pcs M6x18mm bolts (23) and
8pcs M6 nuts (24).
Step 2
Attach the handle (3) to the back
panel of the base assembly(1) with
4pcs M6x12mm bolts (17).
ASSEMBLY
- 7-
Step 3
Attach one of the glass tube fixed
parts (4) on the base assembly (1)
with 3pcs M4x8mm screws (20).
Step 4
Screw the 4pcs lower support (7)
into the holes located on the top
of the base assembly (1).
ASSEMBLY
- 8-
Step 5
Put the 4pcs of the support
connector (9) onto the tops
of the 4 lower supports (7).
Step 6
Screw the 4 upper supports (8)
onto the 4 lower supports (7).
ASSEMBLY
- 9-
Step 7
Fit one piece of the glass tube (5)
into the glass tube fixed part (4)
on top of the base assembly (1).
Insert the glass tube connector (6)
into the glass tube piece already
attached to the base assembly and
then lower the second piece of
glass tube over the glass tube
connector.
Step 8
Attach the other glass tube fixed
part (4) to the upper plate (11)
with 3 pcs M4x8mm screws (21).
ASSEMBLY
- 10-
Step 9
Put the assembled upper
plate from Step 8 on top
of the assembled support
connectors and use 4pcs
M12 screws (15) to secure it.
Step 10
Attach 4pcs mesh guard (10)
on the lower support connectors.
NOTE: The long side will connect
with the base assembly.
ASSEMBLY
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Calentador de patio de Firesense
Firesense
Firesense FireSense 60697 Manual de usuario
Firesense
Firesense 60404 Manual de usuario
Firesense
Firesense FireSense 01775 Manual de usuario
Firesense
Firesense 60688 Manual de usuario
Firesense
Firesense 63057 Especificaciones rápidas
Firesense
Firesense Steel Pagoda Manual de usuario
Firesense
Firesense Mojave Sun IR 60253 Manual de usuario
Firesense
Firesense 60253 Manual de usuario
Firesense
Firesense DLX 46K Manual de usuario
Firesense
Firesense 60950 Manual de usuario
Firesense
Firesense 60255 Manual de usuario
Firesense
Firesense 61279 Manual de usuario
Firesense
Firesense Patio Heater Manual de usuario
Firesense
Firesense 1337 Manual de referencia técnica
Firesense
Firesense steel pagoda Manual de usuario
Firesense
Firesense PH08-SB Manual de usuario
Firesense
Firesense 60405 Manual de usuario
Firesense
Firesense FireSense 60696 Manual de usuario
Firesense
Firesense 60688 Manual de usuario
Firesense
Firesense PH03-SS Manual de usuario
