Option 1 - No LED Bar
Install the two M3 35mm alumi-
num standos. Install two M3
10mm nylon standos at center of
frame. Install four M3 10mm alu-
minum standos. All standos are
mounted using M3 6mm screws
from bottom side of frame
Option 2 - LED Bar Install
Replace the two nylon 10mm
strandos with the 10mm alumi-
num standos from the rear of the
frame.
Install the LED bar at the rear of
the frame.
Screw the two M3 6mm grub
screw (threaded rod) into the
10mm aluminum standos at front
of frame. The grub screws should
only be seated a maximum of
3mm into the stando.
Use a drop of blue thread lock on
the grub screw.
Locate the plastic camera mount
and position it on the frame with
the two M3 holes facing forward.
Place a washer on each M3 screw
prior to screwing the camera
mount in place from the bottom of
the frame.
4
