1
CAUTION! Read Carefully
• HEAVY Always use the handles to lift the Pelletizer. Check that the
power cord is disconnected before moving the unit.
• HIGH SPEED SHARP ROTATING BLADES Never operate the
Pelletizer without all of the components assembled closed and
secured. Never operate the Pelletizer if any parts appear missing or
damaged. NEVER ATTEMPT TO MODIFY OR BYPASS SAFETY
SWITCHES OR CIRCUITRY.
• BOLT TENSIONED BEARING ASSEMBLY Make sure the long
Allen head through-bolts securing the head are hand tight before
operation. Failure to do so can lead to improper operation or
damage. Tighten the bolts in an X pattern.Do not overtighten, this
could prevent the motor and cutter from turning.
• In Case of Emergency pull the power cord out of the machine.
• Only use the Pelletizer to process thermoplastic polymer filaments.
No other use has been tested or approved by Filabot.
• The Pelletizer is designed to process filament between 1mm to 3mm
in diameter. Inserting filament outside of these dimensions can
cause clogs or performance issues.
• Always STOP the Pelletizer and unplug the power cord before
opening or removing any components.
• The Pelletizer is designed for indoor use only. Operate in a clean,
dry area.
• Check the AC input voltage specified on the S/N Label near the
power inlet. Only use the specified input voltage to operate the
Pelletizer or damage to the components will occur.
• Do not use this device if any parts appear missing or damaged.
• Do not modify this device without authorization from Filabot.
Contact Filabot with any questions
1-802-505-6772
