PRELIMINARIES
IMPORTANT: FFEI Ltd products are so designed and constructed as to be safe without risk to
health when properly used (in accordance with the supplied documentation) and when the
safety precautions contained in this document are fully observed.
This manual must not be copied without prior written authorization and is subject to change
without notice. For further information, contact FFEI Ltd at the address given on the front page
of this manual.
WARNING: All precautions mentioned in this document must be strictly observed at all times.
Personnel must read the contents of any documentation supplied and used with this product
BEFORE commencing any work with equipment described in this document.
NOTE: Measured noise level for this product is less than 65 dBa.
CAUTION: FFEI Limited cannot be held responsible for any loss or damage to customer’s data
by unauthorised third parties accessing the system. In the event that FFEI Ltd becomes aware
of any computer virus which will or is likely to affect the system it will take reasonable steps to
bring this to the attention of customers but advises customers to take their own precautions
against unauthorised access.
TRADEMARKS and COPYRIGHT: Fuji and Fujifilm are trademarks of Fuji Photo Film Co., Ltd
that may be registered in certain jurisdictions; Luxel, Celix, FineScan, Celsis, C-dot, C-Scan,
Quattro, Lanovia, ColourKit and Celebrant are trademarks of FUJIFILM Corporation that may
be registered in certain jurisdictions; Adobe, Accurate, PageMaker, Illustrator, PostScript, Pho-
toshop and Type Manager are trademarks of Adobe Systems Inc. that may be registered in
certain jurisdictions; Microsoft and Windows are either registered trademarks or trademarks
of Microsoft Corporation in the United States and/or other countries; all other company names,
products or brand names are trademarks of their respective holders.
The manual was written and illustrated using the best possible information at the time of pub-
lication. Any differences between the manual and equipment reflect improvements intro-
duced after publication of the manual. Changes, technical inaccuracies and typographic
errors will be corrected in subsequent editions. As part of our policy of continuous improve-
ment, we reserve the right to alter design and specifications without further notice.
For installations with a nominal line voltage greater than 220 V and a frequency of 50 Hz: The
equipment is intended for use in premises having a service current capacity of >= 100 A per
phase. The user should determine in consultation with the supply authority, if necessary, that
the service current capacity at the interface point (ie building entry) is sufficient for the
equipment.
