Fenix TK65R Manual de usuario

Fenix TK65R Flashlight

1. Catapult action belt clip

2. Quick-release button

Technical Parameters

ANSI/PLATO

FL1

General Mode

Flash Mode

Turbo

High

Med

Low

Eco

Strobe

SOS

Output

3,200

Lumens

1,000

Lumens

400

Lumens

150

Lumens

3,200

Lumens

400

Lumens

Runtime

1h 45min

4h 55min

13h

10min

35h 45min

113h

Distance

375m

218m

138m

83m

37m

Intensity

35,155

11,880

4,760

1,720

340 cd

Impact

Resistance

Waterproof

IP68, underwater 2m

Note: The abovementioned parameters (lab-tested by Fenix using 7.2V/5000mAh Li-ion battery

pack) may vary between flashlights, batteries and environments.

Cree XHP70 LED with a lifespan of 50,000 hours

Built-in 7.2V/5000mAh Li-ion battery pack

Micro USB fast charging with fast charging adaptor

Micro USB charging port with inner waterproofing design

270.5mm Length x 61.5mm Head diameter x 36.5mm Body diameter

418g (excluding battery and belt clip)

Dedicated catapult action belt clip

Digitally regulated output maintains constant brightness

Featuring battery level indication and low-voltage warning function

Intelligent overheat protection protects from high surface temperature

Made of durable aircraft-grade aluminum; stainless steel strike bezel

Premium type III hard-anodized anti-abrasive finish

Toughened ultra-clear glass lens with an anti-reflective coating

Accessories:

7.2V/5000mAh Li-ion battery pack

Spare O-ring

Micro USB charging cable

USB adaptor

Catapult action belt clip

Operation

Switches

①Master switch: controls on/off and output selection in General mode

②Auxiliary switch: controls on/off and output selection in Flash mode

ON: With the light switched off, press and hold the Master switch for 0.5 seconds to enter

General mode, press and hold the auxiliary switch for 0.5 seconds to enter Flash mode.

OFF: With the light switched on, press and hold either the master or auxiliary switch to turn off

the light.

Mode Selection

In General mode, single click the auxiliary switch to change to Flash mode.

In Flash mode, single click the master switch to change to General mode.

Output selection

In General mode, single click the master switch to cycle through Eco→Low→Med→High→Turbo.

In Flash mode, single click the auxiliary switch to cycle through Strobe→SOS.

③Lock-out Function

Lock: with the light unlocked, simultaneously press and hold the two switches for over 3 seconds.

Light will switch off and 2 one-second blinks will indicate locked status.

Unlock: with the light locked, simultaneously press and hold the two switches for over 3 seconds.

The light will be unlocked and activated on last used brightness.

In locked status, pressing any switch will activate 2 one-second blinks to indicate locked status.

Intelligent Memory Circuit

The light memorizes the last selected brightness level on General mode. When turned on again

the previously used brightness level will be recalled.

Intelligent Overheat Protection

The light will accumulate a lot of heat when used on Turbo output level for extended periods.

When a temperature of 65°C or above is reached, the light will automatically step down by a few

lumens to reduce temperature. When the temperature is reduced, the output will gradually

return to Turbo output level.

④Battery Level Indication

There are four LED’s in the light tail. Single clicking the round switch on the tail will indicate

remaining battery level for 3 seconds:

The more LED’s light up, the higher the battery level.

Four LED’s on: more than 80%;

Only one LED on: more than 20%

One LED flashing: less than 20%

Low-voltage Warning

When the voltage level drops below the preset level, the flashlight is programmed to downshift

to a lower brightness level until Eco output is reached. When this happens in Eco output mode,

the flashlight blinks three times every five minutes to remind you to replace the battery. To

ensure normal use, the flashlight will only turn off once the battery over-discharging protection

activates.

⑤Charging

First plug the USB terminal of the charging cable into an electrical outlet, then connect the Micro

USB terminal of the charging cable to the light. The LED indicators will flash in sequence while

charging, and will turn to constant on when fully charged. The normal charging time is

approximately 4 hours.

Note:

1. Once charging is completed, be sure to close the anti-dust cover.

2. Recharge a stored light every four months to maintain optimum performance of the battery.

⑥Battery Replacement

Unscrew the tail cap to insert the battery (no need to check the polarity), then screw the tail

cap back on. Remove the insulation sheet before first use.

Usage and Maintenance

Disassembling the sealed head can cause damage to the light and will void the warranty.

Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring

with an approved spare．

Periodic cleaning of the battery contacts improves the lamp's performance as dirty contacts

may cause the lamp to flicker, shine intermittently or even fail to illuminate for the following

reasons:

A: The batteries need replacing.

Solution: Replace batteries (Ensure batteries are inserted according to the manufacturer’s

specifications).

B: The threads, PCB board contact or other contacts are dirty.

Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.

If the above methods don't work, please contact your authorized distributor.

Warning

This flashlight is a high-intensity lighting device capable of causing eye damage to the user or

others. Avoid shining the flashlight directly into anyone’s eyes.

Tabla de contenidos

Otros manuales de Flash de Fenix

Manuales populares de Flash de otras marcas

StreamLight

StreamLight PROPOLYMER 2AA Manual de usuario

StreamLight

StreamLight Stinger Manual de usuario

Silverline

Silverline 994024 Manual de usuario

Gama Sonic

Gama Sonic 23i60065 Manual de usuario

Olympia

Olympia RG580 CREE XM-L2 Manual de usuario

EUFAB

EUFAB 13495 Manual de usuario

OLIGHT

OLIGHT S35 BATON Manual de usuario

Kopp

Kopp Emergency Sensor Light Manual de usuario

YLP

YLP PROFESSIONAL Series Manual de usuario

Light motion

Light motion GoBe Manual de usuario

MOB

MOB MO8622 Manual de usuario

EuroLite

EuroLite KKS-3 Manual de usuario

Carson

Carson 500907010 Manual de usuario

Duracell

Duracell 550 Manual de usuario

Mactronic

Mactronic Black Eye 1300 Manual de usuario

Eurotops

Eurotops 29780 Manual de usuario

MOB

MOB MO8690 Manual de usuario

Pelican

Pelican L1 1930 LED Manual de usuario