Table of Contents
Introduction..........................................................................................................................................5
Physical Layout....................................................................................................................................6
USB Port Control.................................................................................................................................6
Serial Port Control................................................................................................................................7
Capture Commands..........................................................................................................................8
CaptureDark - Store Dark Level......................................................................................................9
CaptureDark## - Store Dark Level................................................................................................10
Capture - Store Display Data.........................................................................................................11
Capture# - Store Display Data.......................................................................................................12
CaptureContrastHigh - Store High Contrast Data.........................................................................13
CaptureContrastLow - Store Low Contrast Data...........................................................................14
Get Data Commands...........................................................................................................................15
Under Range Condition.................................................................................................................15
Over Range Condition...................................................................................................................15
GetAverage - Get the number of Captures to Average..................................................................16
GetChannelStatus - Get the status of connected Channels............................................................17
GetLuminance## - Get the Luminance value for a Channel.........................................................18
GetLuminanceAll - Get the Luminance of all Fibers....................................................................19
GetContrastRatio## - Get the Contrast Ratio for a Channel.........................................................20
getxy## - Return the xy Chromaticity values................................................................................21
getxoffset## - Return the x Chromaticity offset............................................................................22
getyoffset## - Return the y Chromaticity offset............................................................................23
getuv## - Return the u'v' Chromaticity values...............................................................................24
getWavelength## - Get the Dominant Wavelength.......................................................................25
getWavelengthOffset## - Get the Dominant Wavelength Offset..................................................26
getAbsInt## Get the Absolute Intensity Value of the Display under test......................................27
getFactor - Get the exposure Factor...............................................................................................28
getFormat - Get the format of the data..........................................................................................29
getCCT - Get Correlated Color temperature..................................................................................30
getxxxALL Get the data for ALL Channels on the Analyser........................................................31
Set Commands....................................................................................................................................32
SetAVERAGE - Set the number of Captures to Average.............................................................33
SetEngineeringFormat - Set the Data format to Engineering........................................................34
SetScientificFormat - Set the Data format to Scientific................................................................35
SetFACTOR## - Set the Exposure Factor.....................................................................................36
setXOFFSET##0.xxx - Set the x Chromaticity Offset..................................................................37
setYOFFSET##0.yyy - Set the y Chromaticity Offset..................................................................38
setWAVELENGTHOFFSET@@±## - Set the wavelength Offset..............................................39
User Calibration..................................................................................................................................40
setCalibration# - Set the Calibrationto a particular Set.................................................................41
getCalibration - Returns the Calibration Set Number....................................................................42
"
