06 Fearne By Swan
HOW TO USE THE JUG KETTLE
Before using the kettle for the first time, fill to the max mark and boil,
then discard the boiled water and rinse the kettle out with cold water.
1. Position the power base as close to a wall socket as possible.
2. Remove the kettle from the power base. If the switch has been
pushed down inadvertently, it will spring up, into the “OFF”
position.
3. Caution: If water inside the kettle has just boiled, it will be full of
steam, which will escape as soon as the lid is opened.
4. Open the lid and fill the kettle via the lid aperture. Watch the level
in the water level indicator. You must use at least one cup of water,
but the water level must be below the max mark.
5. Caution: Do not overfill the kettle.
6. Close the lid. Checking that it is fully closed.
7. Check that the switch is in the “OFF” position before plugging the
power base into the wall socket. Gently position the kettle on the
power base, and switch on the wall socket.
8. Press the switch down. The switch will light up, and the kettle will
start to heat up.
9. When the water has boiled the kettle will switch off automatically,
the switch will return to the “OFF” position and the light will go out.
10. To avoid the risk of splashing, pour slowly and do not over-tilt the
kettle.
11. If you need to switch the kettle off at any time before the water
boils, simply lift it from the power base and set it down again. The
switch will pop up, into the “OFF” position.
IMPORTANT SAFETY NOTES
When you lift the kettle from the base, you may see moisture on the
surface of the base. This is the steam used to switch the kettle off
automatically, which then condenses and is allowed to escape via vents
in the underside of the kettle, do not lift it backwards, as this may
allow water to pass through the steam aperture on to the control area.
SK34030 Fearne By Swan 1.7 Litre Jug Kettle IM.indd 6 16/06/2017 15:54
