ELECTRONICS
FCI Electronics Manual Part No. 412905-000
Issued: 10/19/94 Page 6of 9
Rev. 02/22/01 ECR V10315 Revision B
K\DCU\Manuals
MAINTENANCE
The HT-1038A style hand tool is designed to be maintenance free under normal operational
conditions. However, a need may arise to perform an adjustment or to replace the punch.
Position Locator Adjustment
Follow these procedures to adjust position locator (see Figure 6). Use a straight bladed
screwdriver to adjust the position locator (see Figure 7). Place a connector in the hand tool. Turn
the screw until the connector moves freely end to end without excessive play. The locator will
position the connector properly for wire termination.
Figure 6 Figure 7
Punch Removal
Following are the steps to remove the punch from the hand tool.
1. Using a straight-bladed screwdriver and holding the nut, remove the 0.8mm screw from the
hand tool (see Figure 8). This will allow the punch to rotate free of the hand tool (see Figure 9).
Figure 8 Figure 9
Punch Removal continued:
PDM: Rev:B ReleasedSTATUS: Printed: Jan 14, 2004
