FastCap ChopShop Guía de inicio rápido
FastCap LLC • 888-443-3748 • www.fastcap.com
WE INNOVATE
Assembly and mounting
instructions for the
ChopShop Saw Hood
Remove ChopShop Saw
Hood and aluminum poles
from box.
Insert 1/2” roll pipe into
accessory holes in mitre saw.
Some accessory holes are
1/2” or 5/8” in diameter. If
there is a little movement
this should not be a
problem.
Insert the aluminum pole in
the peacock tail and tighten
knob.
1 3
2
We recommend that you
place a trash can or box under
the ChopShop Saw Hood,
which allows the dust and
debris to collect in one spot.
You can also mount the
ChopShop Saw Hood to a
table. Two mounting holes on
each peacock tail will accept
standard wood screws.
56
Unstrap the 3 Velcro hood
wraps and let the saw hood
fall into position.
4
STOP
All miter
box saws
are not the
same
Some small modifications
to the Saw Hood may
be necessary, allowing it
to fit into the accessory
mounting holes on each
individual saw. These
modifications are generally
limited to:
1. Grinding
a corner off
the aluminum
mounting arm
where the
round 3” post
attaches.
2. Making a
bushing out of
a 1/2 copper pipe
allowing the 3”
mounting post to
fit into the larger
diameter accessory
holes.
FastCap LLC • 888-443-3748 • www.fastcap.com
WE INNOVATE
Assembly and mounting
instructions for Tile
Clamp accessory
To use Tile Clamp accessory:
• Drill holes into the stand or table with the drill bit that is
included. Use at least two of the screws that are included
with each clamp to secure it in place (C).
• Adjust accessory hole (A) to an upright position and clamp
down using handle (B).
• Now, simply place the ChopShop Saw Hood accessory rods
(D) into the accessory hole on tile clamp. Now you are ready
to go.
AD
B
C
Otros manuales de Sierra de FastCap
