Farouk COLORMASTER LGCHI-01G Manual de usuario

CHILGM

Owner’s Manual

Before operating the appliance, please read these instructions

carefully and keep them for future reference.

Original Instructions

HAIR COLOR MIXING FACTORY

FAROUK SYSTEMS, INC.

250 PENNBRIGHT DR.

HOUSTON, TEXAS 77090

TEL: 281-876-2000

MFG: LG Farouk Co.,

2806, Nambusunhwan-ro

Gangnam-gu, Seoul

Republic of Korea

Authorized Representative:

Farouk Systems Europe, B.V.

De Brand 40, 3823 LL

AMERSFOORT

The Netherlands

TEL: +31 (0) 33 204 82 48

UK Responsible Person

(Obelis UK Sandford Gate

East Point Business Park

Oxford

OX4 6LB

United Kingdom)

CHI.COM

SPECIFICATIONS

HARDWARE

Power Module / Motor and Rotation Module / Control Units /

Canister’s installation units / Basket / Sensor module / Case

MACHINE MODEL: LGCHI-01G

POWER:

INPUT: 100 ~ 240 V 50/60 Hz, 2.5A

OUTPUT: 24V 8.4A

Weight: 91.5 lbs. / 41.5 Kg

Dimension: 18 X 20 X 21.5 in. / 46 X 51 X 55 cm

Canister: 12 canisters (10 colors, 2 peroxide)

Cable Length: 1.5m

Operation temperature: 32 ~ 104 °(0 ~ 40°)

Motor speed auto adjustable based on canister’s condition

SENSORS

Load Cell: Weight sensor till 1.1 lbs. / 500g

IR Sensor: Bowl detection

Tact switch: Door open detecting

R / Z Axis sensor: Motor rotation / location detection

CONTROLLER TABLET

Display: 10.3” IPS Full HD, 16:10

Camera 5MP for Front

OS: Android 9.0

SOFTWARE

Color Formulator : Simulation App

Play Store - Android 7.0 Over App Store - iOS 10.2 Over

COLOR MASTER : Dispenser App

. Android Only available

: Without Dispenser system does not support operation.

FCC Compliance Statement (for products subject to Part 15 subpart B)

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including

interference that may cause undesired operation.

English

IMPORTANT SAFETY INSTRUCTIONS

WARNING: THE LG CHI COLORMASTER FACTORY IS AN ELECTRICAL

APPLIANCE AND SHOULD NEVER BE USED OR HANDLED BY ANYONE

UNDER THE AGE OF 18, INCLUDING ANY PERSON WITH A DISABILITY,

LIMITED MOBILITY, OR A VISUAL IMPAIRMENT. MINORS SHOULD NEVER

USE OR TURN ON THIS DEVICE UNLESS UNDER THE SUPERVISION OF

SOMEONE OVER THE AGE OF 18.

BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED WHEN

USING ELECTRIC APPLIANCES, INCLUDING THE FOLLOWING:

KEEP AWAY FROM WATER: AS WITH MOST ELECTRICAL APPLIANCES,

ELECTRIC PARTS ARE ELECTRICALLY LIVE WHEN SWITCH IS OFF.

TO REDUCE THE RISK OF INJURY OR DEATH BY ELECTRIC SHOCK:

1. IF USING ELECTRICAL APPLIANCE NEAR WATER, INSTALL GFCI

OUTLETS IN ALL ELECTRICAL OUTLETS INTO WHICH

ELECTRICAL APPLIANCE WILL BE PLUGGED.

2. DO NOT PLACE OR DROP INTO WATER OR OTHER LIQUIDS.

3. AVOID USING THE APPLIANCE IN OR NEAR WATER.

WARNING: TO REDUCE ELECTROCUTION, FIRE OR INJURY TO

PERSONS:

1. USE THIS APPLIANCE ONLY FOR ITS INTENDED USE AS

DESCRIBED IN THIS MANUAL.

2. NEVER OPERATE THIS APPLIANCE IF IT HAS A DAMAGED CORD

OR PLUG.

3. NEVER ALLOW THE POWER SUPPLY CORD TO BE PULLED,

JERKED, STRAINED, TWISTED, OR SEVERELY BENT, ESPECIALLY

AT THE PLUG CONNECTIONS. THE FOREGOING MAY DAMAGE

THE CORD, INCLUDING AT OR NEAR THE HIGH FLEX POINT

OF ENTRY INTO THE APPLIANCE, CAUSING IT TO RUPTURE AND

SHORT. HANDLE THE CORD CAREFULLY FOR LONGER LIFE.

English

DESCRIPTION

4. KEEP THE CORD AWAY FROM HEATED SURFACES. DO NOT WRAP

THE CORD AROUND APPLIANCE.

5. DO NOT USE OUTDOORS OR OPERATE WHERE AEROSOL SPRAY

PRODUCTS ARE BEING USED OR WHERE OXYGEN IS BEING

ADMINISTERED.

6. DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.

7. DO NOT OPERATE WITH VOLTAGE CONVERTER.

8. IF APPLIANCE IS NOT WORKING PROPERLY CALL CUSTOMER

SERVICE FOR EXAMINATION BY A TECHNICIAN AND POSSIBLE

REPLACEMENT UNDER WARRANTY.

9. DO NOT LEAVE APPLIANCE IN HUMID PLACES.

10. KEEP ANY OPENINGS FREE OF LINT, HAIR AND THE LIKE.

11. DISCONTINUE USE IMMEDIATELY AND UNPLUG IF APPLIANCE

EVER BECOMES TOO HOT OR MALFUNCTIONS IN ANY WAY.

English

DESCRIPTION

1. Tablet Power & Signal Cable

2. Tablet

3. Basket

4. Basket Door

5. Bowl Scale

6. Foot

7. Machine Power Cable

8. Main Power Switch

9. Canister Mounting Handle

10. Canister Holder

11. Side Door

12. Drip Tray

13. Center Tray

English

INSTALLATION FOR THE DISPENSER

1) COLOR FACTORY UNBOXING

1. Remove all of the packing foam & shipping wraps from the Color factory.

2. Plug the power cord into the main power source at the back of the

machine.

2) TABLET INSTALLATION

1. Take out the tablet from the tablet box.

2. Open the right hand side door, and then place the tablet in the front

window area.

3. Gently mount the tablet using the mounting screw.

4. Plug the charging cable into the tablet.

5. Close the right hand side door.

6. Open the left hand side door, then push power button on the top of

tablet to turn it on.

3) SET UP THE WI-FI

1. Make sure the router is on to secure Wi-Fi connection

2. Swipe down twice on upper screen to access Wi-Fi button

3. Select and hold Wi-Fi button

4. Then, select Wi-Fi network to connect to dispenser

1. 3.

INSTALLATION FOR THE DISPENSER (CONT.)

English

4) SET UP THE DISPENSER

1. Power on the main switch at the back.

2. The color master application will start automatically.

Notice: If it does not start automatically, make sure that the tablet power

cable is plugged in

INSTALLATION FOR THE DISPENSER (CONT.)

5) INITIAL INSTALLATION OF CANISTERS

1. In the COLOR MASTER application, go to MANAGEMENT tab

2. Select REPLACE to install canister

*The selected canister will move to the left side door

3. Open the left side door and pull the canister mounting handle out then

lift up

4. Match the nozzle to the slot in the canister holder and insert canister

(see picture 4)

5. Pull down and push in the canister mounting handle

6. Close the door and select YES that the canister has been replaced

7. Repeat steps 2-6 for all 12 canisters

8. Select CALIBRATION once all canisters have been installed

*Calibration tab will be flashing

9. In the calibration window, all of the canisters should be automatically

check marked. If not, select the ALL checkbox.

Select START to begin cleaning.

10. Select OK once cleaning is completed

NOTICE: Do not use a clear or transparent bowl for cleaning. If a bowl is not on the scale,

a prompt will appear.

WARNING:For safety reasons, rotation will not take place with an open door.

Close the door after each replacement/new position.

Do not shake the machine or the dispenser may be damaged while calibrating.

3. 4.

English

6) INITIALIZING THE MACHINE

1. In the COLOR MASTER application, go to MANAGEMENT tab

2. Select INITIALIZE POSITION tab

NOTICE: Do not place a bowl on the scale plate. If a bowl is on the scale, a

prompt will appear.

Do not open the door while in Initializing mode.

SETTINGS

1. GENERAL

a) Select SETTINGS

b) Select GENERAL

1. 4.

6. 7.

English

2. Machine Name

- Machine NAME is editable to recognize dispensers, if there are

multiple machines in same area.

a. To access the menu bar, swipe down twice on upper screen.

b. Press and hold Bluetooth Icon.

c. Under Connection Preference, select Bluetooth.

d. Press device name and rename to your preference.

e. Swipe up on the bottom bar and select the application to check

that the machine name has been updated.

LANGUAGE: Confirm or check language. The voice guide also changes

based on the voice/language selected. To change the language for the

+ADD COLOR FORMULATION screen, see Administration Options under

Advanced Settings.

UNIT: Select grams or ounces

CLEANING AMOUNT: Determine how many grams to dispense from each

can for cleanings. The recommended standard amount for each can will

be preset.

SERVER API: Data connection to server

AUTO CLEANING TIMING: Select frequency for Scheduled Automatic

Cleaning alert

Recomendations:

For a smaller salon, schedule your cleanings more frequently to avoid

any build up in the canisters. Every 1-3 days

For a larger salon, you can schedule your cleanings less frequently.

Once or twice, a week.

OPENING HOUR: Set up to your opening business hours and the

Scheduled Automatic Cleaning alert will appear at this time

LOG DATA SYNC: Sync the log data between machines

SAVE LOGS: Manually upload logs of the dispensing history

SAVE BACKUP: Back up the dispensing history and settings manually.

LOAD BACKUP: Load the dispensing history and settings.

English

3. ADVANCED

Warning: Changing advance settings may interfere with operation of

dispensing. This should only be accessed by the business

administrator or salon manager

1) ENTER THE PASSWORD TO ACCESS:

NOTICE: If you forget the password, call the Customer Service Center. Security

questions will be asked to confirm the assigned personnel to machine.

A. RESET ADMINISTRATOR PASSWORD

B. DISPENSING MESSAGE PARCELING

C. PARAMETER SETTINGS

D. SCALE CALIBRATION

E. SECURITY INFORMATION

F. MACHINE MODE

d. e.

a.b. c.

English

Tabla de contenidos

Idiomas:

Otros manuales de Peinador de cabello de Farouk

Farouk

Farouk GF8269 Manual de usuario

Farouk

Farouk CHI GF8482EU Manual de usuario

Farouk

Farouk CHI LUXURY GF8409EU Manual de usuario

Farouk

Farouk CHI G2 1 1/4 Manual de usuario

Farouk

Farouk CHI G2 GF1595AEU 1C Manual de usuario

Farouk

Farouk CA2204 Manual de usuario

Farouk

Farouk CHI GF8280 Manual de usuario

Farouk

Farouk CHI CA2168 Manual de usuario

Farouk

Farouk CHI BIOSILK CA2378 Manual de usuario

Farouk

Farouk CHI BIOSILK G2 Manual de usuario

Farouk

Farouk CHI CA2377 Manual de usuario

Farouk

Farouk CHI LUXURY GF8508 Manual de usuario

Farouk

Farouk CHI BIOSILK CA2306 Manual de usuario

Manuales populares de Peinador de cabello de otras marcas

Philips

Philips HP8309 Manual de usuario

Eldom

Eldom bess HTS20 Manual de usuario

Lunata Hair

Lunata Hair LH24HR Instrucciones originales

Conair

Conair S3CSC Manual de usuario

Remington

Remington CI89H1 Manual de usuario

Dyson

Dyson Airwrap Manual de usuario

Braun

Braun Satin Hair 1 AS 110 Guía rápida

REVAMP Professional

REVAMP Professional iGEN PROGLOSS CL-2750 Manual de usuario

Vitek

Vitek VT-2285 Manual de usuario

point

point WAVE VIXEN TRIPLE WAVE MAKER Manual de usuario

Braun

Braun Satin Hair 5 Manual de usuario

Philips

Philips beauty Airstylist quattro 600 Manual de usuario

Grundig

Grundig HS 7230 Manual de usuario

Philips

Philips HP4658/08 Manual de usuario

Remington

Remington AS7100 Manual de usuario

Vitek

Vitek VT-2296 BK Manual de usuario

HOT TOOLS

HOT TOOLS SIGNATURE Series Guía de instalación

Conair

Conair INFINITI INFCS25C Manual de usuario