Fantech PHS300 Manual de usuario
Your Fantech HEPA Filtration system should be installed in conformance with the appropriate local, provincial or state
requirements or in the absence of such requirements with the current edition of the National Building Code, and / or
ASHRAE’s “ Good Engineering Practices”.
Fantech reserves the right to modify, at any time and without notice, any or all of its products’ features, designs,
components and specifications to maintain their technological leadership position.
Please visit our website www.fantech.net for more detailed technical information.
United States
Lenexa, KS, 66215
Tel.: 800.747.1762
Canada
Bouctouche, NB, E4S 3M5
Tel.: 800.565.3548
PHS300
Portable Filtration Unit
Installation and Operation Manual
Item #: 463912
Rev Date: 2022-05-12
PARTS IN THE BOX
Portable PHS300, 1 pc
Power cord, 5 ft, 1 pc
REPLACEMENT FILTERS
#463046 - Replacement Pre-Filter with Carbon, 1 pc
#463048 - Replacement HEPA Filter, 1 pc
2
fantech
Note Warning/
Important
note
Information Technical
information Practical tip
PLEASE READ THIS MANUAL BEFORE INSTALLING UNIT
This product is designed and manufactured
to provide reliable performance. Sometime
even most reliable products will experience
occasional failures, and this possibility should
be recognized by the user.
If these products are used in a life support
ventilation system where failure could result
in loss or injury, the user should provide
adequate back-up ventilation, supplementary
natural ventilation or failure alarm system, or
acknowledge willingness to accept the risk of
such loss or injury.
Your Fantech HEPA Filtration system should be
installed in conformance with the appropriate
local, provincial or state requirements or in the
absence of such requirements with the current
edition of the National Building Code, and/or
ASHRAE’s “Good Engineering Practices”.
LIMITATIONS: The product is for residential
applications only. Must be installed in accord-
ance with all national and local regulations,
building and safety codes.
CAUTION:
TURN OFF ALL INTEGRAL DISCONNECTS
BEFORE SERVICING
Prior to installing, serious consideration must be taken to insure this ltration system will operate
properly if integrated to any other type of mechanical system, i.e. a forced air system, or an air
handling unit. To insure proper operation & compatibilities of both system, it is required that you
follow the instructions in this manual.
3
fantech
Table of Content
INTRODUCTION..............................................................................4
SPECIFICATIONS .............................................................................4
INSTALLATION ..............................................................................4
GENERAL OPERATION INFORMATION ..............................................................5
MAINTENANCE .............................................................................6
REPLACEMENT FILTER ........................................................................6
MAINTENANCE SCHEDULE .....................................................................7
PARTS LIST ...............................................................................16
4
fantech
Introduction
Specification
Installation
Filtration Stage 1 & 2 Pre-Filter with Carbon (#463046)
Filtration Stage 3 HEPA Filter (# 463048)
Weight 28 lbs (12.7 kg)
Plenum Mount Port Opening 16" x 3.5" (406 mm x 89 mm)
Installtion Type Plenum, Wall* or Floor* Mounted
Electrical Supply 120VAC @ 60 Hz
Power Consumption 134W
Certication cCSAus
Airow (low/high speed) 170/240 cfm
WHEEL ASSEMBLY
HEPA AIR FILTRATION SYSTEMS
You have purchased a very effective air cleaning and treatment system
incorporating HEPA (High Efciency Particulate Arrestance) lter
technology. This is the type of air cleaning equipment that respiratory
specialists recommend most.
To optimize the performance of your HEPA Filtration System, it should be
maintained on a regular basis.
5
fantech
DOOR SWITCH
MODE SELECTOR
• II (240 CFM)
• I (170 CFM)
OPERATIONS
Maximum Filtration
(240 cfm)
Normal Filtration
(170 cfm)
FUNCTION
The Whole House HEPA system is comprised of
a ventilator, speed selection switch,
3 stages of ltration and the cabinet enclosure
system. The ventilator pulls air through the
pre-lter and then threw the impregnated carbon
pad for odor control and nally the last stage
of ltration is the HEPA lter which removes
99.97% of particles 0.3µm in size.
OPERATION MODE OPTIONS
The unit features two speeds of operation for
your convenience. The speed selection switch
is located on the front of the motor assembly.
At lowest speed the unit will provide 170 CFM
of clean air while at highest speed, the unit will
provide 240 CFM of clean air. It is recommended
that the unit be operated on highest speed
at all times to maximize the benets of the
HEPA ltration system. If for some reason the
ltration needs are not
as important then one
might operate the unit at
low speed.
An access door is
provided at the front
of the unit to permit
access to the lters and
speed selection switch. Opening the latch on the
right side of the unit will permit the door to swing
open. A safety door interlock switch cuts the
power to the motors for your safety. If needed
the door can be removed from the cabinet hinges
by holding the top part of the door with one hand
and gently taping on the bottom edge of the door
with the other hand to release the door from its
hinges.
General Operating Information
6
fantech
General Maintenance Information
WHEN SHOULD I SERVICE
MY UNIT?
SERVICE AND ACCESSORIES
Detailed maintenance information is located on the
front decal on motor plate.
PRE-FILTER WITH CARBON (463046)
Replace lters every 3 to 6 months or as needed.
HEPA FILTER (463048)
Replace lter every 2 to 5 years or as needed.
Check regularly to maintain maximum performance
from your
HVAC system.
For replacement lters, contact your local HVAC
contractor.
INSIDE THE UNIT
Once a year or as needed, clean the interior of the
unit (Wall and Motor Plate) with a mild and non-
abrasive soap. It is recommended to use products
that are environmentally friendly.
CHANGING FILTERS
After opening the unit’s
door, grasp both edges of
lter and pull with equal
force to slide out the
lter.
CLEANING
Once a year or as needed,
clean the interior of the
unit (Wall and motor
plates) using mild non-
abrasive soap and water.
It is recommended to
use products that are
environmentally friendly.
Tips to homeowner/installer
ALWAYS UNPLUG UNIT
BEFORE SERVICING
TROUBLESHOOTING
TROUBLESHOOTING SUGGESTIONS
Unit does not operate • Is power cord fully inserted in the unit’s
connector?
• Is outlet powered?
• Is door interlock switch operating?
Unit operates only on one speed. Possible loose wire inside electrical box, contact
you local contractor.
Unit vibrates Check for excessive dust build up or missing
balancing weight on the impeller wheel.
ELECTRICAL WIRING DIAGRAM
7
fantech
Warranty
• The maintenance free motors are
permanently lubricated and are
guaranteed for 7 years. They are
factory balanced to prevent
vibrations and promote silent
operation.
• All other components have a 5 year
limited warranty. (filters not included)
• The limited warranty covers normal
use. It does not apply to any defects,
malfunctions or failures as a result
of improper installation, abuse,
mishandling or misapplication,
fortuitous occurrence or any other
circumstances outside
manufacturer's control.
• The warranty is in effect for 5 years
on parts and 7 years on the motor
after the date of purchase, including
parts replaced during this time
period. If there is no proof of
purchase available, the date
associated with the serial number
will be used for the beginning of the
warranty period. Parts are a 1 year
warranty when replaced after the
initial warranty has expired.
• This warranty is the exclusive and only
warranty in effect and all other
warranties either expressed or
implied are invalid.
• Warranty from the manufacturer is
for parts only and does not include
labor or shipping to service or repair
them.
Maintenance
Date Type of Service performed Service Technician
Maintenance of the unit should be performed at regular interval to keep the benets of the HEPA ltration unit.
Schedule
8
fantech
Votre système de filtration HEPA de Fantech doit être installé conformément aux exigences de la municipalité, de la province
ou de l’État où vous habitez ou, à défaut de telles exigences, conformément à l’édition actuelle du Code national du bâtiment
du Canada ou aux « méthodes d’ingénierie appropriées » de l’ASHRAE.
Fantech reserves the right to modify, at any time and without notice, any or all of its products’ features, designs,
components and specifications to maintain their technological leadership position.
Please visit our website www.fantech.net for more detailed technical information.
United States
Lenexa, KS, 66215
Tel.: 800.747.1762
Canada
Bouctouche, NB, E4S 3M5
Tel.: 800.565.3548
PHS300
Unité de filtration portable
Manuel d'installation
No. d'article: 463912
Date de rév.: 2022-05-12
PIÈCES DANS LA BOÎTE
Système de filtration d'air PHS300, 1 pc
Cordon d'alimentation, 5 pi, 1 pc
FILTRES DE REMPLACEMENT
#463046 - Filtre de remplacement, Préltre avec carbone 1 pièce
#463048 - Filtre de remplacement HEPA, 1 pièce
10
fantech
Note Warning/
Important
note
Information Technical
information Practical tip
VEUILLEZ LIRE LE PRÉSENT MANUEL AVANT D’INSTALLER L’APPAREIL
Les produits sont conçus et fabriqués pour
fournir une performance able, mais ils ne sont
pas garantis à 100% sans défaut. Même les
produis ont des pannes occasionnelles et cette
possibilité devrait être reconnue par l'utilisateur.
Si ces produits sont utilisés dans un système
de ventilation qui maintien des fonctions vitales
où une défaillance pourrait entraîner des pertes
ou des blessures, l'utilisateur doit fournir une
ventilation de secours adéquate, une ventilation
supplémentaire naturelle, un système d'alarme
de défaillance ou d'accepter les risques de
pertes ou de blessures.
Votre système de ltration HEPA de Fantech
doit être installé conformément aux exigences
de la municipalité, de la province ou de l’État où
vous habitez ou, à défaut de telles exigences,
conformémentàl’éditionactuelleduCodenational
du bâtiment du Canada ou aux « méthodes
d’ingénierie appropriées » de l’ASHRAE.
LIMITATIONS: Le produit est destiné
uniquement aux applications résidentielles.
Doit être installé conformément à toutes les
réglementations nationales et locales, ainsi
qu'aux codes du bâtiment et de sécurité.
MISE EN GARDE:
ÉTEIGNEZ TOUS LES DÉCONNEXIONS IN-
TÉGRALES AVANT L'ENTRETIEN
Avant de procéder à l’installation, examinez avec soin la façon dont le système fonctionnera s’il
est relié à tout autre appareil mécanique, notamment une fournaise à air pulsé ou un appareil de
traitement d’air dont la pression statique est plus élevée.
Tabla de contenidos
Idiomas:
Otros manuales de Purificador de aire de Fantech
