1102 Center Street • West Fargo, ND 58078
1-800-333-2314 fsmfg.com
6. INSTALL LINKS & MANIFOLDS: Install
Manifold Links each with two 5/16”
Bolts, four 5/16” Flat Washers and two
5/16” Nuts. (Be sure the link is on the
correct side of the tab as shown in the
image to the right) Next, slide one Band
Clamp on each end of the Manifold
Supply hose and position Manifolds as
shown. Connect hose to Manifold and
tighten Band Clamp to secure. (Make
sure that the Manifolds are positioned
so the pin holes are directed toward the
rollers.) Slide the Roller Arms to secure
the Manifolds (as shown in the top left
image above).
(At this point it is best to tighten up all the connections that have been made thus far)
7. INSTALL LIFT ARMS & TIRES: Install Lift
Arms as shown in Image above using one
1/2” Washer and one 1/2” Lock Nut. (Note:
Overtightening nuts will make arms dicult
to move.) Next, slide Axle Bushings on axles
as shown in Image 7a. Finally, install tires
as shown in Image 7b using one 5/8”Lock
Nut.
8. INSTALL HITCH: Install (1) 5/16”
Nut on each of the two remaining
5/16” Bolts and loosely screw them
into the nuts on the Mounting Frame
as shown in the image to the left.
Adjust height as needed for your
application.
1. Pour in chemical and water with the valve handle in the closed position.
2. Open valve to allow liquid to drip at desired rate.
3. Drive unit a maximum speed of 5 mph while applying chemical. When roller is
raised, the unit may travel up to 15 mph.
We recommend that only Amine based products such as MCPA or 2,4-D be used on yards.
As a starting point, we recommend mixing 1 to 2 ounces of chemical for each gallon of
water used. Always follow chemical label instructions!
Operating Instructions:
Should you need spare parts or help with your Dandelion
Killer please call us and we will do everything possible to help.
ank you for purchasing a quality product from F/S
Manufacturing!
Publication:WR72-2019-06-05
Included in this Manual:
Parts List | Setup Instructions | Operating Instructions
INSTRUCTION MANUAL
F/S DANDELION KILLER
72” Pull Model - WR72
Step 6
Step 7
Step 8
65
Image 7a
Image 7b
1102 Center Street • West Fargo, ND 58078
1-800-333-2314 fsmfg.com
