tained.
-
Failure
the follow all instructions listed below may result in
Operations for which the power tool
was not designed may create a hazard and cause
personal injury.
-
Just because the accessory can
be attached to your power tool, it does not assure
safe operation.
Accessories running faster than
Incorrectly sized accessories
cannot be adequately guarded or controlled.
Accessories that do not match the
mounting hardware of the power tool will run out
of control.
-
-
-
Damaged
accessories will normally break apart during this
test time.
-
-
The eye pro-
generated by your operation. Prolonged exposure
to high intensity noise may cause hearing loss.
Frag-
ments of workpiece or of a broken accessory may
operation.
-
Cutting accessory con-
an electric shock.
-
If you lose control, the cord may be cut or
snagged and your hand or arm may be pulled into
the spinning wheel.
-
The spinning
wheel may grab the surface and pull the power tool
out of your control.
Accidental contact with the spinning
accessory could snag your clothing, pulling the ac-
cessory into your body.
The
may cause electrical hazards.
Sparks could ignite these materials.
-
-
sult in electrocution or shock.
snagged rotating wheel, backing pad, brush or any
other accessory. Pinching or snagging causes rapid
stalling of the rotating accessory which in turn caus-
es the uncontrolled power tool to be forced in the
wheel is snagged or pinched by the workpiece, the
edge of the wheel that is entering into the pinch
point can dig into the surface of the material caus-
ing the wheel to climb out or kick out. The wheel
may either jump toward or away from the operator,
break under these conditions.
or incorrect operating procedures or conditions
-
The operator can
control torque reactions or kickback forces, if proper
precautions are taken.
-
-
English | 7
www.ffgroup-tools.com
PE 180/1400 E PLUS
