1. PRECAUTIONS AND REQUIREMENTS
1.1. Precautions
1.1.1. Verify that you have the correct model number for your application. Reference model configurations
(page 17) to verify you have the correct unit. If not, see changing hand direction (page 14).
1.1.2. The door that the Concierge 23JL is to be mounted above should be plumb, square, and not warped.
The door should not stick to the jamb.
1.1.3. The door that the Concierge 23JL unit is to be mounted above should have standard butt hinges, void of
any springs. No other door open or close assist features should be attached to the door. 20 lbs. Of initial
force is applied at the leading edge of the door to begin the opening and closing actions. Flimsy or
improperly installed hinges may prevent the door opener from operating properly.
1.2. Power Requirements
1.2.1. This model is supplied with a 9 foot power cord that plugs into a 115v AC outlet. When the optional
electric strike is provided, it is supplied with 12 feet of low voltage wire to connect the electric strike plate
to the strike terminals on the main circuit board (page 11). The terminals are universal. WARNING: Use
caution and disconnect power when wiring electric strike.
1.3. Clearance Requirements
1.3.1. At least 6” of clearance above the top of the door is needed.
