Extron electronics DVC 501 SD Manual de usuario

Product Category

DVC 501 SD • Setup Guide

The Extron DVC 501 SD receives SD-SDI, HD-SDI, and 3G-SDI serial digital video signals and converts them to DVI-D and

analog RGB or component video. It is compliant with SMPTE 259M, 292M, 424M, and ITU digital video standards. The RGB

output can be set for RGBHV, RGBS, and RGsB. Bi-level or tri-level sync can be selected when the unit is set for component

video output. The DVC 501 SD features extraction of embedded AES3 audio, RS-232 and USB serial control, and a buffered

loop-through that delivers reshaped and restored multi-rate SDI signals.

NOTE: For full installation, conﬁguration, and operation details, see the DVC 501 SD User Guide, available at

www.extron.com.

Rear Panel Features and Connections

100-240V ~ 0.3A MAX

50/60 Hz

3G / HD / SD-SDI

BUFFERED

INPUT

LOOP-THROUGH RGB/R-Y,Y,B-Y

OUTPUT

DVI-D

RS-232

N/A Tx Rx

AUDIO

12456

aAC power connector dDVI-D output connector fAudio output connector

b3G/HD/SD-SDI input connector eRGB/YUV output connector gRS-232 connector

cBuffered Loop-through connector

Installation Steps

1. Disconnect power from all equipment.

2. (Optional) Mount the unit to a rack or furniture.

3. Connect the video input. Connect an SD-SDI, HD-SDI, or 3G-SDI source to the 3G/HD/SD-SDI port of the BNC input

connector (bin the rear panel illustration above).

4. (Optional) Connect a monitor or recording device. Attach a monitor or video recording device to the Buffered

Loop-through BNC connector (c).

5. Connect the video output. Connect a display or other output device to the DVD-D digital video connector (d) or to

the RGB/R-Y,Y,B-Y analog RGB (RGBHV, RGBS, and RGsB) or YUV component video connector (e).

6. Connect a control device. Connect a host device, such as a computer or touchpanel control system to one or both of

the following DVC ports to conﬁgure and control the DVC via Simple Instruction Set (SIS™) commands.

zRS-232 port (rear panel) — Connect a host device to the Tx, Rx, and _(ground) pins of this 5-pole captive screw

connector (g). The ﬁrst and second pins of this connector are not used. The default protocol for this port is

9600 baud, 1 stop bit, no parity, 8 data bits, and no ﬂow control.

zCong port (front panel) — Connect a USB cable (USB A to USB mini B) between a USB port on your computer

and this port (aon the front panel illustration on the next page).

7. Connect the audio output. Connect an ampliﬁer or other audio output device to the 5-pole captive screw audio

connector (fon the rear panel illustration), as shown below.

Do not tin the wires!

Balanced Audio Output

Tip

Ring

Tip

Ring

Sleeves

Unbalanced Audio Output

Tip

Sleeves

CAUTION: For unbalanced audio, connect the sleeves to the ground contact. DO NOT connect them to negative (–)

contacts.

8. Connect power to the DVC 501 SD by plugging a standard IEC power cord (provided) from a 100 to 240 VAC, 50-60 Hz

power source into the power receptacle (a).

68-1518-50 Rev. C

09 11

Front Panel Features

Extron

DVC 501 SD

DIGITAL VIDEO CONVERTER

ADJUST

CONFIG

1235

aUSB Conﬁg port bLCD screen cMenu button dNext button eAdjust knobs

Conguring the DVC 501 SD Using the Front Panel

Menu selections are displayed on the LCD screen. To use any menu, press the Menu button repeatedly until the desired

menu is displayed (see the menu ﬂow diagram below). Press the Next button repeatedly until the desired submenu appears.

Rotate an Adjust knob to select an item from a submenu. To return to the main menu at any time, press the Menu button.

After 30 seconds of inactivity, the screen displays the default cycle.

1. From the Output Conﬁg submenus, use the Adjust knobs to select the output signal

type and the sync polarity to match the requirements of the display device.

2. From the Advanced Conﬁg menu, Test Pattern submenu, select the Crop, Crosshatch,

Colorbars, and Grayscale test patterns to conﬁrm that the settings of the display device

are correct.

NOTE: Test pattern timings are based on the incoming SDI signals and are not

displayed if an active signal is not present.

3. Use the Audio Conﬁg submenus to conﬁgure the audio as desired.

Supported Input Resolutions

Supported

Resolutions 23.98 Hz 24 Hz 25 Hz 29.97 Hz 30 Hz 50 Hz 59.94 Hz 60 Hz

720p X X X X X X

1080i X X X

1080p X X X X X X X X

NTSC X

PAL X

NOTE: The output resolution always matches the input resolution.

Simple Instruction Set (SIS) Commands

When setting up the DVC 501 SD, you can issue SIS commands from your computer via RS-232 or USB as an alternative to

the front panel controls. See the DVC 501 SD Series User Guide for a complete list of available SIS commands.

Command ASCII command

(Host to Converter)

Response

(Converter to Host) Additional Description

Mute video 1B Vmt1]Mute the video output.

Unmute video 0B Vmt0 ]Display the video output.

Mute audio 1Z Amt1 ]Mute the audio output.

Unmute audio 0Z Amt0 ]Unmute the audio output.

Enable lock (executive) mode 1X Exe1]Lock all front panel functions.

Disable lock mode 0X Exe0 ]Enable all front panel functions.

AUDIO

CONFIG

30 sec.

Default

Cycle

EXIT MENU

PRESS NEXT

OUTPUT

CONFIG 30 sec.

30 sec.

ADVANCED

CONFIG

30 sec.

Otros manuales para DVC 501 SD

Tabla de contenidos

Otros manuales de Convertidor de medios de Extron electronics

Extron electronics

Extron electronics DSC 3G-HD A Manual de usuario

Extron electronics

Extron electronics mediaport 200 Manual de usuario

Extron electronics

Extron electronics YCS 100 Manual de usuario

Extron electronics

Extron electronics DVS 605 Manual de usuario

Extron electronics

Extron electronics DVC RGB-HD A Manual de usuario

Extron electronics

Extron electronics Four Input Video and RGB Scaler DVS 304 Manual de usuario

Extron electronics

Extron electronics DSC 401 Manual de usuario

Extron electronics

Extron electronics DVS 304 Series Manual de usuario

Extron electronics

Extron electronics HDP 101 4K Manual de usuario

Extron electronics

Extron electronics QGE 100 Manual de usuario

Extron electronics

Extron electronics Video and Sync Converter/Stabilizer SC 210 Manual de usuario

Extron electronics

Extron electronics BUC 102 Manual de usuario

Extron electronics

Extron electronics DVC RGB-HD A Manual de usuario

Extron electronics

Extron electronics DSC 3G-HD A Manual de usuario

Extron electronics

Extron electronics Balanced and Unbalanced Audio Converter BUC... Manual de usuario

Extron electronics

Extron electronics Two InpuT VIdeo Scaler IN1502 Manual de usuario

Extron electronics

Extron electronics Multi Video Processor MVP 104 Manual de usuario

Extron electronics

Extron electronics DDS 100 Manual de usuario

Extron electronics

Extron electronics 3G-AE 100 Manual de usuario

Extron electronics

Extron electronics IN1404XT Manual de usuario

Extron electronics

Extron electronics IN1402 Manual de usuario

Extron electronics

Extron electronics NAV SD 511 Manual de usuario

Extron electronics

Extron electronics Emotia Xtreme Manual de usuario

Extron electronics

Extron electronics DSC 3G-HD A Manual de usuario

Manuales populares de Convertidor de medios de otras marcas

SoundTraxx

SoundTraxx Blunami BLU-2200 Manual de usuario

SPROLINK

SPROLINK VA1 Manual de usuario

Acclaim Lighting

Acclaim Lighting DDC-1-AC Manual de usuario

Nikon

Nikon AF-S TC-20E III Manual de usuario

Axis

Axis AXIS Q7406 Manual de usuario

Omega

Omega TAC80B-J Manual de usuario

Zoom

Zoom Thunderbolt TAC-2R Manual de usuario

OST

OST iConverter 10/100M Manual de usuario

Vertiv

Vertiv Netsure Manual de usuario

birddog

birddog MINI Manual de usuario

Roland

Roland GI-10 Manual de usuario

Wallenstein

Wallenstein WX310 Manual de usuario

Pace

Pace MSS 200-1 Manual de usuario

Solar Converters

Solar Converters EQ 12/24-50 Manual de usuario

CYP

CYP EL-7400V Manual de usuario

TIE

TIE MIDI 1i1o Manual de usuario

DCS

DCS Vivaldi Upsampler Manual de usuario

Westermo

Westermo MCW-211 SERIES Manual de usuario