Extron electronics RWM 2 Manual de usuario

IMPORTANT:

Go to www.extron.com for the

complete user guide and installation

instructions befor

e connecting the

touchpanel to the power sour

ce.

www.extron.com

RWM 2 • Installation Guide

Overview

The RWM 2 is an accessory kit allowing the TLP Pro 725M and TLP Pro 1025M touchpanels to be installed directly into drywall.

This guide provides instructions for experienced professional installers to mount and install the TLP Pro 725M or TLP Pro 1025M

using the RWM 2.

ATTENTION:

• All structural steps and electrical installation must be performed by qualied personnel in accordance with local and

national building codes and electrical codes.

• Toute étape structurelle et installation électrique, doit être effectuée par un personnel qualié, conformément aux codes du

bâtiment, aux codes incendie et sécurité, et aux codes électriques, locaux et nationaux.

TOP

NORTH

AMERICA

NORTH

AMERICA

EU EU

EUEU

Front View Back View

FFAA

CDD

AA = Screw to turn locking arms (4)

BB = Magnets (7)

CC = EU mounting holes (4)

DD = MK mounting holes (2)

EE = North America mounting holes (2)

FF = Locking arms (4)

Figure 1. RWM 2

AScrews to turn locking arm (4)

BMagnets (7*)

C 2-gang EU junction box adaption

D1-gang MK junction box adaption

E1-gang North America junction box

adaptation, horizontally mounted

FLocking arms (4)

gure 1

*The RWM 2 ships with six magnets attached to the front and a spare attached to the back, as shown in

Figure 1. The spare magnet can be moved to the front if extra support is needed.

RWM 2 • Installation Guide (Continued)

TOP

Back View

TLP Pro 725M

Touchpanel

Mounting

Plate

Lock Screw

RWM 2

Figure 2. Installing a TLP Pro 725M with the RWM 2

Before You Start

Decide where you want to mount the touchpanel. A cut-out template for the RWM 2 is available at www.extron.com and

provides dimensions of all the components to be installed.

1. Use the template to cut a hole in the drywall (see ﬁgure 2, 1) that is 4.29" H x 6.14" W (109 mm H x 156 mm W).

The RWM 2 is suitable for drywall that is 0.50” to 1.00’’ (12.7 mm to 25.4 mm) thick.

2. Route cables to the hole.

If local building codes require cables to be run through conduit to a junction box, then the RWM 2 can be used with a standard

2-gang EU junction box, 1-gang MK junction box, or a horizontally mounted 1-gang North America junction box, (Extron JB 125).

The junction box must be purchased separately.

• Both the TLP Pro 725M and 1025M include #6-32 screws and M3.5 screws.

Mounting the RWM 2 Directly to Drywall

1. Run a PoE/Ethernet cable through the RWM 2.

2. Ensure the locking arms (2) are lying at against the top and bottom of the RWM 2, and insert it into the hole.

3. Use a Philips-head screwdriver to turn and tighten the locking arms. The locking arms will hold the RWM 2 securely, but

should not be over-tightened.

Mounting a TLP Pro Touchpanel

1. The touchpanel mounting plate has four hooks (3) one on each corner. Position the TLP Pro 725M or 1025M, so the hooks

t into touchpanel’s two rear slots (see the TLP Pro 525, 725, and 1025 Series User Guide).

2. Slide the TLP Pro 725M or 1025M down slightly, so the hooks are secure in the slots.

3. The tongue at the bottom of the mounting plate (4) sits in the groove at the bottom of the touchpanel (5). Fasten the

touchpanel to the mounting plate by tightening the lock screw (6).

4. After the TLP Pro touchpanel has been assembled, connect the ethernet cable to the rear port on the touchpanel (see the

TLP Pro 525, 725, and 1025 Series User Guide)

5. Place the touchpanel against the RWM 2. Strong magnets on the RWM 2 hold the touchpanel in place.

68-3235-01 Rev. B

06 18

Tabla de contenidos

Otros manuales de Accesorios de Extron electronics

Extron electronics

Extron electronics AXI 22 AT D Manual de usuario

Extron electronics

Extron electronics Architectural Adapter Plate AAP 301 Manual de usuario

Extron electronics

Extron electronics OCS 100W Manual de usuario

Extron electronics

Extron electronics Power Sensor Manual de usuario

Extron electronics

Extron electronics AXI 22 AT D Manual de usuario

Extron electronics

Extron electronics AXI 02 AT Manual de usuario

Extron electronics

Extron electronics PVT SW HDMI RGB D Manual de usuario

Extron electronics

Extron electronics OCS 100W Manual de usuario

Extron electronics

Extron electronics RGB 203 Rxi VTG Manual de usuario

Extron electronics

Extron electronics OCS 100C Manual de usuario

Extron electronics

Extron electronics OCS 100C Manual de usuario

Extron electronics

Extron electronics Extender AKM UK AAP Manual de usuario

Extron electronics

Extron electronics AXI 02 AT Manual de usuario

Extron electronics

Extron electronics WPD 110 A Manual de usuario

Extron electronics

Extron electronics Universal Video Interface with Audio RGB 201... Manual de usuario

Extron electronics

Extron electronics OCS 100W Manual de usuario

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Siemens

Siemens QSA2700D Manual del operador

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario