EXMAX EX-200N Wireless Tour Guide Voice Transmission System
sales@iexmax.com www.iexmax.com EXMAX® Team All Rights Reserved 2/ 4
4、Who in charge of the devices needs to know how to set the channel ID:
(1) Why and when need to set the channel:
1, When there are two or more groups using the devices at the same location, to avoid
the interference between the groups, you need to set different channels for the
devices (including both transmitters and receivers) of different groups.
2, When you need to add more receivers to a group, and the channel of these added
receivers is not the same as that of the devices of the group, you need to set the
channel of these added receivers to be the same as that of the group.(The channel of
the transmitter and the receivers in a group must be the same，or the receivers can
not receive the signal from the transmitter)
(2) The ways of channel setting:
We have two ways to do this: Wireless channel setting and manual channel
setting.(We will use wireless channel setting if we have to set the channel for many
receivers; And we will use manual channel setting if we have to set the channel for
only a few receivers.)
1、Wireless channel setting:
In the working condition, keep pressing both “ ”button and the“ ” button at
the same time until the channel number on the screen is flashing, then release
both “ ”button and the“ ” button, now the transmitter has entered the
channel setting mode, then you can click the " " or " " button to change
the channel number：The channel number can be changed from 001 to
200,after you have chosen the desired channel number, keep pressing “M"
button for about 3 seconds until the flashing antenna icon " " appears,
then release the “M" button, now the transmitter has entered the wireless
channel matching status, then you can put the receivers(the receivers have
been turned on) closed to the transmitter(within 2 meters),and the receivers’
channel will match the transmitter’s channel(within 5 seconds) and become
the same, now the channel matching is finished. Then you can click the
transmitter’s “M" button to quit the channel matching mode, now if the
transmitter speaks, the receivers can hear it.
