Caution
1. Alterations or modifications carried out without appropriate authorization may invalidate
the user’s right to operate the equipment.
2. If powering the device using DC voltage, a Class 2 24VDC 3A power supply is
recommended to ensure stable operation. With its internal protection and regulation,
SensorShield-1600™ can be operated with an unregulated 24VDC power supply. In this
scenario, voltage fluctuation limits will be dependent on setup. Refer to the Electrical
Specifications section on SensorShield-1600™ operational limits.
3. Do not attempt to disassemble SensorShield-1600™ in order to access internal
components. Consult ExcelSense for technical support as required.
4. Never face the SensorShield-1600™ directly towards the sun or any bright or reflective
light, which may cause damage to any internal sensors mounted behind it, such as
cameras.
5. Do not remove the SensorShield-1600™ label containing P/N and S/N information for
warranty service.
6. Never expose SensorShield-1600™ to conditions outside those specified in the
Specifications section. Doing this can cause permanent damage to the device.
7. Damaged SensorShield-1600™ equipment must be replaced through an ExcelSense
representative. Failure to do this may cause incompatibilities and permanent damage to
the system.
8. Always clean the SensorShield-1600™ lens by performing cleaning cycles (see
Triggering the SensorShield-1600™ section for details). Do not clean the glass manually.
SensorShield-1600™ may also be pressure washed as an alternative, when fully
enclosed in an IP69 rated enclosure.
