7
Cautions
This LED device has a very powerful light. Do not look directly into
the light, and do not point it into the eyes of other people.
To obtain an optimal lifetime of your product, always handle the
device with care. Do not expose the product to hot, cold, or moist
conditions that exceed those specified in the technical description, as
this can damage the product. Do not short-circuit your ExamVision
product.
Your ExamVision Light system headlamp and Control unit are not
designed to be immersed in water. Clean off any splashes
immediately to avoid damaging your unit. See section 5 for correct
cleaning and disinfection procedure.
Portable RF communications equipment (including peripherals such
as antenna cables and external antennas) should be used no closer
than 30 cm (12 inches) to any part of Total Lamp, including cables
specified by the manufacturer. Otherwise, degradation of
performance of this equipment could result.
Use of accessories, transducers and cables other than those specified
or provided by the manufacturer of this equipment could result in
increased electromagnetic emissions or decreased electromagnetic
immunity of this equipment and result in improper operation.
Use of this equipment adjacent to or stacked with other equipment
should be avoided because it could result in improper operation. If
such use is necessary, this equipment and the other equipment
should be observed to verify that they are operating normally.
Do not attempt to repair or modify your ExamVision product
yourself. Should the device become damaged or not work properly,
contact your ExamVision dealer for assistance.
