IP Video Surveillance Solutions
1/23/2009
www.exacq.com
4Panasonic
Panasonic provides the EasyIpSetup_Ipro utility to find IP cameras. Running the utility will display a window as seen
below:
click on a camera to highlight it, the click IP setting button to
view and edit the camera IP properties.
Panasonic cameras typically do not use DHCP by factory
default. If you have a DHCP server (e.g. router) on the
network, it can automatically assign your camera an IP
address if you select the “DHCP On” radio button. You will
need to manually assign the camera an IP address if you
manually assigned the exacqVision Server’s IP address,
there is no DHCP server on your local network, or you want
to assign a static IP address to the IP camera to ensure that
its IP address is not inadvertently changed. If so, enter an IP
address which is not used by any other device on your local
network, make sure that the first three numbers match the
first three numbers of your exacqVision Server’s IP address.
Set Subnet to 255.255.255.0, leave the HTTP port at 80,
enter the camera’s Administrator name and password, and
press Apply.
NOTE: Panasonic cameras automatically disable their response to configuration queries twenty minutes after being reset.
If your camera has been running for more than twenty minutes, you’ll need to reset or power cycle it before querying or
configuring its IP address through either Exacq’s IP camera finder or Panasonic’s EasyIPSetup utility.
NOTE: Factory default login for Panasonic IP cameras is:
username: admin
password: 12345
You’ll need to enter this username and password when you add this camera to your exacqVision System.
