tools safety warnings
Working area
•Keep working area clean and well lit. Untidy and dark areas can lead to accidents.
•Do not operate power tools in potentially explosive surroundings, for example, in the
presence of inflammable liquids, gases or dust. Power tools create sparks which may
ignite the dust or fumes.
•Keep children and bystanders at a distance when operating a power tool. Distractions can
cause you to lose control of it.
Electrical safety
Always check that the power supply corresponds to the voltage on the rating
plate.
•Do not expose power tools to rain or wet conditions. Water entering a power tool will
increase the risk of electric shock.
•Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power
tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled
cords increase the risk of electric shock.
•When operating a power tool outdoors, use an extension cord suitable for outdoor use.
Use of a cord suitable for outdoor use reduces the risk of electric shock.
Personal safety
•Use safety equipment. Always wear eye protection. Using safety equipment such as a
dust mask, non-skid safety shoes, a hard hat, or hearing protection whenever it is needed
will reduce the risk of personal injury.
•Avoid accidental starts. Ensure the switch is in the off position before inserting the plug.
Carrying power tools with your finger on the switch or plugging in power tools when the
switch is in the on position makes accidents more likely.
Service
Your power tool should be serviced by a qualified specialist using only standard spare parts. This
will ensure that it meets the required safety standards.
Specific safety instructions for circular saw
•Check lower guard for proper closing before each use. Do not operate without protective
guard or if it is damaged.
•Remove adjusting key and wrenches key before turning the power tool on
•During operation maintain a firm grip with both hands for a proper balance and to avoid the
risk of injury by cutting.
•Protect against kickback. When blade is binding in material processing, release on / off
switch (6) and hold the saw motionless in the material until the blade comes to a complete
stop. To resume work center the blade in the kerf and check that teeth are not engaged into
the material, then press the switch (6) to start.
•Operate powertool only in working position.
•Connect powertool to the dust extraction equipment (bag or vacuum cleaner)
