Evnex E Series Guía del administrador

Installer & Operator Manual

Intelligent EV Charging Station

E7, X7 & X22 Series

V210211

E & X Series

As well as standard installation tools, the following is required:

•T20 TORX SECURITY BIT

•NO.2 SQUARE DRIVE BIT

•7MM MASONRY BIT (FOR SOLID WALLS)

Evnex E & X Series Installation Manual | V210211

Please note

•Read all instructions before installing or using this product.

•This document is current at the time of

printing. Please ensure you have the latest

version. See www.evnex.com/resources or

scan this QR code:

•Evnex Ltd. reserves the right to make changes

to this document or the products described without notice.

•For questions relating to this product, its use or installation,

please refer to contact details below:

Phone: +64 3 925 9879

Email: support@evnex.com

Web: www.evnex.com

Address:

239 Brougham St

Sydenham

Christchurch

8023

New Zealand

3 
 
Evnex E & X Series Installation Manual | V210211 
Contents 
 
Introduction................................................................................................. 5 
Product description................................................................................. 5 
General dimensions................................................................................. 5 
About this document............................................................................... 6 
Scope of this document .......................................................................... 6 
Symbols................................................................................................... 6 
 
Safety information ...................................................................................... 7 
General information................................................................................. 7 
Risk of electric shock .............................................................................. 8 
 
Disclaimer ................................................................................................... 9 
 
Installation ................................................................................................ 10 
Installation Notes .................................................................................. 10 
Site selection ......................................................................................... 10 
Mounting notes ..................................................................................... 12 
Fasteners............................................................................................... 13 
Opening the unit .................................................................................... 14 
Mounting the unit .................................................................................. 15 
Timber framed wall mounting example................................................ 16 
Solid wall mounting example................................................................ 17 
 
Wiring connection ..................................................................................... 18 
Single phase wiring example ................................................................ 19 
Three phase wiring example ................................................................. 20 
Upstream protection ............................................................................. 21 
Accessory terminal block...................................................................... 23 
Earthing the unit.................................................................................... 23 

4 
 
Evnex E & X Series Installation Manual | V210211 
Setting the maximum charge current................................................... 23 
 
Closing the unit ......................................................................................... 24 
Checklist ................................................................................................ 24 
Installing the front cover ....................................................................... 25 
 
Operation................................................................................................... 26 
Status display........................................................................................ 26 
Initialisation........................................................................................... 26 
Charging process .................................................................................. 27 
LED modes / fault conditions................................................................ 28 
 
Technical information............................................................................... 29 
 
Troubleshooting........................................................................................ 33

Evnex E & X Series Installation Manual | V210211

Introduction

Product description

The Evnex E & X Series charging stations are a cost effective connected

charging solution, available in both single phase 7.4kW, and three phase

22kW configurations.

When connected to a compatible OCPP (Open Charge Point Protocol)

server, the Evnex E & X Series charging stations become an excellent

choice for smart-grid managed charging or public charging, where

energy metering or access control is required.

General dimensions

Evnex E & X Series Installation Manual | V210211

About this document

The following document describes the functionality and installation

procedures for the Evnex E & X Series of electric vehicle charging

stations.

Scope of this document

This document only refers to the following E & X Series charging stations,

please refer to the correct documentation if this does not apply.

Three phase: X22-T2T, X22-T2S

Single phase: E7-T1T, E7-T2T, E7-T2S, X7-T1T, X7-T2T, X7-T2S

Symbols

You will find the following symbols throughout this document. Please

pay attention to the recommendations.

CAUTION –Failure to follow these directions may cause

minor injury or damage to equipment.

WARNING –Failure to follow these directions may

cause serious injury or death.

Evnex E & X Series Installation Manual | V210211

Safety information

General information

•This unit should only be installed by those who are appropriately

qualified and skilled to do so.

•This unit has been designed and tested in accordance with IEC 61000-6-

3 and IEC 61000-6-2, however the installer is responsible for ensuring

that all local regulations and standards are complied with.

•This product is to be serviced only by Evnex approved technicians using

only Evnex supplied parts

•There are no user serviceable parts inside the charging station.

•Do not attempt to repair or modify the product

•It is the user’s responsibility to ensure that the cable is stored safely,

and not left where it could become a tripping hazard, or subject to stress

or damage.

•This charging station should only be used to charge a vehicle with a

compatible J1772 socket, or IEC 61851 type 1 or type 2 socket.

•Only cables which comply with IEC 62196-1 and IEC 62196-2 may be

used with this product

•Vehicle and charging cable shall be used as per the manufacturers

instructions

•Vehicle on-board charger required to comply with IEC 61851-1 and IEC

61851-21-1

•Avoid excessive application of moisture to charging cable connectors,

e.g. washing with hose

Evnex E & X Series Installation Manual | V210211

•Do not use harsh chemicals to clean this product. Periodic cleaning may

be done with a damp cloth and mild detergent if required

•Warning labels must not be removed

Risk of electric shock

•Read all instructions before installing or using this product

•If this product appears to be damaged in any way, it should be

electrically isolated and repaired or replaced. Damage includes fraying

or broken insulation on the power cable or any signs of cracking or

separation on the connector or charging unit

•This product should not be operated while in a “Fault” state and should

be electrically isolated until serviced by a qualified technician

•Appropriate upstream protection is required as per local regulations

•Never insert foreign objects in the charging cable connectors or

charging station socket

•Do not use extension cords or any kind of adapter with this product

•This product should not be used by children

•Avoid installing this product in locations that are prone to flooding

Evnex E & X Series Installation Manual | V210211

Disclaimer

Evnex Limited shall not be liable in any way for damage or injury that occurs

when using the product, and all warranties will be void where:

•The installation instructions have not been followed correctly

•The product has been installed by an unqualified person

•The product has been tampered with or modified

•The product has been used for a purpose other than it was designed and

intended for

Evnex E & X Series Installation Manual | V210211

Installation

Installation Notes

•Installer advised to follow anti-static procedures and to avoid touching

exposed electronic components

•Take extra care to avoid damage to internal components during

installation

•Product requires an upstream RCD to be installed with wiring as per

applicable local legislation.

•Product must be installed with appropriately rated wiring and upstream

circuit breaker

•Installation to be performed without charging cable attached for non-

tethered units

•Installer to use appropriate installation equipment and protective safety

clothing as per local legislation

•All exposed metal components such as pedestals shall be earthed as

per local legislation requirements

Site selection

•Where possible, protect the charging station from direct sunlight to

prevent charging speed reduction or charging interruption due to

overheating

•Do not cover unit or install in an area with poor airflow, such as a

cupboard

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cargador de baterías de Evnex

Evnex

Evnex R Series Manual de usuario

Manuales populares de Cargador de baterías de otras marcas

AA Portable Power Corp

AA Portable Power Corp Universal Smart Charger Manual de usuario

Enelion

Enelion Vertica Manual de usuario

RCA

RCA CHU6 Manual de usuario

ANSMANN

ANSMANN ALCT 6/24-10 Manual de usuario

Hitachi

Hitachi UC 18YRSL Guía de solución de problemas

Olympus

Olympus B-20 LPC Manual de usuario

Exibel

Exibel ZH1708143 Manual de usuario

Lenmar

Lenmar Mach 1 Manual de usuario

CTEK

CTEK MXS 5.0 Manual de usuario

ABB

ABB HT842379 Manual de usuario

Nitecore

Nitecore Superb Charger SC4 Manual de usuario

Renogy

Renogy RBC2125DS-21W Manual de usuario

Braun

Braun BWC02M Manual de usuario

CTEK

CTEK MXS 3.6 Manual de usuario

Black & Decker

Black & Decker BDV090 Manual de usuario

Trinity

Trinity DPD Manual de usuario

Hulkman

Hulkman Sigma 1 Manual de usuario

IKEA

IKEA koppla Manual de usuario