EVEREADY B1-5.1-48 Manual de usuario
I
www.solarsg.com.au
USER MANUAL
User Manual
B1-5.1-48
Secondary
1
www.sundaybattery.com
USER MANUAL
Chapter One: Safety Precautions
1.1 Safety Instructions
1.2 Explanation of Symbols
1.3 Emergency Measures
Chapter Two: Product Introduction
2.1 Product's Application Scope
2.2 Product Model Naming Rule
2.3 Product Datasheet
Chapter Three: Installation Instructions
3.1 Package Items
3.2 Installation Position
3.3 Mounting Procedures
Chapter Four: Electrical Connection Ways
4.1 Explanation to Electrical Interface
4.2 Connection ways to Secondary
4.3 Communication Interface
4.4 Installation of the right cover
4.5 Ground Connection
Chapter Five: Debugging Instructions
Chapter Six: Battery Maintenance
6.1 Transportation
6.2 Storage Environment
Chapter Seven: Contact Us
Warranty card
Contents
www.solarsg.com.au
2
2
3
4
5
5
5
6
7
7
8
10
14
14
15
16
17
18
18
19
19
19
20
20
2
1.1 Safety Instructions
Chapter One
Safety Precautions
this manual for instructions before operating the equipment.
Danger
• Do not expose batteries to an environment with a temperature
over 45°C.
• Do not squeeze or impact on the battery with any strong force.
• Do not immerse the battery in water or install it in a humid environment.
Warning
local standards and rules.
• If any unauthorized change of product function results in fatal damage
not be responsible for these losses and warranty claims.
positive and negative electrodes of the battery correctly to prevent
short circuit circumstance.
Caution
• Do not modify or change any components of the battery.
Symbol
3
www.solarsg.com.au
USER MANUAL
Notice
• Please ensure that the circuit breaker is off when wiring B1 battery.
• B1 battery can only be used together with Eveready AS1 and HS1 series
1.2 Explanation of Symbols
Hazardous voltage
No open ames
or gases.
Danger of hot surface
heat.Do not touch the metal casing of the inverter during operation.
Attention
Install the battery out of the reach of children.
An error occurred
Please refer to this manual for troubleshooting.
This device cannot be treated as household waste
"Battery Maintenance".
CE mark
The equipment complies with low voltage and EMC instructions.
Recyclable
Symbol Description
4
In case of emergency, following measures shall be taken:
1
of clean water and seek medical treatment.
2
with soap immediately.
3
straight away.
4
5
spread to it yet.
1.3 Emergency Measures
Warning
the main power.
evacuate immediately.
5
www.solarsg.com.au
USER MANUAL
B1 battery (Hereinafter refers to Secondary) is applied in the household energy
storage system.It has a built-in battery management system (BMS) to improve the
utilization rate of the battery and prevent overcharge and overdischarge of the
battery. Modular design is adopted for the battery to facilitate installation and wiring.
Three units of batteries at most can be paralleled.
Chapter Two
Product Introduction
2.1 Products Application Scope
2.2 Product Naming Rule
Fig. 2.1 B1 Battery Appearance
B1–XX–XX
1 2 3
B1 refers the product series.
XX refers to the rated capacity of the
XX refers to the voltage grade of the
1
2
3
6
2.3 Product Datasheet
Model B1-5.1-48
Electrical Parameters
5120
4600
51.2
42~58.4
Cycle Life
60
60
General Parameters
Battery Type
CAN
0°C~50°C
Cooling Method Natural Convection
Ambient Humidity
Ingress Protection IP65
410*650*186
48
7
Applicable Standards
7
www.solarsg.com.au
USER MANUAL
Chapter Three
Installation Instructions
3.1 Package Items
Battery pack Mounting Bracket
Mounting bolts for
mounting bracket*6 Cables & Bolts*4 Ethernet cable
& EJ45 plug User Manual
8
3.2 Installation Position
3.2.1 Battery size
3.2.2 Installation Position
This equipment is cooled by natural wind convection.
Fig. 3.2.1 B1-5.1-48 (Secondary) Dimension (Unit: mm)
Tabla de contenidos
Otros manuales de Accesorios para cámaras de EVEREADY
