Ceiling Fan: Model EV2075CF
INSTRUCTION MANUAL – IMPORTANT INSTRUCTIONS RETAIN FOR
FUTURE USE - READ FULLY BEFORE USE
Pictures or product specifications may vary slightly from those indicated due to ongoing product improvement
________________________________________________
Safety Instruct ons
WARNING! A su tably qual f ed person - connect on to the ma ns supply requ red, must nstall th s fan.
This fan and associated equipment must be installed by a person who is suitably qualified to install electrical equipment that is
permanently connected to the mains 230V mains power system as a condition of warranty No responsibility will be taken for any
damage or physical harm caused by incorrect installation
Carefully read th s manual n full before us ng th s electr c fan.
Ensure that you know how the fan functions and how to operate it Maintain the fan in accordance with the instructions to ensure that it
functions properly Keep this manual with the fan If the fan is to be used by a third party, this instruction manual must be supplied with
it The safety instructions do not by themselves eliminate any danger completely and proper accident prevention measures must always
be used No liability can be accepted for any damage caused by non -compliance with these instructions or any other improper
use or mishandling
Package Contents
1 x Instruction Manual
1 x Fan Motor Assembly
1 x Set Fan Blades (4)
1 x Extension Tube
1 x Ceiling Base Plate Assembly
1 x Pack Blade Brackets (4)
1 x Pack Screws - Screw pack contains
4 Ceiling Base fixing screw / 4 split washer / 4 washer
12 Blade bracket fixing short bolt / 12 washer / 12 nut (1 set spare)
CAUTION Confirm all parts before disposing of packaging Safely dispose of all plastic bags and
other packaging components They may be potentially dangerous to children
Assembly and Installat on
Unpack and confirm all components
Th s fan should be connected to a 10amp c rcu t controlled by a ded cated solat ng sw tch, su table means for
d sconnect on must be ncorporated n the f xed w r ng c rcu t and all work s to be completed n accordance w th the
current w r ng rules. There s an OFF pos t on on the pull cord sw tch located on the motor assembly however th s does
not d sconnect the fan from the ma ns supply permanently.
WARNING! Ensure the power s OFF before connect ng to the ma ns supply.
Step 1 Fit blade bracket to each blade Note. Blade decorative screen should face downwards on finished product Attach blade bracket
to the blade as shown in fig 1 and fig 2
Step 2 Attach blades to motor assembly as shown in fig 3
Step 3 Remove base cover from base plate
Step 4 Screw base plate to ceiling using the screws supplied
Step 5 Connect mains supply wires to terminal block (P - N - E) Warning Ensure power is OFF This appliance must be earthed
Step 6 Place ceiling base cover over motor wires as shown in fig 4
Step 7 Remove the fixing bolt and cir-clip from the lower end of the extension tube
Step 8 Place the extension tube carefully over the fan motor wires, pull fully out the top of the tube and attach the extension tube to
the motor assembly Fit the cir-clip to the securing bolt as shown in fig 4
Step 9 Connect the fan motor wiring to the terminal block Ensure all earth wires are securely connected
