COMPACT PORTABLE
Operating& Maintenance Instructions
EUROVAC INC. 2
EUROVAC II 50-179 (COMPACT PORTABLE SANDING VACUUM SYSTEM)
FORWARD:
With proper care and attention, your portable vacuum will provide maximum
performance and long service. We are sure it will be one of your most valued assets. Our
interest in the successful operation of your portable continues throughout the life of the unit.
We want it to serve you well. For that reason, please feel free to discuss any problem that you
may encounter with its operation or performance. It will be a pleasure to serve you.
INTRODUCTION:
Eurovac has the perfect solution for elimination sanding dust at the source. Eurovac
construction is the most advanced self-contained dust collector in the market place to date.
The compact construction allows the operator free movement. As a result, sanding is more
efficient, cost effective and less hazardous.
INSTALLING AIR SUPPLY:
One of the best features of the 50-179 portable is an automatic activation system that
will turn the unit on and off with the air tool (not provide) used with your system. To
accomplish this, a compressed air supply must be routed through the portable. A minimum ½”
air supply line using 3/8” I.D. disconnect (not provided) is required on supply side in order to
run two tools simultaneously. Air must be free of dirt and moisture and should be lubricated
regularly (once a day). ¼” I.D. disconnects can be used where compressed air exits. It is very
important air is clean and dry. Install disconnects onto air line of vacuum hoses provided
(minimum ¼” I.D.)
OPERATION:
You are now ready to use your new portable. Plug main power cord into a dedicated
15A 120V circuit. There can be no other electrical equipment plugged into this circuit.
Vacuum system requires all of the power and additional electrical components plugged into the
circuit may blow the fuses/circuit breaker in your main power supply. Plug air tool into hose
(tool must be converted to the type used for vacuum sanding). Test function of automatic
control system by depressing and releasing trigger on your air tool. There is a manual over-
ride power switch located on top of control panel. This way the portable can be used for
straight vacuum cleaning. Since the filter will clog very quickly, it will need cleaning. Contact
factory or your local jobber for any cleaning hoses/tools you may require.
