5. Press "D" or "E" button briefly to confirm and exit alarm setting mode.
NOTE: If no button is pressed for about 60 seconds, the watch will exit alarm setting mode
and return to alarm display mode.
e) CHRONOGRAPH FUNCTIONS
In chronograph mode (Refer to section a. “MODE”):
In chronograph mode, the screen displays the letters ST at the right –see figure above.
Press button "D" or "E" button:
1. Once to start the chronograph;
2. A second time to stop the chronograph;
3. A third time to continue timing.
4. To reset the stopwatch to zero, press and hold "D" or "E" button till the timing resets to
zero.
NOTE: When you switch to other mode, the chronograph continues timing in the background if you
don’t stop it. The chronograph display range is limited to 59 minutes and 59.99 seconds. When it
reaches this limit, it restarts from zero.
f) BACKLIGHT FUNCTION
Press "A" button once to turn on the EL backlight for 3 seconds in any mode.
IV. WARNING
•To ensure a waterproof seal, always make sure that the crown has been pushed back into the normal
operating position.
•DO NOT USE the crown or any other buttons underwater or when the watch is wet.
•To maintain the aesthetic appearance of your watch, avoid contact with perfumes, nail polish, varnish,
cosmetics, cleaning products, adhesives, and paint, as they can cause discoloration, deterioration and
damage.
•To prevent any risk from perspiration, dust and humidity, regularly wipe your watch with a soft, dry cloth.
•To ensure the longevity of your watch, please observe the following instructions: Do not attempt to open
the watch casing. The battery must be replaced by a qualified person.
•Your watch is shock-resistant. However, to avoid damage, make sure you do not drop or hit it against
hard surfaces.
WARNING: You should not dispose of this device with your household waste. A selective collection system for
this type of product is implemented by your local authorities. Please contact your local authorities to find out how
and where collection takes place. These restrictions apply because electrical and electronic devices contain
dangerous substances that have harmful effects on the environment or on human health and must be recycled.
This symbol indicates that electrical and electronic devices are collected selectively. The symbol shows a waste
container crossed out with an X symbol.
Imported by EML/ PRODIS, 1 rue de Rome, 93110 Rosny-sous-Bois, France/ Made in P.R.C
Marketed by EUROTOPS VERSAND GMBH D-40764 LANGENFELD
