01 06
1SYSTEM BOOTS UP (RECORDING STARTS)
Once the car engine is started, "Red/Green” LED light is ON while the system boots up.
Upon successful system boot-up, please note the following start-up indication;
* A single beep tone can be heard.
* Red LED (on blackbox) goes OFF.
* Red LED (on front & rear cameras) flashes every 2 secs.
All the above *** indicate video recording is operating normally.
2SYSTEM SHUTS DOWN (RECORDING STOPS)
Once the car engine is off, the power to the blackbox is automatically disconnected.
However, it will continue to record for 3 additional seconds.
“Red” LED on blackbox will light up and then go off once the system is completely
shut down.
NOTE: Micro SD Card in Blackbox should be removed only when
engine is shut down or power cable to device is disconnected.
Failure to do so may damage the micro SD card !
SYSTEM STARTS TROUBLESHOOTING
1. Video Files do not seem to be recorded on the Micro SD card ?
Check micro SD card. Format memory card if you encounter any errors.
It is recommended to use the LogON_PC Player to format SD card.
2. Blackbox cannot power up ?
Unplug power connector from the Blackbox and firmly plug it in again.
3. Videos in LogON PC_Player look dim ?
Video brightness may be affected if the cameras are installed behind dark
tinted windscreens.You can increase video brightness from the LogON
PC_Player when playing video files.
4. Google map is not available in LogON PC_Player ?
JS400 uses an external GPS receiver connected via cable. Check that the
GPS cable is connected firmly to the blackbox. GPS reception may be
affected by solar films.An Internet connection is necessary for Google maps.
5. Cameras do not seem to be connected (Camera LED does not flash)?
Cameras are connected to Blackbox recording device via USB cables.
Check that the cables are plugged in firmly to the Camera and Blackbox.
6. Recorded videos seem shaky, not clear or misaligned.
Please check that the cameras are firmly installed with good quality
double sided tapes, otherwise cameras may shake or even drop off the
windscreen. Clean windscreen and camera lens with a soft dry cloth.
Make sure cameras are positioned correctly at the vehicle’s front and rear.
7. Multiple beeps occur each time engine is started.
Possible recording error! Check that the micro SD card and the camera cables
are connected correctly to the front camera and blackbox.
8. SD Card, Blackbox or Cameras doesn’t seem to be responding?
System might have hung. Turn off engine or unplug power from Blackbox.
Wait few minutes before restarting engine or plug in power to reset the system.
9. How to remove micro SD Card safely from Blackbox recording device?
To remove memory card safely, it is important to turn off the engine.
Otherwise, Micro SD card can be damaged.
IF OTHER PROBLEMS PERSIST, KINDLY CONTACT YOUR LOCAL DEALER
