Estella 236ECEGOD Manual de usuario
08/2022
3058215
236ECEGOD
User Manual
On Demand Espresso Grinder
1
Index ..............................................................................1
Safety Warnings.....................................................................2
Troubleshooting.....................................................................2
Installation .........................................................................2
Programming .......................................................................3
Operation ..........................................................................4
Cleaning ...........................................................................4
Parts List ...........................................................................5
NOTE: Save these instructions for future reference.
Index
2
• This machine should only be used by qualified personnel.
• Do not allow anyone under the age of 18 to use this machine.
• Do not unplug the grinder by pulling on the cord.
• Unplug the grinder before reaching in for any reason.
• Beware that grinder may continue to spin for a short period of time after turning
off the machine.
• Do not operate with wet hands.
• Do not allow liquid to come into contact with the grinder.
• Only put espresso beans into hopper.
• Make sure that the handle on the grinder is correctly screwed in place and that it stays within
the lines on the grind selector.
If the grinder is not working or tripping:
First check the grind selector. It is possible that beans got stuck in the grinder - to check, turn
the handle to a more coarse setting and turn on machine. If this does not work, try using the
Automatic Power Failure Installment Button. This is located next to the power button, and can be
used when the grinder has tripped or has stopped working. This will reset the grinder.
Safety Warnings
Troubleshooting
Installation
• Make sure grinder is sitting on a flat surface.
• Before plugging in the grinder, make sure the voltage of the electric supply match
machine ratings.
• If hopper becomes detached, make sure to securely fit it into the grinder. The handle will need
to be screwed into place to the grind selector.
Wall receptacle must be grounded. Do not use extension cords or wall adapters.
3
Decrease me (in seconds) of how long the grinder is grinding beans.
Increase me (in seconds) of how long the grinder is grinding beans.
The one cup button is for the first setting, which you can program to the amount of time the
machine will grind beans for.
The two cup button is for the second setting, which you can program to the amount of time
the machine will grind beans for.
The connuous run buon will connue to run as long as the buon is held down. The
grinder will stop when the buon is released.
3
5
6
4
7
Setting Time (Seconds)
1
2
3
4
5
Programming
1. You can program both the one cup and two cup buons located on the seng panel. Doing so
will allow the machine to run for the amount of me selected, when the buon is pressed.
2. To program me (in seconds), click on either the one cup or two cup buon and adjust the me
to the desired amount using the minus (-) and plus (+) buons.
3. When you reach the desired me you can then hit the start buon to begin grinding.
4
1. Ensure that the hopper is securely fitted to the top of the grinder.
2. Close the slide underneath the hopper.
3. Fill the hopper with espresso beans and secure the lid.
4. Open the slide to allow beans to fall into the grinder.
5. Turn the power switch to the on position.
6. Put the portafilter below the doser, and make sure to hold in place during the
grinding process.
7. To start grinding, select the button for either the one cup or two cup setting and hit start, or
manually grind by pressing the arrow button.
8. The grinder will grind beans until the selected time runs out or you can press the 'Start' button
again to stop the grinder.
1. Close slide and pull off the funnel from the machine.
2. Use vacuum cleaner to get any loose grounds out of machine.
3. Wash the funnel with nonabrasive soap and water
4. Make sure to dry the funnel completely by air drying
5. Use brush to sweep off any loose grounds and dust that are in funnel, doser, and base.
Caution: Do not get water/soap in the base and burr area.
Operation
Cleaning
If grounds are not dispensing ensure that properly dried espresso beans are being used.
Make sure to pull dispensing lever entire way forward and then allow to release back to its
original position.
Note: To adjust coarseness of grounds thread the adjustment handle into the grind selector and
rotate to desired posion. Only adjust coarseness while the machine is on. Please note that
adjusng the grind will change the amount dispensed.
5
Grind Adjustment Spring
Grinding Machine
Gear Plate Group
M4 Screw
Grinding Machine
Anchor Screw
M4 Screw
Cone-Shape Coffee Beans
Pouring Trough
Grinder Selector
Adjustment Stick
Grind Adjustment Abut
Screw (M4 Screw)
Funnel
Funnel Lid
Cooling Fan
Foundation Lid
Footpad
Power Button
Automatic Power Failure
Installment Button
Funnel
Setting Panel
Handle Frame
Controller
Slide
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Parts List
22
22
Tabla de contenidos
