AK6000 - prevádzkový manuál
Warning - danger or risk of injury
!Important note or statement
Please read these instructions carefully before using the AK6000 control unit
Do not use the boiler until completely installed
When the boiler is ON you can not do the following
oremove enclosure from the electrical parts - for example electronic modules,
fans, sensors, thermostat etc.
oreplace the fuses
orepair damaged cables and modules etc.
Before removing the cover of the electrical parts or other apliances is important to
disconect the power cord from the AC outlet.
Do not operate the boiler unless all enclosure panels are properly in place
In case of failure detection or damaging any part is important
odo not touch any part of boiler
oimmediately disconect boiler out of the AC outlet
orefer all servicing to qualified service personnel
This appliance is not suitable for person which were not instructed by the responsible
operator for using the appliance or whose have physical and other disability which
prevents from the safe operation on the apliances
Improper connection of the equipment can result in risk of electric shock. Check with
qualified electrician or service representative if you are in doubt whether the boiler is properly
