Ericsson 2219 Manual de usuario



Install RadioInstall Radio

Radio 2219Radio 2219

Installation Instructions

Ge11067AGe11067A

67/1531-LZA 701 6001/1 Uen J67/1531-LZA 701 6001/1 Uen J



CopyrightCopyright

be reproduced in any form without the be reproduced in any form without the written permission of the copyrightwritten permission of the copyright

owner.owner.

DisclaimerDisclaimer

The contents of this document are subject to revision without notice due toThe contents of this document are subject to revision without notice due to

continued progress in continued progress in methodologymethodology, design and , design and manufacturing. Ericsson shallmanufacturing. Ericsson shall

have no liability for any error or have no liability for any error or damage of any kind resulting from the use ofdamage of any kind resulting from the use of

this document.this document.

Trademark ListTrademark List

All trademarks mAll trademarks mentioned hereentioned herein are the propin are the property of their respectierty of their respective owners.ve owners.

These are shown in the These are shown in the documentdocument Trademark InformationTrademark Information..

67/1/153531-1-LZLZA A 70701 61 600001/1/1 U1 Uen en JJ||20201717-0-06-6-0606



ContentsContents

11 IntroductionIntroduction 11

1.11.1 DocumentationDocumentation 11

1.21.2 ToolsTools 11

1.31.3 ConditionsConditions 22

22 Work ProcessWork Process 44

33 Unpack and Check MaterialsUnpack and Check Materials 55

44 Installation AlternativesInstallation Alternatives 77

4.14.1 Mounting Direction Mounting Direction AlternativesAlternatives 88

55 Prepare for InstallationPrepare for Installation 1010

5.15.1 Install Mounting BracketInstall Mounting Bracket 1010

5.25.2 Preassemble Single Pole Clamp and Prepare RadioPreassemble Single Pole Clamp and Prepare Radio

(Optional)(Optional) 1111

5.35.3 Install SFP ModuleInstall SFP Module 1212

5.45.4 Assemble DC Assemble DC Power ConnePower Connectorctor 1414

66 Install RadioInstall Radio 1515

6.16.1 Install Multiple RadiosInstall Multiple Radios 1515

6.26.2 Assemble SinAssemble Single Pole Clamgle Pole Clamp (Optional)p (Optional) 1515

6.36.3 Hoist RadioHoist Radio 1616

6.46.4 Attach Radio to RAttach Radio to Railail 1717

6.56.5 Attach Radio to SAttach Radio to Single Pole Clingle Pole Clamp (Optional)amp (Optional) 1818

6.66.6 Connect CablesConnect Cables 1919

6.76.7 Optional ActionsOptional Actions 2626

77 VeVerify Radio Installation on rify Radio Installation on SiteSite 2828

7.17.1 Check SiteCheck Site 2828

7.27.2 Power Up RadioPower Up Radio 3131

7.37.3 Check Radio After Power UpCheck Radio After Power Up 3131

88 Perform Concluding RoutinesPerform Concluding Routines 3333

99 ReferencesReferences 3434

Contents

67/67/15153131-L-LZA ZA 70701 61 600001/1/1 1 UeUen n JJ||20201717-0-06-6-0606



Install Radio

6767/1/153531-1-LZLZA 7A 701 01 60600101/1 /1 UeUen n JJ||20201717-0-06-6-0606



11 IInnttrroodduuccttiioonn

This document describes how to install Radio 2219 on site.This document describes how to install Radio 2219 on site.

11..11 DDooccuummeennttaattiioonn

Make sure that the Make sure that the followingfollowing

documents are read and understood:documents are read and understood:

•• Personal Health and SafetyPersonal Health and Safety

InformationInformation

•• System Safety InformationSystem Safety Information

11..22 TToooollss

Table 1

Table 1lists the lists the required tools for installing the radio.required tools for installing the radio.

TTable able 1 1 TTools ools RequiredRequired

Product NameProduct Name

Electrostatic Discharge (ESD) wrist strap (staticElectrostatic Discharge (ESD) wrist strap (static

control wrist strap)control wrist strap)

Torque wrench 0.5–4 Nm, TORX® T20Torque wrench 0.5–4 Nm, TORX® T20

Torque wrench 5–25 Nm, TORX® T30Torque wrench 5–25 Nm, TORX® T30

Introduction

67/67/15153131-L-LZA ZA 70701 61 600001/1/1 1 UeUen n JJ||20201717-0-06-6-0606 11



Product NameProduct Name

Torque wrench 5–25 Nm, socket 10 mmTorque wrench 5–25 Nm, socket 10 mm

Torque wrench 5–25 Nm, socket 13 mmTorque wrench 5–25 Nm, socket 13 mm

Torque wrench 5–25 Nm, open-ended head 20 mmTorque wrench 5–25 Nm, open-ended head 20 mm

Torque wrench 5 Nm, open-ended head 22 mmTorque wrench 5 Nm, open-ended head 22 mm

Lifting deviceLifting device

11..33 CCoonnddiittiioonnss

The conditions in this section must The conditions in this section must be fulfilled before work starts.be fulfilled before work starts.

11..33..11 BBeeffoorre e GGooiinng g tto o tthhe e SSiittee

Before going to site, make sure of the following:Before going to site, make sure of the following:

•• Site access permission has been Site access permission has been received.received.

•• DocumentatiDocumentation stated on stated inin Documentation

Documentationon page 1 is available.on page 1 is available.

•• All applicaAll applicable tools stated inble tools stated in Table 1

Table 1are available.are available.

11..33..22 BBeeffoorre e SSttaarrttiinng g tthhe e IInnssttaallllaattiioonn

Before starting the installation, make sure of Before starting the installation, make sure of the following:the following:

•• The site is prepared according to the .The site is prepared according to the .

•• The ordered hardware is available.The ordered hardware is available.

Install Radio

2267/67/15153131-L-LZA ZA 70701 61 600001/1/1 1 UeUen n JJ||20201717-0-06-6-0606



•• The rail is installed on the site. For more information on how to install theThe rail is installed on the site. For more information on how to install the

rail, refer torail, refer to Install RailInstall Rail..

•• The power supply for the radio is installed and tested at the radio site.The power supply for the radio is installed and tested at the radio site.

•• The site grounding system is installed and tested.The site grounding system is installed and tested.

•• Either of the Either of the following alternatifollowing alternatives must be ves must be installed and tested:installed and tested:

–– A main switch anA main switch and an external fusd an external fusee

–– A circuit breakerA circuit breaker

Introduction

67/67/15153131-L-LZA ZA 70701 61 600001/1/1 1 UeUen n JJ||20201717-0-06-6-0606 33



22 WWoorrk k PPrroocceessss

Figure 1

Figure 1shows the work process for installing the radio.shows the work process for installing the radio.

Ge11051AGe11051A

Unpack and CheckUnpack and Check

MaterialsMaterials

Install Mounting BracketInstall Mounting Bracket

Verify RadioVerify Radio

InstallationInstallation

Power Up RadioPower Up Radio

Check RadioCheck Radio

After PAfter Power Upower Up

Perform ConcludingPerform Concluding

RoutinesRoutines

Install RadioInstall Radio

WWaalll l IInnssttaallllaattiioonnPPoolle e IInnssttaallllaattiioonn

Figure Figure 1 1 Radio Radio InstallatInstallation ion Work Work ProcessProcess

Install RadioInstall Radio

4467/67/15153131-L-LZA ZA 70701 61 600001/1/1 1 UeUen n JJ||20201717-0-06-6-0606



33 UUnnppaacck k aannd d CChheecck k MMaatteerriiaallss

The radio is transported in a The radio is transported in a corrugated box.corrugated box.

Note:Note: The radio must not be stored in an outdoor environment, even if it isThe radio must not be stored in an outdoor environment, even if it is

kept in its kept in its original packagingoriginal packaging. The packed radio can . The packed radio can only be keptonly be kept

outdoors during installationoutdoors during installation. After . After installationinstallation, it , it must be powered upmust be powered up

within 48 hours even if it is not within 48 hours even if it is not taken into service. The reason is totaken into service. The reason is to

protect the internal units from protect the internal units from local climate conditions.local climate conditions.

Do not dispose of the packaging as it can be required to return faultyDo not dispose of the packaging as it can be required to return faulty

equipment. For more information about handling faulty equipment, refer toequipment. For more information about handling faulty equipment, refer to

Handling Faulty EquipmentHandling Faulty Equipment..

StepsSteps

To unpack and check the materials:To unpack and check the materials:

1.1.

Ge8583A

Examine the packaging forExamine the packaging for

damage. If it is damaged,damage. If it is damaged,

immediately register a immediately register a complaintcomplaint

with the transport company. It iswith the transport company. It is

recommenderecommended that a d that a photo of thephoto of the

damages be taken to improve thedamages be taken to improve the

claims process.claims process.

2.2.

Ge8584A

Remove the straps from theRemove the straps from the

corrugated box.corrugated box.

Unpack and Check Materials

67/67/15153131-L-LZA ZA 70701 61 600001/1/1 1 UeUen n JJ||20201717-0-06-6-0606 55



3.3.

Ge6679C

Remove the tape from theRemove the tape from the

corrugated box.corrugated box.

Note:Note:

Make sure that the items in theMake sure that the items in the

corrugated box are not damaged.corrugated box are not damaged.

4.4. Check that the items deliveredCheck that the items delivered

correspond to the packing list.correspond to the packing list.

5.5.

Ge8585A

Remove the fitments.Remove the fitments.

6.6.

Ge11052AGe11052A

Remove the radio from the box,Remove the radio from the box,

and carefully place the radio onand carefully place the radio on

the ground on a clean, softthe ground on a clean, soft

surface, or on the surface, or on the packagingpackaging

material.material.

Note:Note:

Make sure to keep the radioMake sure to keep the radio

clean from moisture and dirt.clean from moisture and dirt.

Install Radio

6667/67/15153131-L-LZA ZA 70701 61 600001/1/1 1 UeUen n JJ||20201717-0-06-6-0606

Otros manuales de Radio de Ericsson

Ericsson

Ericsson MOBITEX BRU3 Manual de usuario

Ericsson

Ericsson MOBITEX BRU3 Instrucciones de instalación

Ericsson

Ericsson ORION Manual de usuario

Ericsson

Ericsson ORION Manual de usuario

Ericsson

Ericsson MDX SERIES Manual de usuario

Ericsson

Ericsson M-RK Series Manual de usuario

Ericsson

Ericsson MDX LBI-38848C Manual de usuario

Ericsson

Ericsson FMD 16 PLUS Manual de usuario

Ericsson

Ericsson DUAL FORMAT MDX LBI-38848B Manual de usuario

Ericsson

Ericsson LBI-38977D Manual de usuario

Ericsson

Ericsson RBS 2207 Hoja de instrucciones

Ericsson

Ericsson 2203 Instrucciones de funcionamiento e instalación

Ericsson

Ericsson MDX SERIES Manual de usuario

Ericsson

Ericsson LBI-38701 Manual de usuario

Ericsson

Ericsson EDACS MDX Manual de usuario

Ericsson

Ericsson MDX GE-MARC Manual de servicio

Ericsson

Ericsson MDX LBI-39015C Manual de usuario

Ericsson

Ericsson LBI-39012A Manual de usuario

Ericsson

Ericsson M-RK I Instrucciones de instalación

Ericsson

Ericsson LBI-38950 Manual de usuario

Ericsson

Ericsson EDACS ORION Manual de usuario

Ericsson

Ericsson mRRUS 12 Manual de usuario

Ericsson

Ericsson MDX LBI-39015 Manual de usuario

Ericsson

Ericsson LBI-39015B Manual de usuario

Manuales populares de Radio de otras marcas

EisSound

EisSound KBSound iSelect Manual de usuario

Midland

Midland 1001LWX Manual de usuario

Konig

Konig HAV-SR41 Manual de usuario

Roberts

Roberts exprssion Manual de usuario

VDigi

VDigi DD3.0 Manual de usuario

Radio Shack

Radio Shack 21-1863 Manual de usuario

Roberts

Roberts Stream 207 Manual de usuario

Sony

Sony Walkman SRF-M97 Manual de usuario

Stanley

Stanley FatMax FMC770 Manual de usuario

auna

auna DAB-Radio 10026947 Manual de usuario

SOUNDMASTER

SOUNDMASTER UR190 Manual de usuario

HYT

HYT TC-320 Manual de usuario

auna multimedia

auna multimedia Yellowstone 10026851 Manual de usuario

B-Tech

B-Tech GMRS-V2 Manual de usuario

Weierwei

Weierwei VEV-V8 Manual de usuario

SOUNDMASTER

SOUNDMASTER DAB750 Manual de usuario

Telefunken

Telefunken TF-1505 Manual de usuario

Makita

Makita LXRM03 Manual de usuario