Ericsson Monogram Series Manual de usuario
Ericsson Inc.
Private Radio Systems
Mountain View Road
Lynchburg, Virginia 24502
1-800-528-7711 (Outside USA, 804-528-7711) Printed in U.S.A.
3. Insert the remaining charger units into the enclosure and insert their
respective AC power cord plugs into the receptacles of the AC Outlet
Strip (see Figure 2, view A).
Perform the following steps (Steps 4 thru 6) to ensure
that the charger units function prior to installing the top
retaining cover on the enclosure.
NOTE
4. Place the enclosure into position where it will be used and connect the
AC power cord plug from the AC Outlet Strip to a 110 VAC power
source.
5. Press the power switch on the AC Outlet Strip to the ON position.
6. Insert a
Monogram
Series MPG 300 radio unit into each of the
charger slots and verify that the corresponding indicators light.
7. Install the top retaining cover and secure with two screws (see Figure
2, view B). Ensure that no cabling is pinched or damaged when the
cover is secured.
8. Install the four self-adhesive rubber feet to the bottom of the enclosure.
VIEW A VIEW B
Figure 2 - Assembly Instructions
ericssonz
LBI-39009
Installation Manual
Monogram
Series
DUAL RATE
MULTI-CHARGER
(6-UNIT) KIT
MHCH3W
2
TABLE OF CONTENTS
UNPACKING ................................................................................. 3
ASSEMBLY .................................................................................... 3
This manual is published by Ericsson Inc., without any warranty.
Improvements and changes to this manual necessitated by typographical
errors, inaccuracies of current information, or improvements to programs
and/or equipment, may be made by Ericsson Inc., at any time and without
notice. Such changes will be incorporated into new editions of this manual.
No part of this manual may be reproduced or transmitted in any form or by
any means, electronic or mechanical, including photocopying and
recording, for any purpose, without the express written permission of
Ericsson Inc.
Copyright© October 1993, Ericsson GE Mobile Communications Inc.
3
UNPACKING
When unpacking, be sure all parts are included. The following material
should be part of the kit.
•
Six (6) Dual Rate Charger Units - MHCH3V
•
One (1) Enclosure with retaining cover
•
Two (2) Machine screws with washers and nuts: No. 10-16 x 2.5"
•
Two (2) Thread forming screws: No. 10-16 x 3/4" or (machine screws)
•
One (1) AC Outlet Strip
•
Four (4) self-adhesive rubber feet
ASSEMBLY
REQUIRED TOOLS
•
Phillips screwdriver
•
Pliers or 1/4' nutdriver
ASSEMBLY
1. Install the AC Outlet Strip to the bottom of the enclosure using the two
machine screws. Insert the machine screws from the bottom of the
enclosure through the two holes and through the mounting holes of the
AC Outlet Strip. Use a washer and a nut on each screw and tighten
securely (see Figure 1, view A).
2. Insert one of the Dual Rate Charger Units into the enclosure and insert
its AC power cord plug into one of the receptacles of the AC Outlet
Strip (see Figure 1, view B).
VIEW A VIEW B
Figure 1 - Assembly of 6-Unit Charger
2
TABLE OF CONTENTS
UNPACKING ................................................................................. 3
ASSEMBLY .................................................................................... 3
This manual is published by Ericsson Inc., without any warranty.
Improvements and changes to this manual necessitated by typographical
errors, inaccuracies of current information, or improvements to programs
and/or equipment, may be made by Ericsson Inc., at any time and without
notice. Such changes will be incorporated into new editions of this manual.
No part of this manual may be reproduced or transmitted in any form or by
any means, electronic or mechanical, including photocopying and
recording, for any purpose, without the express written permission of
Ericsson Inc.
Copyright© October 1993, Ericsson GE Mobile Communications Inc.
3
UNPACKING
When unpacking, be sure all parts are included. The following material
should be part of the kit.
•
Six (6) Dual Rate Charger Units - MHCH3V
•
One (1) Enclosure with retaining cover
•
Two (2) Machine screws with washers and nuts: No. 10-16 x 2.5"
•
Two (2) Thread forming screws: No. 10-16 x 3/4" or (machine screws)
•
One (1) AC Outlet Strip
•
Four (4) self-adhesive rubber feet
ASSEMBLY
REQUIRED TOOLS
•
Phillips screwdriver
•
Pliers or 1/4' nutdriver
ASSEMBLY
1. Install the AC Outlet Strip to the bottom of the enclosure using the two
machine screws. Insert the machine screws from the bottom of the
enclosure through the two holes and through the mounting holes of the
AC Outlet Strip. Use a washer and a nut on each screw and tighten
securely (see Figure 1, view A).
2. Insert one of the Dual Rate Charger Units into the enclosure and insert
its AC power cord plug into one of the receptacles of the AC Outlet
Strip (see Figure 1, view B).
VIEW A VIEW B
Figure 1 - Assembly of 6-Unit Charger
Ericsson Inc.
Private Radio Systems
Mountain View Road
Lynchburg, Virginia 24502
1-800-528-7711 (Outside USA, 804-528-7711) Printed in U.S.A.
3. Insert the remaining charger units into the enclosure and insert their
respective AC power cord plugs into the receptacles of the AC Outlet
Strip (see Figure 2, view A).
Perform the following steps (Steps 4 thru 6) to ensure
that the charger units function prior to installing the top
retaining cover on the enclosure.
NOTE
4. Place the enclosure into position where it will be used and connect the
AC power cord plug from the AC Outlet Strip to a 110 VAC power
source.
5. Press the power switch on the AC Outlet Strip to the ON position.
6. Insert a
Monogram
Series MPG 300 radio unit into each of the
charger slots and verify that the corresponding indicators light.
7. Install the top retaining cover and secure with two screws (see Figure
2, view B). Ensure that no cabling is pinched or damaged when the
cover is secured.
8. Install the four self-adhesive rubber feet to the bottom of the enclosure.
VIEW A VIEW B
Figure 2 - Assembly Instructions
ericssonz
LBI-39009
Installation Manual
Monogram
Series
DUAL RATE
MULTI-CHARGER
(6-UNIT) KIT
MHCH3W
Otros manuales para Monogram Series
3
Este manual sirve para los siguientes modelos
1
Otros manuales de Cargador de baterías de Ericsson
Ericsson
Ericsson 344A3072P8 Manual de usuario
Ericsson
Ericsson Monogram MHMA5C Manual de usuario
Ericsson
Ericsson LBI-38707 Manual de usuario
Ericsson
Ericsson LBI-38706B Manual de usuario
Ericsson
Ericsson BML 161 51/022 Manual de usuario
Ericsson
Ericsson M-RK 344A4616P1 Guía del administrador
Ericsson
Ericsson M-RK Guía del administrador
Ericsson
Ericsson 19B801507P2 Manual de usuario
Ericsson
Ericsson BML 161 54/1 Manual de usuario
Ericsson
Ericsson MASTR III 344A3168P1 Manual de usuario
Ericsson
Ericsson BML 161 51/022 Manual de usuario
Ericsson
Ericsson BML 161 66/2 Guía de configuración
Ericsson
Ericsson Monogram MHCH3W Manual de usuario
Ericsson
Ericsson BML 161 51/022 Manual de usuario
Ericsson
Ericsson 344A3072P1 Manual de usuario
Ericsson
Ericsson BML 161 59/1 Manual de usuario
Ericsson
Ericsson 19B801507P1 Manual de usuario
