If you find the last piece of paper can't be cut completely.please adjust
according to Knife shim adjustment method.
Check whether there is any foreign matter on the guiding rod;
Pull out the front covering strip, and check stepping motor, to see
whether the synchranous pulley and synchronous belt are fixed
normal;
Adjust the support chip on the screw, and you can move it back
and forth until digital display dimension matches measuring scale
dimensian, then lock the retaining screw firmly.
Cut the electricity power;
Cut the electricity power;
Disassemble retaining screws on both sides of the upper cover, and
then take the upper cover away;
Loose seven M6 fasten screws on the blade which is on blade carrie,
and adjust screws of adjusting blade depth on blade carrier,until the
blade cuts into cutting stick about 0.3-0.5 mm;
Tighten up fasten screws on blade carrier, put on the upper cover,then
fix up；
Choose one piece of paper to have a trial cut. If it cannot be cut
completely, you can readjust according to the processes above.
Open the upper cover;
Loose the notched fasten screw on the blade carrier, revolve the two
screw stems clockwise, and then fix up and lock firmly;
Take away other fasten screws on the blade carrier;
Revolve the two screw stems anticlockwise 180°, then take out the
blade. Please wear gloves or use cotton cloth to wrap the blade to
avoid scratch;
※ Note:
Dull blade can't cut paper correctly.
Also, blade will become dull if it always cuts thick paper or pasteboard.
If cutting quality and accuracy can't meet required standard, the blade
needs to be changed. Your work will go smoothly if you always have
one replacement on hand.
When you need to change blade, you must operate according to the
steps of blade change instruction.
2.Basic adjustment
2-1 Cut the electricity power;
2-2 Cutting power adjustment
2-3 Knife blade change
5
