Equinox Systems Micro-ISP IV Series Manual de usuario

Serial Programming Systems

for the Atmel 89S, AT90S (AVR) &

ATmega microcontroller families

USER

GUIDE

(Version 2.03)

FIRMWARE

UPGRADABLE

This datasheet has been downloaded fromhttp://www.digchip.com at this page

Micro-ISP Series IV User Manual V2.03

AtmelTM and AVRTM are trademarks of the Atmel Corporation

Microsoft, MS-DOS, WindowsTM and Windows 95TM Windows NT™ are registered

trademarks of the Microsoft Corporation

IBM, PC and PS/2 are registered trademarks of International Business Machines

Corporation

Every effort was made to ensure accuracy in this manual and to give appropriate credit to

persons, companies and trademarks referenced herein.

or copied only in accordance with the terms of

the agreement.

It is against the law to copy the software on any

medium except as specifically allowed in the

license or non-disclosure agreement.

The purchaser may make one copy of the

software for backup purposes. No part of this

manual may be reproduced or transmitted in any

form or by any means, electronic, mechanical,

including photocopying, recording, or

information retrieval systems, for any purpose

other than for the purchaser’s personal use,

without written permission.

Equinox guarantees that its products will be

free from defects of material and

workmanship under normal use and service,

and these products will perform to current

specifications in accordance with, and subject

to, the Company’s standard warranty which is

detailed in Equinox’s Purchase Order

Acknowledgment.

Equinox reserves the right to change

specifications detailed in this document

without notice and does not represent a

commitment on the part of the manufacturer.

The software described in this document is

furnished under license agreement or

non-disclosure agreement

and may be used

Disclaimer

Please note about diagrams contained

within this document:

Whilst suggested circuits are offered in

good faith, Equinox will not be liable in

any way for any problems which might

arise out of their use.

The Micro-ISP Programmer is a CE Approved Product. It is designed only for use in a

development environment only. This means that the user must ensure that there is no

possibility of damage from electrostatic discharge (ESD). Since the devices and equipment to

which this product is likely to be connected may well themselves be susceptible to ESD, this

should not pose any difficulty.

For example, if you are handling microcontrollers and EEPROMS etc. then you will already be

used to appropriate precautions, such as the use of anti-static mats, wrist straps and so on.

You should treat your Micro-ISP with the same care as you would these type of device.

Always ensure that you are not yourself carrying a static charge before handling the product.

Wearing an earthed anti-static wrist strap is recommended.

Equinox have taken great care in designing this product to be compliant with the European

EMC directive. When using the equipment be sure to follow the instructions provided.

Although RF emissions are within prescribed limits, care should be taken if you are using the

product near to sensitive apparatus. If you experience any difficulty please refer to Equinox

technical support.

ESD Points to remember

●Work in a static-free environment.

●Wear an earthed wrist strap when handling either the programmer

and/or any programmable device.

Micro-ISP Series IV User Manual V2.03

Electromagnetic Compatibility (EMC) Compliance

Please Note:

This equipment is designed for use in a ‘Development Environment’ only and is

NOT guaranteed to operate correctly in a ‘Production Environment’.

Use of this product in a ‘Production Environment’ will invalidate your warranty.

Micro-ISP Series IV User Manual V2.03

iii

It is often the case that users experience problems when installing or using a product for the first time.

Due to the low-cost nature of this product, Equinox are unable to answer technical support questions

about this product or its use by telephone.

If you have a technical support problem, please consult the following list for help:

1This manual

2 Troubleshooting Guide (see page 28)

3On-line help

Press <F1> for help at any time.

The help system is context-sensitive. Simply press <F1> on any error message and the possible

causes of the error should be listed. This help system is updated on a regular basis. Please see

software update details for information on keeping up-to-date with software revisions.

4 Internet Web Site

Equinox have setup an AVR™ microcontroller support page on our web site. This page is designed

to provide up-to date information on all issues concerning both AVR™ microcontrollers and support

tools.

The microcontroller support page can be found at: www.equinox-tech.com/avr

5 E-mail

Please e-mail any technical support questions about this product to: micr[email protected]

Equinox will try our best to answer your questions about this product as quickly as possible.

However, we can not promise an immediate reply. Please consult our web site for new software

updates as the problem that you are enquiring about may have already been fixed in a new version.

6 Fax

Please fax any technical support questions about this product to: +44 (0) 1204 535555

Equinox will try our best to answer your questions about this product as quickly as possible.

However, we can not promise an immediate reply. Please consult our web site for new software

updates as the problem that you are enquiring about may have already been fixed in a new version.

Technical Support

Micro-ISP Series IV User Manual V2.03

Contacts

Equinox Technologies UK Limited

3 Atlas House, St Georges Square, Bolton, England BL1 2HB

Telephone Sales ....................... : +44 (0) 1204 529000

Fax ........................................... : +44 (0) 1204 535555

E-mail ...................................... : [email protected]

Web site .................................. : www.equinox-tech.com

For technical support on this product please e-mail us at:

[email protected]

In line with our policy of continuous improvement, the ‘Meridian for Windows™’ software is

updated on a regular basis. The firmware of the actual programmer is also periodically

updated. If you would like to receive an automatic e-mail every time a new version is

released, please make sure you have registered your system with Equinox and you have

quoted your e-mail address. You may cancel this service at any time.

The Meridian software updates can currently be downloaded from the following

places:

Internet : www.equinox-tech.com

Select <software> this will take you to the software download page

Software Updates

Micro-ISP Series IV User Manual V2.03

About AVR Microcontrollers

Atmel manufacture a complete family of AVR and 89S microcontrollers each with

differing FLASH, EEPROM, SRAM and number of I/O pins. Data sheets for these

devices can be viewed and printed using the Acrobat pdf reader software supplied

on the Atmel CD-ROM. As data sheets are often updated on a regular basis, it is

recommended that you consult the Atmel web site for the latest information.

A few sources of further information about Atmel AVR microcontrollers are listed

below:

Atmel web site : www.atmel.com

Equinox web site : www.equinox-tech.com/avr

If you have any silicon related technical support question about AVR and 89S

microcontrollers which can not be answered by looking at the Atmel/Equinox web

sites, please e-mail:

AVR - [email protected]

89S - [email protected]

with a detailed description of the problem.

Important - Please note

Equinox Technologies are unable to answer direct technical support questions

concerning AVR microcontrollers. Please contact your local Atmel distributor or sales

office if you require any further information.

Micro-ISP Series IV User Manual V2.03

Contents

Introduction.........................................................................1

Device Support....................................................................2

System Specifications .........................................................3

Hardware Overview ...........................................................4

Hardware/Software Installation Overview ......................5

Meridian for Windows Overview......................................6

Hardware Installation Instructions....................................7

Serial Port Selection............................................................8

Software Overview.............................................................9

Device Programming Guide .............................................11

In-System Programming Overview..................................18

ISP Header Pin Assignments ............................................19

ISP Cable Convertor ..........................................................20

Target System Requirements ...........................................21

Atmel AT89S/89LS - ISP Notes..........................................22

Atmel ATmega103/603 - ISP Notes..................................24

Atmel AT90S/ATtiny - ISP Notes ......................................25

Upgrading the Programmer Firmware............................26

Micro-ISP Compatible Target Systems.............................27

Troubleshooting Guide.....................................................28

Micro-ISP Series IV User Manual V2.03

Introduction

The Micro-ISP is a state-of-the-art device

programmer supporting the new range of

In-System Programmable (ISP)

microcontrollers from Atmel. These

microcontrollers feature serially

downloadable memory allowing both CODE

and DATA (if device features EEPROM) areas

to be updated in-system without physically

removing the target device from the

application board. The serial programming

is based around the industry standard SPI

protocol which is a 3-wire bus featuring

two data lines and a clock line.

The Micro-ISP programmer currently

supports the Atmel 89S, AVR™(90S),

ATmega and ATtiny microcontroller families

as standard.

The Micro-ISP programmer features

extremely fast programming speeds due to

the use of dedicated hardware to generate

the SPI waveforms.

Please Note:

This programmer is designed for development

use only.

MICRO-ISP DEVICE

PROGRAMMER HIGHLIGHTS

•State-of-the-art Device Programmer

•Supports In-System Programming (ISP)

of:

•Atmel 89S microcontroller family

•Atmel AVR(90S) microcontroller family

•Atmel ATmega microcontroller family

•Atmel ATtiny microcontroller family

•Powerful Windows Interface Software -

Meridian compatible with Win3.1, 95,

98 & NT

•Device Manufacturer Certification for

many algorithms

•Connects to spare PC Serial Port

•Straightforward hardware/software

installation

•Supports programming of security lock

bits

•The programmer firmware is field

upgradable allowing new devices and

enhancements to be added in the future

FAST programming times due to:

•Enhanced serial programming

algorithms

•SPI programming waveforms generated

by dedicated hardware

Two versions of the programmer are

available:

•Standard voltage : UISP-S4 (4.8-6.0V)

•Low voltage : UISP-LV4 (3.3-6.0V)

Micro-ISP Series IV User Manual V2.03

Device Support

ATMEL 89S FLASH Microcontroller Family

AT89S8252

AT89S53

AT89LS8252

AT89LS53

Atmel AVR ‘Classic’ Microcontroller Family

Atmel ATmega FLASH Microcontroller Family

ATmega103

ATmega603

Atmel Tiny FLASH Microcontroller Family

ATtiny22

AT90S1200

AT90S1200A (same as AT90S1200

with RCEN Enabled)

AT90S2313

AT90S2323

AT90S2333

AT90S2343

AT90S4414

AT90S4434

AT90S8515

AT90S8535

AT90LS2333

AT90LS4433

AT90LS4434

AT90LS8535

ATmega103L

ATmega603L

Caution. Make sure you do not exceed the maximum voltage of the target device.

Please note: Only ATtiny devices which feature a ‘Low Voltage Serial Programming

Mode’ are supported.

Micro-ISP Series IV User Manual V2.03

System Specifications

Minimum System Contents

The Micro-ISP Series IV programmer is available as either a +5V or low voltage version. The

minimum system contents for both versions are as follows:

• Micro-ISP Serial Download Programmer • PC Serial extension cable set

• Windows Driver Software • Atmel CD-ROM

• ISP Cable convertor

Micro-ISP Serial Programmer Specifications

Programmer Size : 55 x 53 x 16mm

Shipped Weight : Approx 0.10kg

PC Connection : Serial Port 25-pin female D Connector

Programming Cable : Length 300mm

Header : 10-way IDC 0.1” pitch bump polarised

Power Supply : Requires power from target system or external power supply.

Series IV Vcc. 4.8 - 6.0V

- Is(supply) approx 50mA when programming

- Is(supply) approx 27mA in standby

Series IV LV Vcc. 3.3 - 6.0V

- Is(supply) approx 36mA when programming @ 3.3V

- Is(supply) approx 22mA in standby @ 3.3V

- Is(supply) approx 70mA when programming @ 5V

- Is(supply) approx 37mA in standby @ 5V

Minimum PC requirements

The minimum hardware and software requirements to ensure that the programmer operates

correctly are as follows:

• 100% IBM compatible 386+ • Minimum 1MB free hard disk space

• Windows 3.1 or higher • Spare PC serial port

• Minimum 4MB RAM

Tabla de contenidos

Otros manuales de Placa madre de Equinox Systems

Equinox Systems

Equinox Systems ISPnano IV-ATE Series Instrucciones de uso

Equinox Systems

Equinox Systems GEMINI-1 Manual de usuario

Equinox Systems

Equinox Systems FS2003 Manual de usuario

Equinox Systems

Equinox Systems Epsilon 5 Manual de usuario

Equinox Systems

Equinox Systems ISP juno Manual de usuario

Equinox Systems

Equinox Systems PPM3 MK2 Manual de usuario

Equinox Systems

Equinox Systems AVR Professional Starter System Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario