Equator PFL 255 Manual de usuario
OWNER’S MANUAL
Model - PFL 255
Portable Fireplace
with LED Light
Please read the instructions carefully and keep for future reference. Information may be
updated from time to time so please refer to website for the latest version of the manual.
Breakage of glass
Equator
Equator
Equator
1
Equator Appliances
Equator
2
ALWAYS keep electric cords, home furnishings, drapes, clothing, papers,
or other combustibles at least 3 feet away from all sides of the appliance.
DO NOT place the appliance near a bed because objects such as pillows or
blankets can fall off the bed and be ignited.
DO NOT COVER or block the air vents of the appliance. Doing so could cause
a fire.
AVOID fire or electric shock! NEVER insert or allow any foreign objects to
enter the ventilation or exhaust openings of the appliance.
Prevent Fire! Keep all flammable liquids, like gasoline or paint, away from the
appliance. The fireplace produces arcing sparks that could ignite
flammable liquids.
DO NOT cover the appliance in any manner. Doing so could block the air flow
and cause the unit to overheat or could ignite the material covering it.
NEVER run the power cord under carpet, rugs, runners, or any other covering.
Doing so could cause the cord or materials covering the cord to overheat.
AVOID FIRE! Regularly inspect all air vents to make sure they are free from dust,
lint, or other blockage. Unplug the unit and clean with a vacuum ONLY.
DO NOT rinse or get it wet.
SAFETY INFORMATION
Read this manual before installing and operating this appliance.
Failure to follow these instructions may result in electric shock, fire property,
or personal injury.
.
.
.
.
.
.
.
WARNING
.
Use only the electric insert and included mantel. NEVER use a mantel
from another maker.
NEVER use this electric fireplace insert unless it is properly installed in the
correct mantel.
Use extreme caution if using the appliance near children, or where children
may be present.
NEVER leave the appliance unattended. ALWAYS unplug it when not in use.
The appliance is hot when in use. AVOID INJURY! DO NOT TOUCH hot
surfaces or attempt to move it while it is hot.
WARNING
.
.
.
.
Do not store or use gasoline or other flammable liquids in vicinity of this appliance.
.
For residential use only! NOT for commercial use!
NEVER use this fireplace for other than its intended purpose.
3
ALWAYS turn the appliance off before unplugging it from the outlet.
AVOID INJURY! Keep the cord from crossing traffic areas to avoid tripping
NEVER modify this fireplace. Doing so could result in personal injury or
property damage. Modification of this fireplace completely voids all warranties.
Discontinue use if this fireplace malfunctions or is dropped or damaged in
any manner.
NEVER place any objects on top of this mantel. Any object placed on top may
cause it to tip over.
NEVER sit, stand, or climb on this electric fireplace. Doing so could cause
the unit to tip over, resulting in serious personal injury or property damage.
.
.
.
.
.
.
.
.
.
.
WARNING
Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside!
ALWAYS disconnect this unit from the power supply before performing any
assembly or cleaning, or before relocating the electric fireplace.
ALWAYS store the appliance in a dry location. NEVER use the fireplace if it has
become wet.
NEVER use the appliance in bathrooms, laundry rooms, or any other location
where the heater could fall into a bathtub or pool, become damp or come in
contact with water.
NEVER hang this unit on a wall directly below an electrical outlet.
NEVER operate the appliance if the power cord or plug has become damaged,
or if the grounding pin is damaged or missing.
ONLY use this heater on a 110V 15 Amp grounded circuit. NEVER overload
the circuit. If the appliance trips the circuit breaker, unplug all other appliances
on the same circuit before the next use. Avoid plugging other appliances into the
same circuit as the fireplace.
NEVER plug the appliance into an outlet that is old, cracked, or has any loose
wires or connections. Plugging into a faulty outlet could result in electric
arcing within the outlet that could cause the outlet to overheat or catch fire.
ALWAYS check the cord and plug connections with each use!
1. MAKE SURE the plug fits tight in the outlet! Faulty wall outlet connections or
loose plugs can cause the outlet to overheat.
2. Heaters draw more current than small appliances. Overheating may occur
even if it has not occurred with the use of other appliances.
3. During use check frequently to see if the plug outlet or faceplate is HOT!
4. If the outlet or faceplate is HOT, discontinue use immediately and have a
qualified electrician inspect and/or replace the faulty outlets.
.
.
.
.
.
4
PREPARATION
Failure to do so could result in personal injury or property damage.
Tools required for assembly:
Phillips screwdriver (not included)
This appliance has a front panel made of GLASS!
ALWAYS use extreme caution when handling glass.
The following accessories and parts are included with the fireplace:
remote control, wheels (4) and wheel screws (16).
Install the wheels as shown.
Turn the mantel over on a soft level surface. Align the holes in each
wheel with the holes in the mantel. Thread wheel screws through
each hole and into the mantel. Tighten securely with a
Phillips screwdriver. DO NOT OVER-TIGHTEN.
WARNING! This fireplace has wheels. NEVER use near stairs
or ramps, or on unlevel surfaces. Doing so could cause the
fireplace to roll away and cause personal injury or
property damage.
5
Place Fireplace on a smooth flat surface, leaving 3 feet of space
all around it.
After attaching the wheels please make sure to LOCK the wheels
so the fireplace does not move.
Attaching the wheels is optional. If the wheels are attached, they must
be locked to prevent the appliance from moving once it is in place.
OPERATION and SAFETY
Read and understand this entire owner’s manual, including all
safety information, before plugging in or using this product.
Failure to do so could result in electric shock, fire, serious injury,
or death.
Power
Make sure the ON/OFF switch, located on the control panel, is in the
OFF position. Plug the power cord into a 110V / 60Hz 15 Amp
grounded outlet. Make sure the outlet is in good condition and the
plug is not loose. NEVER exceed the maximum amperage for the
circuit. DO NOT plug other appliances into the same circuit.
Temperature Limiting Safety Feature
This appliance is equipped with a Temperature Limiting Safety
Feature. Should the appliance reach an unsafe temperature
o o
(212 F / 95 C), the appliance will automatically turn OFF.
If the fireplace tips over, the appliance will automatically turn Off.
This is another safety feature.
To reset :
1. Unplug the power cord from the outlet.
2. Turn the ON/OF switch on the CONTROL PANEL to OFF. Wait
15 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged
with dust or lint. If they are, use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord
back into the outlet.
5. If it switches off again, UNPLUG THE APPLIANCE RIGHT AWAY!
Have the outlets, wiring, and breaker box inspected by a
professional. Make necessary repairs before using the appliance.
6
Button
Function
Action
Power button: Turns the unit ON and OFF.
Press once. Indicator light turns on.
Power turns on. All functions enabled.
Heater turns on and blows warm air.
TIMER button: Controls timer settings to
turn off fireplace at a selected time. The
time can be selected from 30 mins to 9
hours.
2. Press again until desired setting is
reached. LED display shows the time.
1. Press once. Indicator light turns on.
FLAME button: Control the flame color and
brightness level.
2. Press for 5 seconds for the flame to get
brighter.
1. Press for 3 seconds to change the
flame color.
HEAT button: Controls the temperature.
1. Press for 5 seconds to select the
o
desired temperature setting.(65-95 F)
2. Press repeatedly to select the
temperature.
TEMPERATURE button to increase heat.
(On Remote Control Only)
Press to increase the heat output.
(On Remote Control Only)
TEMPERATURE button to decrease heat.
Press to decrease the heat output.
Control Panel and Remote
The control panel is in the upper right corner of the appliance.
Display Indicator
Light
Temp Flame Timer Power
Temperature increase and decrease buttons on Remote only
7
Operation
Once the appliance is in place, it is ready to use.
Ensure there is at least 3 feet of space all around the fireplace.
Power On/Off
Press the Power On/Off button on the Control Panel to turn on the
Fireplace. It can also be turned on with the Remote Control.
Timer
The Fireplace can be set to turn off by pressing the Timer button on
the Control Panel or on the Remote Control. The Timer can be set
from 30 minutes to 9 hours. Press to increase from 30 minutes to
1 hour and then in 1-hour increments. The Indicator Light will
illuminate on the Control Panel and as the time is selected, it will
show on the Control Panel Display.
Flame
The Flame button can change the colors and the brightness in the
fireplace. The Indicator Light and flame selection will show on the
Control Panel Display.
· Press the button for 3 seconds to select from 7 colors: Orange,
green, blue, white, green/orange, blue/pink, yellow.
· Press the button for 5 seconds to increase the brightness of the
fireplace logs and flames. There are 5 levels of brightness, from
dim to very bright.
Heat
The Heat button can be used to select the temperature of the
fireplace from 65 – 95˚F. Press it for 5 seconds to select the desired
temperature. The Indicator Light and temperature will show on the
Control Panel Display.
Remote Control
All the functions on the Control Panel can also be selected from the
Remote Control. In addition, there are Up and Down arrow buttons
on the Remote which control the temperature to increase or decrease.
8
CARE AND MAINTENANCE
ALWAYS turn the appliance OFF and unplug the power cord from the
outlet before cleaning, performing maintenance, or moving this
fireplace. Failure to do so could result in electric shock, fire, or
personal injury.
Risk of electric shock! DO NOT OPEN! No user-servicable
parts inside!
NEVER use abrasive cleansers, liquid sprays, or any cleaner
that could scratch the surface. Clean the exterior of the
fireplace with a slightly damp cloth or duster.
Electrical components are integrated in the fireplace and are not
serviceable by the customer.
Storage: Store the apppliance in a clean dry place when not in use.
NEVER immerse in water or spray with water. Doing so could
result in electric shock, fire, or personal injury.
Metal: Buff using a soft cloth, slightly dampened with a citrus
oil-based product. DO NOT use brass polish or household
cleaners as these products will damage the metal trim.
Glass: Use a good quality glass cleaner and dry thoroughly with a
paper towel or lint-free cloth. NEVER use abrasive cleansers,
liquid sprays, or any cleaner that could scratch the surface.
Vents: Use a vacuum or duster to remove dust and dirt from the
heater and vent areas. Clean the exterior of the fireplace with
a slightly damp cloth or duster.
Wood:
9
Tabla de contenidos
