5
6
Specifications
9
10
11
9. Power Supply
The rgbw-mini-RF and rgbw-mini-RF-receiver work from
6-24V DC. The red power input cable should be connected
to power supply positive and black to negative. Always
make sure the power supply voltage is the same as the
rated LED voltage.
10. LED Output
The controller and receiver support constant voltage LED
products and control the load using a PWM output. The
black cable connects to LED positive. The red, green, blue
and white cables connect to the respective colored LEDs
11. Status Indicator
The indicator light displays the current status of the unit. It
indicates the following:
Blue: normal operation.
Short single white flash: new command executed.
Long single white flash: the user has cycled through all modes
or colors .
Long single yellow flash: The unit has reached maximum
speed or brightness.
Red flashing: overload protection active.
Yellow flashing: thermal protection active.
Operation
12. Using the Remote
Remove the battery insulation tape from the remote before
using. The RF wireless signal can pass through most non-
metallic barriers, although range may be reduced. Do not
install the controller or receiver inside a closed metal box.
13. Pairing New Remote
The remote and rgbw-mini-RF come already paired. One
rgbw-mini-RF can be paired with 5 remotes. Each remote can
be paired to an unlimited number of rgbw-mini-RF units.
To pair a new remote:
1). Power-off the rgbw-mini-RF for at least 5 seconds.
2). Power-on the rgbw-mini-RF, then press the ‘ON’ and
‘White Bright +’ key simultaneously within 5 seconds. Press
the ‘RED’ key immediately afterward.
The indicator will flash white 3 times to acknowledge the
pairing.
14. Programming Slave Receivers
The rgbw-mini-RF-receiver slave receiver can be programmed
to use zone 1, 2 or 3. Each zone can have an unlimited
number of receivers.
To pair a slave receiver:
1). With the controller powered-on, power-off the rgbw-mini-
RF-receiver for at least 5 seconds.
2). Power-on the rgbw-mini-RF-receiver, then press the ‘ON’
and ‘White Bright +’ key simultaneously within 5 seconds. The
indicator will flash blue.
3). Press the zone key for the desired zone. The indicator will
flash white 3 times to confirm zone assignment.
Advanced Features
15. Waterproofing
When installing at wet environment, the cable
connections must also be waterproofed. Waterproofing
glue and heat-shrink are recommended, but waterproof
connectors may also be used.
Wireless signals are attenuated by water, so wireless
range may be reduced if the receivers are installed
underwater. Be sure to test the wireless range before
permanently installing the receiver in water or very wet
locations.
16. Protection
The rgbw-mini-RF and rgbw-mini-RF-receiver have full
protection circuitry for short circuit, output overload,
reversed power polarity and overheating. The indicator will
flash red for overload or short circuit protection and flash
yellow for thermal protection. The controller will
automatically recover from protection when conditions return
to normal.
rgbw-mini-RF rgbw-mini-RF-receiver
Dynamic Modes
Static Colors
Color Resolution 256 levels
White Brightness
Color Brightness
Speed Adjustment
Overload Protection Yes
Thermal Protection Yes
Working Voltage 6-24VDC
Remote Frequency 433.92MHz None
Synchronization Frequency 2.4GHz ISM band
Remote Control Distance >15m in open area None
Synchronization Distance >15m in open area
Zone Control 3 zones, infinite receivers in each zone.
Rated Output Current 3x2.5A + 4A
IP Grade IP68 IP68
