Envirologix QUICKTOX FLEX Manual de usuario
QUICKTOX FLEX INCUBATOR INSTRUCTIONS
Remove incubator base and block from each of their respective boxes. Assemble by placing block into the
incubator base, and connecting the power cord. Be sure the unit is on a flat surface away from heat
sources, windows, etc.
Note. The block will fit snugly in the base. To make it easier to insert, try to make sure it is squared up
while getting started. It may take some force to get the block to slide in. Once inserted, continue to press
down so that the bottom of the block is in complete contact with the plate inside the base.
To set the incubator, flip the switch on
the back to the 'on' position. Unit will do
a system check, and the display will
default to P1 (program 1), indicating its
current temperature.
Use the "Shift" key () to move the cursor
over to the appropriate spot; use the up
and down arrows () to set the "tens"
digit to "2". Use the Shift key again to
move the cursor to the "ones" digit and
enter 2 as well. This sets the preferred
Though you should
not ever need to,
there is a tool
included in the
incubator base box
that can be inserted
and screwed into the
block to provide a
handle for pulling it
out of the base.
- 2 –
temperature to 22°C. As it is recommended to keep the unit ready and acclimated for use during any
time of the day, we recommend leaving the time set at the default, 000. Hit the "Start/Stop" button to set.
Unit will either heat or cool until reaching 22°; and until ready, the readout will read "NOTOK".
Once the correct temperature is within range, it will beep and the readout will change to "OK".
Run all Flex assays in the incubator. If the temperature of your room is between 20 and 24°C (68 and
75°F) you may skip the 2 minute sample acclimatization step. Set the test tubes in the incubator, extract
your sample, transfer extract to the tube along with buffer, and run the test in the incubator.
Remove strip immediately after test time and cut off the tailpad. Place the strip in paddle of the
QuickScan, slide in, and press "Read Test" on the QuickScan screen on the computer.
Doc. M231-1016 Questions? technicalservice@envirologix.com
Otros manuales de Accesorios de Envirologix
