Touchingo n 9
TOUCHING ON
Once you’ve switched on the Display Box by selectingyour weapon mode, the screen will
show the EnPointe logo to indicate that the system is ready for fencers to touch on.
If your weapon is plugged in and connected to your lamé in Foil and Sabre, you can
‘touch on’ (register) to the Display Box by holdingthe tip of your weapon near the
EnPointe logo below the screen.
The scrollingblue square outline will indicate that a touch on is in progress. This will
become a solid white square when the process is complete. This process should take less
than a second.
The fencer who touches on first will be allocated to the right-hand side of the piste. The
second fencer will be allocated to the left-hand side. You can swap any part of the
fencer’s equipment, includingwires or weapons, without needingto touch on again.
Now you’re ready to fence! There is no calibration routine required.
TIP
When touched on, the battery indicator light in the Pocket Boxes (viewed through
the sockets) indicates the side of the piste the Pocket Box is currently touched on
to. The colours correspond to the on-target light on that side of the piste. So, on
the EnPointe Display Box: red=left, green=right.
