Obsereve the following precautions without fail for safe operation of the equipment.
WARNING
1. When connecting cables to the terminals of the analyzer or when servicing inside the
analyzer, take care to avoid electric shock. When servicing electrical parts, be sure to turn
the power off.
2. Connect the grounding wire to prevent accidents caused by electric shock.
3. When fabricating the gas inlet/outlet pipes or disconnecting pipes for maintenance inside
the analyzer, be sure to shut off the gas source valve to prevent accidents caused by gas
intoxication or oxygen deficiency.
4. To prevent gas intoxication and oxygen deficiency, test gas leaks after fabricating the gas
inlet/outlet pipes or performing maintenance service of piping inside the analyzer.
Route the gas outlet at a safe place provided with the atmospheric pressure.
CAUTION
1. To prevent electric shock, before you turn on the power switch always check that the
power supply wiring is correctly and securely connected, and that the supply voltage
matches the power source voltage of this device.
2. To prevent gas intoxication or oxygen deficiency, before you open the gas source valve
always check that the gas inlet and outlet pipes of the analyzer are correctly and securely
connected, and check that there is no gas source valve.
3. To prevent burns, do not touch the transmission unit, sensor unit (detector, etc.) and their
periphery during operation and shortly after operation because there portions are very hot.
4. Be sure to close the gas source valve to perform maintenance services of the piping system
when the sample gas contains toxic contents to prevent gas intoxication.
5. Observe the cautions and operation methods described in this manual to operate this equipment
safety. If the description is neglected during operation of the equipment, electric shock, gas
intoxication, oxygen deficiency, burns, damage or deterioration of this equipment or damage to
the final product (device, etc.) may be caused.
Safety Precautions
