Endon YG- 8002 Manual de usuario

The Light pack contains:

Short Post Lantern with integral terminal block.

The following tools may be required:

Selection of cross and flat head screwdrivers.

Electric drill and assorted drill bits.

Wire strippers.

Electrical insulation tape.

INSTRUCTION MANUAL

This product is only suitable for connection to a 240V~50Hz supply.

It is recommended that this light is installed by a qualified electrician in accordance with current IEE

Wiring Regulations and local Building Regulations.

The light fitting should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp

miniature circuit breaker).

This light has an IP44 (splash proof) rating suitable for use outdoors.

Run supply wire from a 5-amp electrical supply using double insulated 3-core cable of type

H05RN-F1.0mm2(not supplied) to selected site, ensuring it is adequately protected through the full

length of the cable run, it must come out of the flat surface of the mounting surface in line with the

entry to the fitting.

Except where installed in a conduit or duct , which provides equivalent protection against

mechanical damage, a cable buried in the ground shall incorporate an earthed armour or metal

sheath or both, suitable for use as a protective conductor, or be of insulated concentric

construction. Buried cables shall be marked by cable covers or a suitable marking tape. Buried

conduits and ducts shall be suitably identified. Buried cables, conduits and ducts shall be at a

sufficient depth to avoid being damaged by any reasonably foreseeable disturbance of the ground.

This product contains breakable parts – be careful during handling and maintenance to avoid

breakage.

If the cover is broken or cracked then it must be replaced immediately to preserve the water ingress

protection, please consult your retailer. This is represented by the symbol

When fixing to the mounting surface ensure that the fixings used are appropriate for the mounting

surface on which they are being used and that the mounting surface is level and secure.

If any modification is made it will invalidate the warranty and may render the product unsafe.

Before you start

Please read these instructions carefully before fitting your new light and retain for reference.

Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit

breaker before commencing installation.

Ensure that no one else has access that would enable the supply to be inadvertently reconnected.

Ensure that there are no cables / pipes beneath the surface (other than the supply cable for this

fitting).

Check the packaging and make sure that you have all the required parts.

Follow each assembly step in order to prevent incorrect assembly

Make sure all screws / nuts, including electrical connections etc are fully tightened before use.

YG- 8002 Short Post Lantern.

Safety Warnings

Endon Lighting

LS9 0SE

These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.

Assembly / user instructions

20150309 W28 24

Diagram A

Diagram B

Diagram C

1. Determine the position of

your light fitting. Ensure

that there is sufficient

power cable to connect

to the fitting – we

recommend at least

20cm.

2. Diagram A. Locate the

terminal block bracket

inside the (short) post.

3. Diagram B. Connect the

mains supply cable to the

internal terminal block –

see wiring details.

IMPORTANT: This is a

Class I fitting and

MUST be earthed.

4. Diagram C and D.

Secure the post to the

mounting surface making

sure that the internal

cables are not trapped or

damaged. Fit the bulb –

never fit bulbs of a

higher wattage or of a

type other than those

specified on the label

as this may cause over

heating and damage

the fitting. Close and

secure the lid.

5. Turn on the power and

test.

Diagram D

Tabla de contenidos

Otros manuales de Luz exterior de Endon

Endon

Endon Pagoda PIR Outdoor Wall Light Manual de usuario

Endon

Endon YG-7501 Manual de usuario

Endon

Endon EL- 40119 Manual de usuario

Endon

Endon Dean 82013 Manual de usuario

Endon

Endon 67702 Roko Manual de usuario

Endon

Endon Cambridge Wall Light Manual de usuario

Endon

Endon EL- 40094 Manual de usuario

Endon

Endon Burford Manual de usuario

Endon

Endon EL-YG-5006 Manual de usuario

Endon

Endon EL-40065 Manual de usuario

Endon

Endon Leyton Manual de usuario

Endon

Endon YG-861-SS Manual de usuario

Endon

Endon EL-40098 Manual de usuario

Endon

Endon York 1lt Wall Manual de usuario

Endon

Endon Burford 76549 Manual

Endon

Endon Burford Manual de usuario

Endon

Endon 76983 Manual de usuario

Endon

Endon Roko Manual de usuario

Endon

Endon EL- 40101 Manual de usuario

Endon

Endon Elan 5lt Manual de usuario

Endon

Endon Canillo Manual de usuario

Endon

Endon Galina Flush Manual de usuario

Endon

Endon Middleton EL-40017 Manual de usuario

Endon

Endon 56410 Manual de usuario

Manuales populares de Luz exterior de otras marcas

Sealey

Sealey LED37 Manual de usuario

nordlux

nordlux VEJERS Guía del usuario

SImx

SImx ELITE LED LHTC637 Manual de usuario

GEV

GEV CAROLINE 10833 Manual de usuario

NEBO

NEBO NEB-LSP-0020 Manual de usuario

WE-EF

WE-EF PFL540 LED Manual de usuario

Lindby

Lindby 9949029 Manual de usuario

HEPER

HEPER DOGO Side LW6048.585-US Instrucciones de instalación y funcionamiento

HEPER

HEPER LW8034.003-US Instrucciones de instalación y funcionamiento

Maretti

Maretti VIBE S 14.6080.04.A Manual de usuario

BEGA

BEGA 84 253 Manual

HEPER

HEPER MINIMO Instrucciones de instalación y funcionamiento

LIGMAN

LIGMAN BAMBOO 3 Manual de usuario

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manual de usuario

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manual de usuario

urban ambiance

urban ambiance UQL1273 Manual de usuario

TotalPond

TotalPond 52238 Manual de usuario

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manual de usuario