Emerson SolaHD STC-DRS Series Manual de usuario

Surge Protective Devices

STC-DRS Series

DIN Rail Protection

Safety Information

Important Information

Read these instructions carefully and look at the equipment to become

familiar with the device before trying to install, operate, service or maintain it.

The following special messages may appear throughout thisbulletin or on the

equipment to warn of potential hazards or to call attention to information that

clarifies or simplifies a procedure.

The addition of either symbol to a “Danger”or “Warning” safety label

indicates that an electrical hazard exists which will result inpersonal

injury if the instructions are not followed.

This is the safety alert symbol. It is used to alert you to potential

personal injury hazards. Obey all safety messagesthat follow this

symbol to avoid possible injury or death.

DANGER

DANGER indicates a hazardous situation which, if not avoided,

will result in death or serious injury.

WARNING

WARNING indicates a hazardous situation which, if not avoided,

could result in death or serious injury.

CAUTION

CAUTION indicates a hazardous situation which, if not avoided,

could result in minor or moderateinjury.

NOTICE

NOTICE is used to address practices not related to physical injury. The safety

alert symbol shall not be used with this signal word.

Please Note

Electrical equipment should be installed, operated, serviced, and maintained only

by qualified personnel. No responsibility is assumed by Appleton Grp LLC d/b/a

Appleton Group for any consequences arising out of the use of this material.

A qualified person is one who has skills and knowledge related to the

construction, installation, and operation of electrical equipment andhas received

safety training to recognize and avoid the hazards involved.

Page: 1

STC-DRS Series

Introduction

The STCDRS036 is a DIN Rail mountable, single pair surge suppression module implementing three stage

hybrid technology. This module addresses over-voltage transients with gas tubes and silicon avalanche

components. In addition, sneak currents are mitigated with resetable fuses (PTCs). The PTCs increase

resistance several orders of magnitude when over-currents exceed operating limits. A normal state resumes

when the over-current condition is removed. The ability to self-restore in this manner signicantly increases

suppressor performance and survivability.

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

• Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E,

NOM-029-STPS or CSA Z462.

• This equipment must only be installed and serviced by qualied electrical personnel.

• Turn o󰀨 all power supplying this equipment before working on or inside equipment.

• Always use a properly rated voltage sensing device to conrm power is o󰀨.

• Replace all devices, doors and covers before turning on power to this equipment.

• This equipment must be e󰀨ectively grounded per all applicable codes. Use an equipment-grounding conductor to

connect this equipment to the power system ground.

• Conrm that the Surge Protective Device voltage rating on the module or nameplate label is not less than the

operating voltage.

• For 6-35VDC models, do not place in service on any signal line capable of continuously supplying

more than 150mA.

Failure to follow these instructions will result in death or serious injury.

WARNING: This product can expose you to chemicals including DINP, which is known to the State of California

to cause cancer, and DIDP which is known to the State of California to cause birth defects or other reproductive

harm. For more information go to: www.P65Warnings.ca.gov.

STC-DRS Series

Page: 2

NOTICE

HAZARD OF MIS-INSTALLATION

• Only install this protective device in indoor applications and on communication loop circuits which have been

isolated from the public switch telephone network (PSTN).

• Do not expose the communication loop to contact with the electric light or power conductors.

• Install the protectors as per the applicable requirements of the National Electric Code, ANSI/NFPA 70.

Failure to follow these instructions can result in equipment damage.

Installation

1. Turn off power prior to installing SPD.

2. Install SPD in suitable enclosure.

3. Connect load wires to output side of SPD.

4. Connect source wires to input side of SPD.

5. Do not exceed 150mA continuous current.

6. Turn on power and verify operation.

General Technical Specifications 0-36VDC Models

Operating Voltage 0-36 VDC

Breakdown Voltage 43 VDC

Operating Current 0.15 A

Peak Surge Current 10 kA (8x20µs)

Max Current Ip (Occurrences) >100 (10x1000µs)

Typical Capacitance 1500pf

Nominal Series Resistance 5 Ω

Response Time < 1 nanosecond

Operating Temperature -40°C to 85°C

Certiﬁcations UL 497B

Limited Warranty 5 years

Page: 3

STC-DRS Series

Field Side

(Line)

Load Side

(Load)

LINE

SHIELD

2.95

[74.9]

2.35

[59.7]

Ground

2.25

[57.2]

0.8

[20.3]

1.1

[27.9]

Wire Size Range = 22-12 AWG

Terminal Torque Rating = 0.8 Nm (7 in-lb)

Ordering Information

MODEL APPLICATION

STCDRS036 0-36 VDC

STC-DRS Series

Page: 4

Technical Support

Website: www.solahd.com

Technical Support E-Mail: solahd.technicalservices@emerson.com

Toll-Free: (800) 377-4384

USA: (847) 268-6651

Warranty

Please refer to the “Terms & Conditions of Sale” document.

While every precaution has been taken to ensure accuracy and completeness in this manual, Appleton Grp LLC d/b/a Appleton Group

assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions.

Page: 5

Notes

STC-DRS Series

A272-139 Rev. 3 12/2020

The Emerson logo is a trademark and service mark of Emerson Electric Co.

Appleton Grp LLC d/b/a Appleton Group. SolaHD is a registered trademark of Appleton Grp LLC.

United States

(Headquarters)

Appleton Grp LLC

9377 W. Higgins Road

Rosemont, IL 60018

United States

T +1 800 621 1506

Australia Sales Office

Bayswater, Victoria

T +61 3 9721 0348

Europe

ATX SAS

Espace Industriel Nord

35, rue André Durouchez,

CS 98017

80084 Amiens Cedex 2

France

T +33 3 2254 1390

China Sales Office

Shanghai

T +86 21 3338 7000

Canada

EGS Electrical Group Canada

Ltd.

99 Union Street

Elmira ON, N3B 3L7

Canada

T +1 888 765 2226

Middle East Sales Office

Dammam, Saudi Arabia

T +966 13 510 3702

Chile Sales Office

Las Condes

T +56 2928 4819

India Sales Office

Chennai

T +91 44 3919 7300

Korea Sales Office

Seoul

T +82 2 3483 1555

PN#9634_r

Asia Pacific

EGS Private Ltd.

Block 4008, Ang Mo Kio

Ave 10,

#04-16 TechPlace 1,

Singapore 569625

T +65 6556 1100

Latin America

EGS Comercializadora

Mexico S de RL de CV

Calle 10 N°145 Piso 3

Col. San Pedro de los Pinos

Del. Álvaro Obregon

Ciudad de México. 01180

T +52 55 5809 5049

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Protector contra sobretensiones de Emerson

Emerson

Emerson 500 Series Manual de usuario

Emerson

Emerson Interceptor II TVSS Manual de usuario

Emerson

Emerson STC-SLAC Series Manual de usuario

Emerson

Emerson SolaHD SPD200K Series Manual de usuario

Emerson

Emerson SP-6TVN Manual de usuario

Emerson

Emerson Islatrol RM-115-10R Manual de usuario

Emerson

Emerson Sola HD STV200K Series Manual de usuario

Emerson

Emerson PSS Surge Protector Manual de usuario

Emerson

Emerson AccuGuide ACGY1110808 Manual de usuario

Emerson

Emerson Liebert PSS NET 1080T Manual de usuario

Emerson

Emerson SOLAHD STV100K Series Manual de usuario

Emerson

Emerson SOLAHD STCPOE65FF Manual de usuario

Emerson

Emerson SOLAHD STCCAT6P0EI Manual de usuario

Emerson

Emerson 500 Series Manual de usuario

Emerson

Emerson PowerSure 350-500VA Manual de usuario

Emerson

Emerson SolaHD STC-642 Series Manual de usuario

Emerson

Emerson Liebert TYPE SS Manual de usuario

Emerson

Emerson IE Series Manual de usuario

Emerson

Emerson SolaHD STC-HSP Series Manual de usuario

Emerson

Emerson PowerSure PST Manual de usuario

Emerson

Emerson PanelGuard 65 Manual de usuario

Emerson

Emerson Liebert Precision Cooling Manual de usuario

Emerson

Emerson Liebert LM Series Manual de usuario

Emerson

Emerson Liebert XDF Manual de usuario

Manuales populares de Protector contra sobretensiones de otras marcas

ELAC

ELAC ProteK PR91-W Manual de usuario

Tsubaki

Tsubaki TSM4000M1 Manual de usuario

QVS

QVS PP134C Manual de usuario

CyberPower

CyberPower CSP604T Manual de usuario

Davis Instruments

Davis Instruments Radio Surge Protector Manual de usuario

M-system

M-system MGA-100 Manual de usuario

CyberPower

CyberPower CSP706T Manual de usuario

CyberPower

CyberPower B300WRC1 Manual de usuario

M-system

M-system MGD-24 Manual de usuario

Leviton

Leviton 51120-3R Manual de usuario

Panamax

Panamax MAX 5400-EX Manual de usuario

CyberPower

CyberPower B1006T Manual de usuario

OBO Bettermann

OBO Bettermann ÜSM-20-230I1PE65 Manual de usuario

Minuteman

Minuteman MMS7120RCT Manual de usuario

Leviton

Leviton 52412-DS3 Manual de usuario

Savio

Savio LZ-07 Manual de usuario

Siemens

Siemens HNM3M120 Manual de usuario

Mitsubishi Electric

Mitsubishi Electric LITOL LTM-125RF Manual de usuario