Emerson 781 Manual de usuario
Quick Start Guide
00825 0100-4421, Rev DC
September 2020
Emerson Wireless Field Link
NOTICE
This guide provides basic guidelines for the Emerson Wireless Field Link. It does not provide
instructions for diagnostics, maintenance, service, or troubleshooting. This guide is also available
electronically on www.Emerson.com.
WARNING
Failure to follow these installation guidelines could result in death or serious injury.
Ensure only qualified personnel perform the installation.
Explosions could result in death or serious injury.
Installation of the transmitters in a hazardous environment must be in accordance with the
appropriate local, national, and international standards, codes, and practices. Please review the
Product Certifications section for any restrictions associated with a safe installation.
Electrical shock could cause death or serious injury.
Avoid contact with the leads and terminals. High voltage that may be present on leads can cause
electrical shock.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
operation.
This device must be installed to ensure a minimum antenna separation distance of 8-in. (20 cm) from
all persons.
Contents
Wireless considerations................................................................................................................3
Physical installation...................................................................................................................... 6
Verify operation........................................................................................................................... 8
Reference information................................................................................................................. 9
Ordering information................................................................................................................. 11
Product certifications................................................................................................................. 13
Quick Start Guide September 2020
2 Emerson.com/Rosemount
1 Wireless considerations
1.1 Power up sequence
The Emerson Wireless Field Link and wireless I/O should be installed and
functioning properly before the power modules are installed in any wireless
field devices. Wireless field devices should also be powered up in order of
proximity from the Field Link beginning with the closest. This will result in a
simpler and faster network installation.
1.2 Mounting location
The Field Link should be mounted in a location that allows convenient access
to the host system network (wireless I/O) as well as the wireless field device
network.
Find a location where the Field Link has optimal wireless performance.
Ideally this will be 15 to 25 ft. (4,6 to 7,6 m) above the ground or 6 ft. (2 m)
above obstructions or major infrastructure.
Figure 1-1: Mounting Location
AB
C
D
E
15- to 25-ft.
(4,6 to 7,6 m)
6-ft. (2 m)
AControl room
BGround
CField link
DMast or pipe
EInfrastructure
1.3 Antenna position
The antenna should be positioned vertically, either straight up or straight
down, and should be approximately 3 ft. (1 m) from any large structure,
September 2020 Quick Start Guide
Quick Start Guide 3
building, or conductive surface to allow for clear communication to other
devices.
Figure 1-2: Antenna Position
1.4 Conduit plug
The temporary orange plugs should be replaced with the included conduit
plugs using approved thread sealant.
Figure 1-3: Conduit Plugs
AA
AConduit plug
1.5 Intended use
The Field Link must be used in conjunction with a network manager or
network Gateway. The Field Link then functions as a translator between the
wired network and a wireless field network.
Quick Start Guide September 2020
4 Emerson.com/Rosemount
Figure 1-4: Example System Architecture
A
B
C
D
E
F
AHost system
BControl network
CNetwork manager
DField link
EWireless field network
FWireless field devices
September 2020 Quick Start Guide
Quick Start Guide 5
2 Physical installation
2.1 Pipe mounting
Procedure
1. Insert larger U-bolt around 2-in. pipe/mast, through the saddle,
through the L-shaped bracket, and through the washer plate.
2. Use a 1/2-in. socket-head wrench to fasten the nuts to the U-bolt.
3. Insert smaller U-bolt around base the Field Link and through the L-
shaped bracket.
4. Use a 1/2-in. socket-head wrench to fasten the nuts to the U-bolt.
Figure 2-1: Mounting
2.2 Power and data wiring
Procedure
1. Remove housing cover labeled “Field Terminals.”
2. Connect the positive power lead to the “+” power terminal and the
negative power lead to the “–” terminal.
3. Connect the Data + lead to the “A (+)” terminal and the Data – lead
to the “B (–)” terminal.
4. Plug and seal any unused conduit connections.
5. Replace the housing cover.
Quick Start Guide September 2020
6 Emerson.com/Rosemount
Figure 2-2: Emerson Wireless Field Link Terminal Diagram
A
B
C
D
AData A (+)
BData B (–)
C+10.5 to 30 VDC
DReturn
2.3 Grounding
The Field Link enclosure should always be grounded in accordance with
national and local electrical codes. The most effective grounding method is a
direct connection to earth ground with minimal impedance. Ground the
Field Link by connecting the external ground lug to earth ground. The
connection should be 1 Ω or less.
September 2020 Quick Start Guide
Quick Start Guide 7
3 Verify operation
3.1 Power-up sequence
Upon applying power to the Field link the LCD display meter will activate and
display a series of startup screen. The following screens are displayed during
startup.
1. Startup Screen 1 – All segments on
2. Startup Screen 2 – Device identification
3. Startup Screen 3 – Tag
4. Startup Screen 4 – Status
3.2 Normal operation
After the initial startup screens the Field Link will cycle through several
periodic screens.
1. Electronics Temperature Screen
2. Percent Range Screen
3. Wired Interface Usage
4. Radio Interface Usage
The Field Link will continue to rotate through each periodic screen through
the course of normal operation. If any diagnostic or fault condition occurs, a
corresponding diagnostics screen will appear.
Quick Start Guide September 2020
8 Emerson.com/Rosemount
4 Reference information
Figure 4-1: Emerson Wireless Field Link Terminal Diagram
A
B
C
D
AData A (+)
BData B (–)
C+10.5 to 30 VDC
DReturn
Note
The Emerson Wireless Field Link requires separate twisted shield pairs (four
wires) for power and data.
September 2020 Quick Start Guide
Quick Start Guide 9
Figure 4-2: Emerson Wireless Field Link Dimensional Drawing
A
B
C
D
90°
5.51
(140)
4.20
(107)
3.55
(90.17)
10.91
(277)
12.43
(316)
3.55
(90.17)
5.51
(140)
5.21
(132)
A2x Conduit plug
BPossible antenna rotation shown
CExtended range antenna
DWirelessHART® antenna
Table 4-1: Emerson Wireless Field Link Specifications
Item Specifications
Input power 10.5 – 30 VDC
Operating temperature –40 to 185 °F (–40 to 85 °C)
Wiring (power) 24 AWG - 14 AWG twisted shielded pair(1)
Wiring (RS-485
communications)
24 AWG - 14 AWG twisted shielded pair(1)
Less than 15 pF/ft capacitance.
Wiring distance 656 ft. (200 m)
Wireless protocol WirelessHART, 2.4 – 2.5 GHz DSSS
Wireless output power,
EIRP
10 dBm with WK antenna and 12.5 dBm with WM
antenna
Mounting All SST, 2-in. pipe and panel mount bracket
Humidity 0 – 90% relative humidity
(1) Ambient temperatures above 60 °C require wiring rated to at least 5 °C above
max ambient temperature.
Quick Start Guide September 2020
10 Emerson.com/Rosemount
Otros manuales para 781
1
Tabla de contenidos
Otros manuales de Equipos industriales de Emerson
Emerson
Emerson Fisher 4660 Pressure Pilot Manual de usuario
Emerson
Emerson HART CAM216 Manual
Emerson
Emerson Rosemount IK220 Manual de usuario
Emerson
Emerson ROSEMOUNT HMC-C01 Manual de usuario
Emerson
Emerson Fisher 114PL Manual de usuario
Emerson
Emerson Enardo EN Series Manual de usuario
Emerson
Emerson Fisher ATST Desuperheater Manual de usuario
Emerson
Emerson Copeland OME-16T Manual de instrucciones
Emerson
Emerson PACMOTION VFD Instrucciones de instalación y funcionamiento
Emerson
Emerson PENBERTHY GSA Manual
Emerson
Emerson GPC Series Instrucciones de instalación
Emerson
Emerson Digistart CS Manual de usuario
Emerson
Emerson Anderson Greenwood 727 Series Manual de usuario
Emerson
Emerson Shafer Manual de usuario
Emerson
Emerson Rosemount Manual de usuario
Emerson
Emerson Bettis EHO Manual de usuario
Emerson
Emerson 581 Series Instrucciones de instalación
Emerson
Emerson PENBERTHY Series Manual
Emerson
Emerson TARTARINI PS/79-1 Manual de usuario
Emerson
Emerson Spence B Series Manual de usuario
